Minimal Drilling Technique to Measure Chloride-Penetration Depth and Carbonation Depth in Concrete
Publication: Journal of Materials in Civil Engineering
Volume 32, Issue 9
Abstract
A method was investigated to determine concrete durability by measuring the carbonation depth and chloride ion () penetration depth. Under the proposed method, a 1- or 2-mm-diameter hole was drilled into a concrete surface and the hole’s walls were sprayed with either a phenolphthalein or silver nitrate solution to observe the carbonation depth or penetration depths using an inserted 0.6-mm-diameter fiberscope. This method is intended to be a highly accurate, semidestructive test of concrete durability that causes minimum damage to the inspected concrete structure. It was found through visual observation and image analysis that when coloring the 1-mm drill holes with phenolphthalein, the holes had to be sufficiently dried before observation, whereas when coloring with silver nitrate, no special pretreatment was required. The results of the proposed method were compared with measurements using calipers on cut surfaces, demonstrating that the proposed method yields highly reliable measurements of parameters describing concrete durability.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
This study was financially supported by the Sumitomo Electric Group. The authors would like to thank Dr. K. Nakarai (Hiroshima University) for assistance with the onsite experiments of the middle-scale specimens.
References
AASHTO. 2007. Standard method of test for predicting chloride penetration of hydraulic cement concrete by the rapid migration procedure. Washington, DC: AASHTO.
Abu Zeid, N., M. Balducci, F. Bartocci, R. Regni, and G. Santarato. 2010. “Indirect estimation of injected mortar volume in historical walls using the electrical resistivity tomography.” J. Cult. Heritage 11 (2): 220–227. https://doi.org/10.1016/j.culher.2009.07.001.
Abu-Zeid, N., D. Botteon, G. Cocco, and G. Santarato. 2006. “Non-invasive characterisation of ancient foundations in Venice using the electrical resistivity imaging technique.” NDT E Int. 39 (1): 67–75. https://doi.org/10.1016/j.ndteint.2005.06.007.
Ali-Benyahia, K., Z. M. Sbartaï, D. Breysse, M. Ghrici, and S. Kenai. 2019. “Improvement of nondestructive assessment of on-site concrete strength: Influence of the selection process of cores location on the assessment quality for single and combined NDT techniques.” Constr. Build. Mater. 195 (Jan): 613–622. https://doi.org/10.1016/j.conbuildmat.2018.10.032.
Ali-Benyahia, K., Z. M. Sbartaï, D. Breysse, S. Kenai, and M. Ghrici. 2017. “Analysis of the single and combined non-destructive test approaches for on-site concrete strength assessment: General statements based on a real case-study.” Case Stud. Constr. Mater. 6 (Jul): 109–119. https://doi.org/10.1016/j.cscm.2017.01.004.
Alwash, M., D. Breysse, and Z. M. Sbartaï. 2015. “Non-destructive strength evaluation of concrete: Analysis of some key factors using synthetic simulations.” Constr. Build. Mater. 99 (Nov): 235–245. https://doi.org/10.1016/j.conbuildmat.2015.09.023.
Ann, K. Y., and H. W. Song. 2007. “Chloride threshold level for corrosion of steel in concrete.” Corros. Sci. 49 (11): 4113–4133. https://doi.org/10.1016/j.corsci.2007.05.007.
Aoki, Y., K. Shimano, Y. Miyoshi, and M. Suzuki. 2008. “Estimation of chloride ion penetration to hardened concrete by solution spray method.” [In Japanese.] Proc. Japan Concr. Inst. 30 (1): 759–764.
Aoki, Y., T. Sawamoto, and K. Shimano. 2013. “Report on several empirical studies on chloride ion penetration depth measurements by silver nitrate solution spraying method.” [In Japanese.] Proc. Japan Concr. Inst. 35 (1): 1843–1848.
Avdelidis, N. P., and A. Moropoulou. 2004. “Applications of infrared thermography for the investigation of historic structures.” J. Cult. Heritage 5 (1): 119–127. https://doi.org/10.1016/j.culher.2003.07.002.
Bosiljkov, V., M. Uranjek, R. Žarnić, and V. Bokan-Bosiljkov. 2010. “An integrated diagnostic approach for the assessment of historic masonry structures.” J. Cult. Heritage 11 (3): 239–249. https://doi.org/10.1016/j.culher.2009.11.007.
Chang, C. F., and J. W. Chen. 2006. “The experimental investigation of concrete carbonation depth.” Cem. Concr. Res. 36 (9): 1760–1767. https://doi.org/10.1016/j.cemconres.2004.07.025.
Glass, G. K., and N. R. Buenfeld. 1997. “The presentation of the chloride threshold level for corrosion of steel in concrete.” Corros. Sci. 39 (5): 1001–1013. https://doi.org/10.1016/S0010-938X(97)00009-7.
Harada, K., and Y. Ito. 2007. “Development of endoscope for concrete structure inspection.” [In Japanese.] Technical Rep. of NISHIMATSU CONSTRUCTION Co. 30 (20): 109–110.
Harada, K., Y. Ito, and N. Miyamoto. 2009. “Development of evaluation method of concrete structure by stick scanner.” [In Japanese.] Technical Rep. of NISHIMATSU CONSTRUCTION Co. 32 (17): 97–98.
Harun, S. N. 2011. “Heritage building conservation in Malaysia: Experience and challenges.” Procedia Eng. 20 (1): 41–53. https://doi.org/10.1016/j.proeng.2011.11.137.
He, F., C. Shi, Q. Yuan, X. An, and B. Tong. 2011. “Calculation of chloride concentration at color change boundary of colorimetric measurement.” Cem. Concr. Res. 41 (11): 1095–1103. https://doi.org/10.1016/j.cemconres.2011.06.008.
He, F., C. Shi, Q. Yuan, C. Chen, and K. Zheng. 2012. “-based colorimetric methods for measurement of chloride penetration in concrete.” Constr. Build. Mater. 26 (1): 1–8. https://doi.org/10.1016/j.conbuildmat.2011.06.003.
ISO. 2015. Determination of the carbonation resistance of concrete–Accelerated carbonation method. ISO 1920-12. Geneva: ISO.
Ito, Y., Y. Takahashi, and N. Miyamoto. 2007. “Development of stick scanner for concrete structure inspection.” [In Japanese.] Kensetsunosekoukikaku 10 (692): 19–24.
Izumi, I., F. Oshida, and H. Kasami. 1988. “Study on standardization of carbonation test method.” [In Japanese.] Proc. Japan Concr. Inst. 10 (2): 425–430.
Kasai, Y., and N. Yuasa. 1998. “The carbonation of concrete and the proposal of rapid testing method for its depth.” [In Japanese.] J. Jap. Soc. Non-Destructive Insp. 47 (9): 643–648.
Kim, M. Y., E. I. Yang, and S. Y. Tae. 2007. “Evaluation of chloride penetration characteristics using a colorimetric method in concrete structures in concrete structures.” In Proc., Structural Mechanics in Reactor Technology, 1–6. Toronto: International Association for Structural Mechanics in Reactor Technology.
Kothari, A., B. N. Newman, and D. Kuikarni. 2006. “Breast duct micro-endoscopy: A study of technique and a morphological classification of endo-luminal lesions.” Breast 15 (3): 363–369. https://doi.org/10.1016/j.breast.2005.08.025.
Liu, T., and R. W. Weyers. 1998. “Modeling the dynamic corrosion process in chloride.” Cem. Concr. Res. 28 (3): 365–379. https://doi.org/10.1016/S0008-8846(98)00259-2.
Liu, Y. 1996. “Modeling the time-to corrosion cracking of the cover concrete in chloride contaminated reinforced concrete structures.” Ph.D. dissertation, Dept. of Civil Engineering, Virginia Tech.
Masi, A., D. Nigro, and M. Vona. 2012. “Effect of core drilling and subsequent restoration on RC column strength.” In Proc. of 15th World Conf. on Earthquake. Lisbon, Portugal: Sociedade Portuguesa de Engenharia Sismica.
Nihira, T., M. Sogabe, Y. Tanimura, and K. Higasikawa. 2004. “Feasibility study on the carbonation depth measurement by drill method in concrete structure.” [In Japanese.] Proc. Japan Concrete Institute 26 (1): 2025–2030.
Nordtest. 1999. Chloride Migration coefficient from non-steady-state migration experiments. Taastrup, Denmark: Nordtest.
Osborne, G. J. 1989. “Carbonation and permeability of blastfurnace slag cement concretes from field structures.” Special Publication 114: 1209–1238.
Otieno, M. B., H. D. Beushausen, and M. G. Alexander. 2011. “Modelling corrosion propagation in reinforced concrete structures: A critical review.” Cem. Concr. Compos. 33 (2): 240–245. https://doi.org/10.1016/j.cemconcomp.2010.11.002.
Otsuki, N., S. Nagataki, and K. Nakashita. 1993. “Evaluation of the solution spray method for measurement of chloride penetration into hardened cementitious matrix materials.” Constr. Build. Mater. 7 (4): 195–201. https://doi.org/10.1016/0950-0618(93)90002-T.
Papadakis, V. G. 2000. “Effect of supplementary cementing materials on concrete resistance against carbonation and chloride ingress.” Cem. Concr. Res. 30 (2): 291–299. https://doi.org/10.1016/S0008-8846(99)00249-5.
RILEM CPC18. 1988. “Measurement of hardened concrete carbonation depth.” Mater. Struct. 211 (26): 453–455. https://doi.org/10.1007/BF02472327.
Roy, S. K., K. B. Poh, and D. O. Northwood. 1999. “Durability of concrete–Accelerated carbonation and weathering studies.” Build. Environ. 34 (5): 597–606. https://doi.org/10.1016/S0360-1323(98)00042-0.
Sawamoto, T., T. Fujiwara, N. Yuasa, and Y. Kasai. 2010. “A study on simple method for measurement of chloride penetration depth of concrete by combining drilling powder with silver nitrate solution.” Cem. Sci. Concr. Technol. 64 (1): 196–202. https://doi.org/10.14250/cement.64.196.
Steffens, A., D. Dinkler, and H. Ahrens. 2002. “Modeling carbonation for corrosion risk prediction of concrete structures.” Cem. Concr. Res. 32 (6): 935–941. https://doi.org/10.1016/S0008-8846(02)00728-7.
Tanaka, S., and Y. Sakai. 2019. “Development and verification of neutralization depth and chloride ion penetration depth measurement method using fibrescope.” In Proc., 5th Int. Conf. in Sustainable Construction Materials and Technologies (SCMT5). London: Kingston Univ.
Visser, J. H. M. 2014. “Influence of the carbon dioxide concentration on the resistance to carbonation of concrete.” Constr. Build. Mater. 67 (Part A): 8–13. https://doi.org/10.1016/j.conbuildmat.2013.11.005.
Yamamoto, D., H. Hamada, Y. Sagawa, and T. Hiromitsu. 2013. “Evaluation of compressive strength of concrete using small diameter core.” In Proc., 3rd Int. Conf. in Sustainable Construction Materials and Technologies (SCMT3). Kyoto, Japan: Kyoto Research Park.
Yamamoto, D., H. Hamada, Y. Sagawa, and T. Ikeda. 2009. “Development of diagnostic method for deterioration of sewage pipe by semi-destructive method.” [In Japanese.] Accessed November 14, 2018. http://www.kyugikyo.com/pdf/h21/02.pdf.
Zacoeb, A., Y. Ito, and K. Ishibashi. 2012. “Internal crack assessment on concrete structures by scanning image analysis.” ARPN J. Eng. Appl. Sci. 7 (8): 939–944.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: Oct 30, 2019
Accepted: Feb 6, 2020
Published online: Jun 18, 2020
Published in print: Sep 1, 2020
Discussion open until: Nov 18, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.