Utilizing Fluorescence Microscopy for Quantifying Mobilization Rate of Aged Asphalt Binder
Publication: Journal of Materials in Civil Engineering
Volume 29, Issue 12
Abstract
The asphalt paving industry has been increasing the use of recycled asphalt pavement (RAP). There is a concern about the percentage of aged asphalt binder in the RAP that can actually be blended into the virgin binder and thus become available to coat the aggregate. In this study, a laboratory procedure was proposed for quantifying the mobilization rate of the aged binder using fluorescence microscopy. A new parameter, the mean gray value (MGV), was derived from the fluorescence image and used to differentiate between the recycled and virgin binders as well as their blends. A blending chart was generated according to the MGV for the virgin-aged asphalt blends containing 0–100% RAP binder and was used as a baseline for the quantification. A linear relationship was found between the MGV and the RAP binder content. A laboratory experiment was conducted to validate the proposed method. Glass cullet was added as a special type of aggregate so that it could be retrieved after mixing and tested by fluorescence microscopy. The results showed that the mobilization rate of the RAP binder from the fluorescent method was improved with an extended mixing time and an elevated temperature.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the financial support from the National Science Foundation of China (NSFC) under the Grant No. 51578415 and from the Federal Highway Administration and Tennessee Department of Transportation. The results in this paper represent the views from the authors and may not necessarily reflect the views from any of the sponsors.
References
ASTM. (2010a). “Standard practice for accelerated aging of asphalt binder using a pressurized aging vessel (PAV).” ASTM D6521-13, West Conshohocken, PA.
ASTM. (2010b). “Standard test method for effect of heat and air on a moving film of asphalt (rolling thin-film oven test).” ASTM D2872-12, West Conshohocken, PA.
ASTM. (2010c). “Standard test method for quantitative extraction and recovery of asphalt binder from asphalt mixtures.” ASTM D6847-02, West Conshohocken, PA.
ASTM. (2014). “Guide for using fluorescence microscopy to quantify the spread area of fixed cells.” ASTM F2998-14, West Conshohocken, PA.
Bennert, T., and Dongré, R. (2010). “Backcalculation method to determine effective asphalt binder properties of recycled asphalt pavement mixtures.” Transp. Res. Rec., 2179, 75–84.
Bonaquist, R. (2005). “Laboratory evaluation of hot mix asphalt (HMA) mixtures containing recycled or waste product materials using performance testing.”, Pennsylvania Dept. of Transportation, Harrisburg, PA.
Booshehrian, A., Mogawer, W. S., and Bonaquist, R. (2013). “How to construct an asphalt binder master curve and assess the degree of blending between RAP and virgin binders.” J. Mater. Civ. Eng., 1813–1821.
Bowers, B. F., Huang, B., Shu, X., and Miller, B. C. (2014). “Investigation of reclaimed asphalt pavement blending efficiency through GPC and FTIR.” Constr. Build. Mater., 50, 517–523.
Brûlé, B., Brion, Y., and Tanguy, A. (1988). “Paving asphalt polymer blends: Relationships between composition, structure and properties (with discussion).” Proc., Association of Asphalt Paving Technologists, Association of Asphalt Paving Technologists, Lino Lakes, MN.
Buisine, J., et al. (1993). “Thermodynamic behavior and physicochemical analysis of eight SHRP bitumens.” Transp. Res. Rec., 1386, 1–9.
Carpenter, S. H., and Wolosick, J. R. (1980). “Modifier influence in the characterization of hot-mix recycled material.” Transp. Res. Rec., 777, 15–22.
Copeland, A. (2011). “Reclaimed asphalt pavement in asphalt mixtures: State of the practice.”, Federal Highway Administration, Richmond, VA.
Daly, W. H., Qui Chiu, Z., and Negulescu, I. (1993). “Preparation and characterization of asphalt-modified polyethylene blends.” Transp. Res. Rec., 1391, 56.
D’Angelo, J., and Dongré, R. (2009). “Practical use of multiple stress creep and recovery test: Characterization of styrene-butadiene-styrene dispersion and other additives in polymer-modified asphalt binders.” Transp. Res. Rec., 2126, 73–82.
Dennis, A. M., Rhee, W. J., Sotto, D., Dublin, S. N., and Bao, G. (2012). “Quantum dot-fluorescent protein FRET probes for sensing intracellular pH.” ACS Nano, 6(4), 2917–2924.
Ding, Y., Huang, B., Shu, X., Zhang, Y., and Woods, M. E. (2016). “Use of molecular dynamics to investigate diffusion between virgin and aged asphalt binders.” Fuel, 174(12), 267–273.
Druta, C., Wang, L., and Zhu, T. (2009). “Laboratory investigation of reclaimed asphalt pavement mixed with pure binder using X-ray CT scanner.” ICCTP 2009: Critical Issues in Transportation Systems Planning, Development, and Management, North American Chinese Overseas Transportation Association, Harbin, China, 1–10.
Eriksen, K., and Wegan, V. (1993). Optical methods for the evaluation of asphalt concrete and polymer-modified bituminous binders, Roskilde Danish Road Institute, Roskilde, Denmark.
Grossegger, D., Grothe, H., Hofko, B., and Hospodka, M. (2017). “Fluorescence spectroscopic investigation of bitumen aged by field exposure respectively modified rolling thin film oven test.” Road Mater. Pavement Des., 1–9.
Hajj, E., Loria, L., and Sebaaly, P. (2012). “Estimating effective performance grade of asphalt binders in high RAP mixtures using different methodologies: Case study.” Transp. Res. Rec., 2294, 53–63.
Handle, F., et al. (2016). “The bitumen microstructure: A fluorescent approach.” Mater. Struct., 49(1–2), 167–180.
Huang, B., Li, G., Vukosavljevic, D., Shu, X., and Egan, B. (2005). “Laboratory investigation of mixing hot-mix asphalt with reclaimed asphalt pavement.” Transp. Res. Rec., 1929, 37–45.
Khorasani, G. K. (1987). “Novel development in fluorescence microscopy of complex organic mixtures: Application in petroleum geochemistry.” Org. Geochem., 11(3), 157–168.
Kriz, P., et al. (2014). “Blending and diffusion of reclaimed asphalt pavement and virgin asphalt binders.” Road Mater. Pavement Des., 15(S1), 78–112.
Lu, X., and Isacsson, U. (1999). “Chemical and rheological characteristics of styrene-butadiene-styrene polymer-modified bitumens.” Transp. Res. Rec., 1661, 83–92.
Mills, J., and White, R. (2012). Organic chemistry of museum objects, Routledge, Abingdon, U.K.
Mogawer, W. S., Booshehrian, A., Vahidi, S., and Austerman, A. J. (2013). “Evaluating the effect of rejuvenators on the degree of blending and performance of high RAP, RAS, and RAP/RAS mixtures.” Road Mater. Pavement Des., 14(S2), 193–213.
Mortazavi, M., and Moulthrop, J. S. (1993). “The SHRP materials reference library.” National Research Council, Washington, DC.
Nahar, S., Mohajeri, M., Schmets, A., Scarpas, A., Van De Ven, M., and Schitter, G. (2013). “First observation of blending-zone morphology at interface of reclaimed asphalt binder and virgin bitumen.” Transp. Res. Rec., 2370, 1–9.
Navaro, J., Bruneau, D., Drouadaine, I., Colin, J., Dony, A., and Cournet, J. (2012). “Observation and evaluation of the degree of blending of reclaimed asphalt concretes using microscopy image analysis.” Constr. Build. Mater., 37(12), 135–143.
Petryayeva, E., Algar, W. R., and Medintz, I. L. (2013). “Quantum dots in bioanalysis: A review of applications across various platforms for fluorescence spectroscopy and imaging.” Appl. Spectrosc., 67(3), 215–252.
Rad, F., Sefidmazgi, N., and Bahia, H. (2014). “Application of diffusion mechanism: Degree of blending between fresh and recycled asphalt pavement binder in dynamic shear rheometer.” Transp. Res. Rec., 2444, 71–77.
Rinaldini, E., Schuetz, P., Partl, M., Tebaldi, G., and Poulikakos, L. (2014). “Investigating the blending of reclaimed asphalt with virgin materials using rheology, electron microscopy and computer tomography.” Compos. Part B, 67(12), 579–587.
Shirodkar, P., et al. (2011). “A study to determine the degree of partial blending of reclaimed asphalt pavement (RAP) binder for high RAP hot mix asphalt.” Constr. Build. Mater., 25(1), 150–155.
Stasiuk, L., and Snowdon, L. (1997). “Fluorescence micro-spectrometry of synthetic and natural hydrocarbon fluid inclusions: Crude oil chemistry, density and application to petroleum migration.” Appl. Geochem., 12(3), 229–241.
Swiertz, D., Mahmoud, E., and Bahia, H. (2011). “Estimating the effect of recycled asphalt pavements and asphalt shingles on fresh binder, low-temperature properties without extraction and recovery.” Transp. Res. Rec., 2208, 48–55.
Swiertz, D. R., and Bahia, H. U. (2011). “Test method to quantify the effect of RAP and RAS on blended binder properties without binder extraction.” Proc., 56th Annual Conf. of the Canadian Technical Asphalt Association, Canadian Technical Asphalt Association, Victoria, BC, Canada.
Zearley, L. J. (1979). “Penetration characteristics of asphalt in a recycled mixture.” Transp. Res. Rec., 79, 1–13.
Zhang, X., et al. (2013). “Relationship between heterogeneity of source rocks and genetic mechanism of abnormally high pressure.” Sci. China Earth Sci., 56(11), 1971–1976.
Zhao, S. (2014). “Blending issues of hot and warm mix asphalt containing recycled asphalt pavement and recycled asphalt shingle.” Ph.D. dissertation, Univ. of Tennessee, Knoxville, TN.
Zhao, S., Huang, B., Shu, X., and Woods, M. E. (2015a). “Quantitative characterization of binder blending: How much recycled binder is mobilized during mixing?” Transp. Res. Rec., 2506, 72–80.
Zhao, S., Nahar, S. N., Huang, B., Schmets, A., and Scarpas, A. (2014). “Characterizing blending efficiency of recycled asphalt shingle (RAS) and virgin binder.” Proc., 51st Petersen Asphalt Research Conf., Western Research Institute, Laramie, WY.
Zhao, S., Nahar, S. N., Schmets, A. J., Huang, B., Shu, X., and Scarpas, T. (2015d). “Investigation on the microstructure of recycled asphalt shingle binder and its blending with virgin bitumen.” Road Mater. Pavement Des., 16(S1), 21–38.
Zofka, A., Marasteanu, M. O., Clyne, T. R., Li, X., and Hoffmann, O. (2004). “Development of simple asphalt test for determination of RAP blending charts.” Univ. of Minnesota Digital Conservancy, Minneapolis.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jan 26, 2017
Accepted: May 31, 2017
Published online: Oct 9, 2017
Published in print: Dec 1, 2017
Discussion open until: Mar 9, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.