Sasobit-Modified Asphalt Binder Rheology
Publication: Journal of Materials in Civil Engineering
Volume 29, Issue 9
Abstract
This research discusses the effect of Sasobit on asphalt binder rheology and how different percentages of Sasobit affect its performance. Evaluation is performed according to the Superpave test specifications. Tests include the rotational viscosity (RV), the dynamic shear rheometer (DSR), and the bending beam rheometer (BBR). Several rheological parameters are investigated: the dynamic viscosity (), the complex modulus (), the phase angle (), the creep stiffness (), and the m-value. The behavior of modified asphalt binder is investigated at a wide range of temperatures (–160°C). Results show an improvement of the asphalt binder performance at high temperatures, but adverse effects on asphalt binder performance at the low temperatures are observed. The optimum percentage of Sasobit is found to be 2% by mass of the asphalt binder; higher percentages are not recommended.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank Sasol Wax (Sasolburg, South Africa) for providing the Sasobit material for testing.
References
AASHTO. (2009). “Effect of heat and air on a moving film of asphalt (rolling thin-film oven test).” AASHTO T240, Washington, DC.
AASHTO. (2011). “Viscosity determination of asphalt binder using rotational viscometer.” AASHTO T316, Washington, DC.
AASHTO. (2012a). “Accelerated aging of asphalt binder using a pressurized aging vessel (PAV).” AASHTO R28, Washington, DC.
AASHTO. (2012b). “Determining the flexural creep stiffness of asphalt binder using the bending beam rheometer (BBR).” AASHTO T313, Washington, DC.
AASHTO. (2012c). “Standard method of test for determining the rheological properties of asphalt binder using a dynamic shear rheometer (DSR).” AASHTO T315, Washington, DC.
Airey, G. (2004). “Fundamental binder and practical mixture evaluation of polymer modified bituminous materials.” Int. J. Pavement Eng., 5(3), 137–151.
Al Assi, M. O. (2015). “The rheological properties of Sasobit-modified asphalt binder.” M.Sc. thesis, Jordan Univ. of Science and Technology, Irbid, Jordan.
Al-Khateeb, G., and Al-Akhras, N. (2011). “Properties of portland cement–modified asphalt binder using superpave tests.” Constr. Build. Mater., 25(2), 926–932.
Burger, A. F., Muller, J., and Jenkins, K. J. (2001). “Rheology of polymer modified bitumen: A comparative study of three binders and three binder/filler systems.” 20th South Africa Transport Conf., Pretoria, South Africa.
Canestrari, F., Graziani, A., Pannunzio, V., and Bahia, H. (2013). “Rheological properties of bituminous binders with synthetic wax.” Int. J. Pavement Res. Technol., 6(1), 15–21.
Edwards, Y., and Redelius, P. (2003). “Rheological effects of waxes in bitumen.” Energy Fuels, 17(3), 511–520.
Ghuzlan, K., Al-Khateeb, G., and Damrah, A. (2013). “Using oil shale ash waste as a modifier for asphalt binders.” J. Mater. Cycles Waste Manage., 15(4), 522–529.
Hanz, A., Mahmoud, E., and Bahia, H. U. (2011). “Impacts of WMA production temperatures on binder aging and mixture flow number.” J. Assoc. Asphalt Paving Technol., 80, 459–490.
Jamshidi, A., Hamzah, M., and You, Z. (2013). “Performance of warm mix asphalt containing Sasobit: State-of-the-art.” Constr. Build. Mater., 38, 530–553.
Kim, H., Lee, S., and Amirkhanian, S. (2011a). “Impact of warm mix additives on rheological properties of polymer modified asphalt binders.” Can. J. Civil Eng., 38(12), 1414–1426.
Kim, H., Lee, S., and Amirkhanian, S. (2011b). “Rheology of warm mix asphalt binders with aged binders.” Constr. Build. Mater., 25(1), 183–189.
Kim, Y. (2009). Modeling of asphalt concrete, ASCE, Reston, VA.
Liu, J., and Li, P. (2012). “Low temperature performance of Sasobit-modified warm-mix asphalt.” J. Mater. Civ. Eng., 57–63.
Qin, Q., Farrar, M., Pauli, A., and Adams, J. (2014). “Morphology, thermal analysis and rheology of Sasobit modified warm mix asphalt binders.” Fuel, 115, 416–425.
Zhang, J., Yang, F., Pei, J., Xu, S., and An, F. (2015). “Viscosity-temperature characteristics of warm mix asphalt binder with Sasobit.” Constr. Build. Mater., 78, 34–39.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Sep 3, 2016
Accepted: Mar 1, 2017
Published online: May 27, 2017
Published in print: Sep 1, 2017
Discussion open until: Oct 27, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.