Acid, Alkali, and Chloride Resistance of Concrete Composed of Low-Carbonated Fly Ash
Publication: Journal of Materials in Civil Engineering
Volume 29, Issue 3
Abstract
This research investigates the effect of carbonated fly ash inclusion in concrete as partial replacement of cement on the durability performance when exposed to salt, sulfate, and acid solution. The effect of chemical exposure periods (30, 60, 90, and 120 days) on compressive strength and weight of concrete with low volume (25%) replacement of cement was investigated for various water curing ages (28, 56, 90, and 180 days). A comparative assessment with low volume (25% cement replacement) fly ash concrete and control concrete was also conducted. It was observed from the results that low volume carbonated fly ash concrete demonstrated a significant increase in resistance to loss in compressive strength and weight against salt, sulfate, and acid attack. Gray relation-based analysis was performed to determine suitable parameters for simultaneous minimization of strength loss and weight loss under chemical exposure. It can be recommended that, due to its cost-effectiveness, easy processing, and environmental friendly nature, carbonated fly ash can be adopted in construction as a partial replacement of cement in concrete.
Get full access to this article
View all available purchase options and get full access to this article.
References
Amin, N. (2011). “Use of bagasse ash in concrete and its impact on the strength and chloride resistivity.” J. Mater. Civ. Eng., 717–720.
Bertos, M. F., Simons, S. J., Hills, C. D., and Carey, P. J. (2004). “A review of accelerated carbonation technology in the treatment of cement-based materials and sequestration of .” J. Hazard. Mater., 112(3), 193–205.
Biernacki, J. J., Williams, P. J., and Stutzman, P. E. (2001).“Kinetics of reaction of calcium hydroxide and fly ash.” ACI Mat. J., 98(4), 340–349.
Binici, H., Cagatay, I. H., and Shah, T. (2008). “Mineralogy of plain portland and blended cement pastes.” Build. Environ., 43(7), 1318–1325.
BIS (Bureau of Indian Standards). (1959a). “Indian standard code of practice—Methods of test for strength of concrete.” IS: 516-59, New Delhi, India.
BIS (Bureau of Indian Standards). (1959b). “Indian standard methods of sampling and analysis of concrete.” IS: 1199-59, New Delhi, India.
BIS (Bureau of Indian Standards). (1970). “Specifications for coarse and fine aggregates from natural sources for concrete.” IS: 383-70, New Delhi, India.
BIS (Bureau of Indian Standards). (2009). “Recommended guidelines for concrete mix design.” IS: 10262-2009, New Delhi, India.
BIS (Bureau of Indian Standards). (2013). “Specifications for 43 grade ordinary portland cement.” IS: 8112-1989, New Delhi, India.
Bobicki, E. R., Liu, Q., Xu, Z., and Zeng, H. (2012). “Carbon capture and storage using alkaline industrial waste.” Prog. Energy Combust. Sci., 38(2), 302–320.
Bochenczyk, A. U., Mokrzycki, E., Piotrowski, Z., and Pomykala, R. (2009). “Estimation of sequestration potential via mineral carbonation in fly ash from lignite combustion in Poland.” Energy Proc., 1(1), 4873–4879.
Criado, M., Jiménez, A. F., and Palomo, A. (2010). “Effect of sodium sulfate on the alkali activation of fly ash.” Cem. Concr. Compos., 32(8), 589–594.
Datta, R., Joshi, D., li, J., and Wang, J. Z. (2008). “Image retrieval: Ideas, influences, and trends of the new age.” ACM Comp. Surv., 40(2), 5:1–5:60.
Dlugokencky, E. (2016). “Annual mean carbon dioxide data.” Earth System Research Laboratory, National Oceanic and Atmospheric Administration, Boulder, CO.
Fan, Y., Yin, S., Wen, Z., Zhong, J. (1999). “Activation of fly ash and its effects on cement properties.” Cem. Concr. Res., 29(4), 467–472.
Fauth, D. J., Soong, Y., and White, C. M. (2002). “Carbon sequestration utilizing industrial solid residues.” Prepr. Symp. Am. Chem. Soc., Div. Fuel Chem., 47(1), 37–38.
Gray, M. L., et al. (2004). “ capture by amine-enriched fly ash carbon sorbents.” Sep. Purification Technol., 35(1), 31–36.
He, L., Yu, D., Ly, W., Wu, J., and Xu, M. (2013). “A novel method for sequestration via indirect carbonation of coal fly ash.” Ind. Eng. Chem. Res., 52(43), 15138–15145.
Huang, C. H., Lin, S. K., Chang, C. S., and Chen, H. J. (2013). “Mix proportions and mechanical properties of concrete containing very high-volume of class F fly ash.” Constr. Build. Mater., 46, 4671–4678.
Jo, H. Y., Ahn, J., and Jo, H. (2012). “Evaluation of the sequestration capacity for coal fly ash using a flow-through column reactor under ambient conditions.” J. Hazard. Mater., 241–242, 127–136.
Lee, C. Y., Lee, H. K., and Lee, K. M. (2003). “Strength and microstructural characteristics of chemically activated fly ash–cement systems.” Cem. Concr. Res., 33(3), 425–431.
Lin, C. L. (2004). “Use of the Taguchi method and grey relational analysis to optimize turning operations with multiple performance characteristics.” Mater. Manuf. Processes, 19(2), 209–220.
Mayoral, M. C., Andrés, J. M., and Gimeno, M. P. (2013). “Optimization of mineral carbonation process for sequestration by lime-rich coal ashes.” Fuel, 106(4), 448–454.
Mehta, P. K. (1986). Concrete structure, properties of materials, Prentice Hall, St. Louis.
Mehta, P. K. and Monteiro, P. J. M. (1996). Concrete microstructure, properties and materials, McGraw-Hill, New York.
Mira, P., Papadakis, V. G., and Tsimas, S. (2002). “Effect of lime putty addition on structural and durability properties of concrete.” Cem. Concr. Res., 32(5), 683–689.
Muduli, S. D., Nayak, B. D., and Dhal, N. K. (2012). “ sequestration through mineral carbonation of fly ash and its use in agriculture.” ISPRS Archives XXXVIII-8/W3 Workshop Proc.: Impact of Climate Change on Agriculture, 200–202.
Muduli, S. D., Nayak, B. D., Dhal, N. K., and Mishra, B. K. (2014). “Atmospheric sequestration through mineral carbonation of fly ash.” Greener. J. Phys. Sci., 4(1), 1–6.
Mun, M., and Cho, H. (2013). “Mineral carbonation for carbon sequestration with industrial waste.” Energy Proc., 37, 6999–7005.
Naik, T. R., Singh, S. S., and Hossain, M. M. (1995). “Properties of high performance concrete systems incorporating large amounts of high-lime fly ash.” Constr. Build. Mater., 9(4), 195–204.
Neville, A. (2004). “The confused world of sulfate attack on concrete.” Cem. Concr. Res., 34(8), 1275–1296.
Neville, A. M. (1996). Properties of concrete: Durability of concrete, Wiley, New York.
Owens, K. J., Basheer, P. A. M., and Sen Gupta, B. (2007). “Utilization of carbon dioxide from flue gases to improve physical and microstructural properties of cement and concrete systems.” Proc., Int. Conf.: Sustainable Construction Materials and Technologies, UW Milwaukee CBU, Milwaukee, 59–68.
Pinter, J. P., Kimball, B. A., Garcia, R. L., Wall, G. W., Hunsaker, D. J., and LaMorte, R. L. (1996). “Free-air CO2 enrichment: Responses of cotton and wheat crops.” Carbon dioxide and terrestrial ecosystems, G. W. Koch and H. A. Mooney, eds., Academic Press, San Diego, 215–250.
Poon, C. S., Lam, L., and Wong, Y. L. (2000). “A study on high strength concrete prepared with large volumes of low calcium fly ash.” Cem. Concr. Res., 30(3), 447–455.
Ridzuan, A. R. M., Khairulniza, A. A., Fadzil, M. A., Nurliza, J., Fauzi, M. A. M., and Yusoff, W. M. F. W. (2014). “Alkaline activators concentration effect to strength of waste paper sludge ash-based geopolymer mortar.” Proc., Int. Civil and Infrastructure Engineering Conf., Institute of Infrastructure Engineering and Sustainability Management (IIESM), Universiti Teknologi MARA, Selangor Darul Ehsan, Malaysia, 169–175.
Ross, P. J. (1998). Taguchi techniques for quality engineering, McGraw-Hill, New York.
Ryu, G. S., Lee, Y. B., Koh, K. T., and Chung, Y. S. (2013). “The mechanical properties of fly ash-based geopolymer concrete with alkaline activators.” Constr. Build. Mater., 47, 409–418.
Senapati, M. R. (2011). “Fly ash from thermal power plants—Waste management and overview.” Current Sci., 100(12), 1791–1794.
Skalny, J., Marchand, J., and Odler, I. (2002). Sulfate attack on concrete, Spon Press, London.
Smithson, P. C., and College, B. (2008). “Calcium carbonate content of limestone.” Laboratory Clean-Up and Chemical Disposal, 1–6.
Tsao, C. C. (2009). “Grey-Taguchi method to optimize the milling parameters of aluminum alloy.” Int. J. Adv. Manuf. Technol., 40(1–2), 41–48.
Vaughan, A. (2015). “Global carbon dioxide levels break 400ppm milestone.” The Guardian, London.
Vimal, K., Gulab, S., and Rajendra, R. (2005). “Fly ash: A material for another green revolution.” Fly Ash Utilization Programme (FAUP), TIFAC, DST, New Delhi, India, 2.1–2.16.
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Oct 26, 2015
Accepted: Jul 26, 2016
Published online: Oct 25, 2016
Published in print: Mar 1, 2017
Discussion open until: Mar 25, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.