Effect of Plant Aggregates on Mechanical Properties of Earth Bricks
Publication: Journal of Materials in Civil Engineering
Volume 29, Issue 12
Abstract
A building material is mainly characterized by its mechanical performance, which provides proof of its quality. However, the measurement of the compressive or flexural strength of an earth-based material with plant aggregates, which is very ductile, is not fully standardized. The objective of this study is to determine the compressive and flexural strengths of a composite made of earth and 0, 3, or 6% of barley straw, hemp shiv, or corn cob. Given the manufacturing processes available, cylindrical compressed specimens were studied in compression, whereas extruded specimens were studied in flexion. Two protocols were tested for compressive strength measurements: one with direct contact between the specimen and the press and the other with reduced friction. The test with reduced friction engendered a huge decrease of the stress and a slight decrease of the strain. For both compressive and flexural strengths, the specimens made of earth alone were the most resistant, followed by composites containing straw. The influence of two different treatments applied to the straw is also discussed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors wish to thank the French National Research Agency—France (ANR) for funding project BIOTERRA—ANR—13—VBDU—0005 Villes et Bâtiments Durables.
References
AFNOR (Association Française de Normalisation). (1992). “Analyse granulométrique des sols—Méthode par sedimentation.” NF P94-057, Paris (in French).
AFNOR (Association Française de Normalisation). (1993). “Détermination des limites d’Atterberg—Limite de liquidité à la coupelle—Limite de plasticité au rouleau.” NF P94-051, Paris (in French).
AFNOR (Association Française de Normalisation). (2001). Blocs de terre comprimée pour murs et cloisons: Definitions—Spécifications—Méthode d’essais—Condition de reception, Paris (in French).
AFNOR (Association Française de Normalisation). (2006). Méthode d’essais des ciments—Détermination des résistances mécaniques, Paris (in French).
Algin, H. M., and Turgut, P. (2008). “Cotton and limestone powder wastes as brick material.” Constr. Build. Mater., 22(6), 1074–1080.
Al Rim, K., Ledhem, A., Douzane, O., Dheilly, R. M., and Queneudec, M. (1999). “Influence of the proportion of wood on the thermal and mechanical performances of clay-cement-wood composites.” Cem. Concr. Compos., 21(4), 269–276.
Alvarez, V. A., and Vázquez, A. (2006). “Influence of fiber chemical modification procedure on the mechanical properties and water absorption of MaterBi-Y/sisal fiber composites.” Compos. Part Appl. Sci. Manuf., 37(10), 1672–1680.
ASTM. (2004). “Standard test method for unconfined compressive strength of cohesive soil.” ASTM D2166, Reston, VA.
Aubert, J.-E., Fabbri, A., Morel, J. C., and Maillard, P. (2013). “An earth block with a compressive strength higher than 45 MPa!” Constr. Build. Mater., 47, 366–369.
Aubert, J.-E., Maillard, P., Morel, J. C., and Al Rafii, M. (2016). “Towards a simple compressive strength test for earth bricks?” Mater. Struct., 49(5), 1641–1654.
Aubert, J.-E., Marcom, A., Oliva, P., and Segui, P. (2015). “Chequered earth construction in south-western France.” J. Cult. Herit., 16(3), 293–298.
Aymerich, F., Fenu, L., Francesconi, L., and Meloni, P. (2016). “Fracture behaviour of a fibre reinforced earthen material under static and impact flexural loading.” Constr. Build. Mater., 109, 109–119.
Aymerich, F., Fenu, L., and Meloni, P. (2012). “Effect of reinforcing wool fibres on fracture and energy absorption properties of an earthen material.” Constr. Build. Mater., 27(1), 66–72.
Bal, H., Jannot, Y., Gaye, S., and Demeurie, F. (2013). “Measurement and modelisation of the thermal conductivity of a wet composite porous medium: Laterite based bricks with millet waste additive.” Constr. Build. Mater., 41, 586–593.
Bouhicha, M., Aouissi, F., and Kenai, S. (2005). “Performance of composite soil reinforced with barley straw.” Cem. Concr. Compos., 27(5), 617–621.
BSI (British Standards Institution). (1981). “Precast concrete masonry units. Specification for precast concrete masonry units.” BS 6073, London.
Cerezo, V. (2005). Propriétés mécaniques, thermiques et acoustiques d’un matériau à base de particules végétales: Approche expérimentale et modélisation théorique, Institut National des Sciences Appliquées, Lyon, France (in French).
Chabannes, M., Bénézet, J.-C., Clerc, L., and Garcia-Diaz, E. (2014). “Use of raw rice husk as natural aggregate in a lightweight insulating concrete: An innovative application.” Constr. Build. Mater., 70, 428–438.
Chan, C.-M. (2011). “Effect of natural fibres inclusion in clay bricks: Physico-mechanical properties.” Int. J. Civil Environ. Eng., 3(1), 51–57.
Danso, H., Martinson, B., Ali, M., and Mant, C. (2015a). “Performance characteristics of enhanced soil blocks: A quantitative review.” Build. Res. Inf., 43(2), 253–262.
Danso, H., Martinson, D. B., Ali, M., and Williams, J. (2015b). “Effect of fibre aspect ratio on mechanical properties of soil building blocks.” Constr. Build. Mater., 83, 314–319.
De Chazelles, C.-A., Klein, A., and Pousthomis, N. (2011). Les cultures constructives de la brique de terre crue—Echanges transdiciplinaires sur les constructions en terre crue, 3rd Ed., ENSAM, Espérou, France (in French).
Demir, I. (2006). “An investigation on the production of construction brick with processed waste tea.” Build. Environ., 41(9), 1274–1278.
Demir, I. (2008). “Effect of organic residues addition on the technological properties of clay bricks.” Waste Manage., 28(3), 622–627.
Galán-Marín, C., Rivera-Gómez, C., and Petric, J. (2010). “Clay-based composite stabilized with natural polymer and fibre.” Constr. Build. Mater., 24(8), 1462–1468.
Ghavami, K., Toledo Filho, R. D., and Barbosa, N. P. (1999). “Behaviour of composite soil reinforced with natural fibres.” Cem. Concr. Compos., 21(1), 39–48.
Guinea, G. V., Planas, J., and Elices, M. (1992). “Measurement of the fracture energy using three-point bend tests. 1: Influence of experimental procedures.” Mater. Struct., 25(4), 212–218.
Hill, C. A. S., Khalil, H. P. S. A., and Hale, M. D. (1998). “A study of the potential of acetylation to improve the properties of plant fibres.” Ind. Crops Prod., 8(1), 53–63.
Islam, M., and Iwashita, K. (2006). “Seismic response of fiber-reinforced and stabilized adobe structures.” Proc., Getty Seismic Adobe Project 2006 Colloquium, Getty Conservation Institute, Los Angeles.
Khedari, J., Watsanasathaporn, P., and Hirunlabh, J. (2005). “Development of fibre-based soil–cement block with low thermal conductivity.” Cem. Concr. Compos., 27(1), 111–116.
Kornmann, M., and Lafaurie, P. (2005). “Matériaux de construction en terre cuite.” Fabrication et proprieties, Septima, Paris (in French).
Laborel-Préneron, A., Aubert, J. E., Magniont, C., Tribout, C., and Bertron, A. (2016). “Plant aggregates and fibers in earth construction materials: A review.” Constr. Build. Mater., 111, 719–734.
Laborel-Préneron, A., Magniont, C., and Aubert, J.-E. (2017). “Characterization of barley straw, hemp shiv and corn cob as resources for bioaggregate based building materials.” Waste Biomass Valorization, 1–18.
Ledhem, A., Dheilly, R. M., Benmalek, M. L., and Quéneudec, M. (2000). “Properties of woodbased composites formulated with aggregate industry waste.” Constr. Build. Mater., 14, 341–350.
Lenci, S., Clementi, F., and Sadowski, T. (2012). “Experimental determination of the fracture properties of unfired dry earth.” Eng. Fract. Mech., 87, 62–72.
Magniont, C. (2010). “Contribution à la formulation et à la caractérisation d’un écomatériau de construction à base d’agroressources.” Ph.D. thesis, Université Toulouse III, Paul Sabatier, Toulouse, France (in French).
Martins, A. P. S., Silva, F. A., and Toledo Filho, R. D. (2014). “Mechanical behavior of self-compacting soil-cement-sisal fiber composites.” Key Eng. Mater., 634, 421–432.
Mattone, R. (2005). “Sisal fibre reinforced soil with cement or cactus pulp in bahareque technique.” Cem. Concr. Compos., 27(5), 611–616.
Millogo, Y., Aubert, J.-E., Hamard, E., and Morel, J.-C. (2015). “How properties of kenaf fibers from Burkina Faso contribute to the reinforcement of earth blocks.” Materials, 8(5), 2332–2345.
Millogo, Y., Aubert, J.-E., Séré, A. D., Fabbri, A., and Morel, J.-C. (2016). “Earth blocks stabilized by cow-dung.” Mater. Struct., 49(11), 4583–4594.
Millogo, Y., Morel, J.-C., Aubert, J.-E., and Ghavami, K. (2014). “Experimental analysis of pressed adobe blocks reinforced with Hibiscus cannabinus fibers.” Constr. Build. Mater., 52, 71–78.
Minke, G. (2006). Building with earth: Design and technology of a sustainable architecture, Birkhäuser, Basel, Switzerland.
Mohamed, A. E. M. K. (2013). “Improvement of swelling clay properties using hay fibers.” Constr. Build. Mater., 38, 242–247.
Morel, J.-C., Pkla, A., and Walker, P. (2007). “Compressive strength testing of compressed earth blocks.” Constr. Build. Mater., 21(2), 303–309.
Mostafa, M., and Uddin, N. (2015). “Effect of banana fibers on the compressive and flexural strength of compressed earth blocks.” Buildings, 5(1), 282–296.
MSJC (Masonry Standards Joint Committee). (2008). “Building code requirements and specification for masonry structures.” TMS 402/602, Longmont, CO.
NZS (Standards New Zealand). (1998). “Materials and workmanship for earth buildings.” NZS 4298, Wellington, New Zealand.
Olivier, M., Mesbah, A., El Gharbi, Z., and Morel, J. C. (1997). “Mode opératoire pour la réalisation d’essais de résistance sur blocs de terre comprimée: Test method for strength tests on blocks of compressed earth.” Mater. Struct., 30(9), 515–517 (in French).
Palankar, N., Ravi Shankar, A. U., and Mithun, B. M. (2015). “Studies on eco-friendly concrete incorporating industrial waste as aggregates.” Int. J. Sustain. Built Environ., 4(2), 378–390.
Piattoni, Q., Quagliarini, E., and Lenci, S. (2011). “Experimental analysis and modelling of the mechanical behaviour of earthen bricks.” Constr. Build. Mater., 25(4), 2067–2075.
Quagliarini, E., and Lenci, S. (2010). “The influence of natural stabilizers and natural fibres on the mechanical properties of ancient Roman adobe bricks.” J. Cult. Herit., 11(3), 309–314.
Segetin, M., Jayaraman, K., and Xu, X. (2007). “Harakeke reinforcement of soil–cement building materials: Manufacturability and properties.” Build. Environ., 42(8), 3066–3079.
TSI (Turkish Standards Institution). (2002). “Methods of test for mortar for masonry units. 1: Determination of compressive strength.” TS EN 772–1, Ankara, Turkey.
Villamizar, M. C. N., Araque, V. S., Reyes, C. A. R., and Silva, R. S. (2012). “Effect of the addition of coal-ash and cassava peels on the engineering properties of compressed earth blocks.” Constr. Build. Mater., 36, 276–286.
Yetgin, Ş., Çavdar, Ö., and Çavdar, A. (2008). “The effects of the fiber contents on the mechanic properties of the adobes.” Constr. Build. Mater., 22(3), 222–227.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Feb 8, 2017
Accepted: Jun 1, 2017
Published online: Oct 11, 2017
Published in print: Dec 1, 2017
Discussion open until: Mar 11, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.