Inexpensive Strengthening Technique for Partially Loaded Reinforced Concrete Beams: Experimental Study
Publication: Journal of Materials in Civil Engineering
Volume 27, Issue 10
Abstract
This paper constitutes a special importance for developing countries where an affordable trowel-based strengthening system is needed. This paper also provides an affordable strengthening solution when it is not possible to entirely remove the effect of live load on the strengthened element. A series of 13 ferrocement strengthened beams of 2,400 mm in length and a rectangular cross section of were tested. The beams were cast and preloaded to different load fractions (45 and 60%) of its ultimate capacity; then the load was partially released (by 15% of the ultimate load) and maintained, while the beams were then strengthened and reloaded until failure. The load released simulates the removed live load while strengthening an actual beam. The research reported in this paper features designing and manufacturing a special loading frame to apply, release, and reapply the loads on the tested beams. The frame allows implementing the strengthening process while maintaining the strengthened beams partially loaded. The use of flat and U-shaped ferrocement layers of three different volume fractions (VFs) of mesh reinforcement have been assessed. The overall response of the specimens was investigated in terms of the load carrying capacity, crack patterns, and propagation and modes of failure, and the deformational characteristics that include deflection, ductility, and energy absorption characteristics. The results indicated that the ferrocement strengthening system is effective in enhancing both strength and ductility of the RC beams.
Get full access to this article
View all available purchase options and get full access to this article.
References
ACI. (1988). “Guide for the design, construction, and repair of ferrocement.” ACI Struct. J., 85(3), 325–351.
Ahmad, S. F. (2010). “Precast ferrocement barrel shell planks as low cost roof.” Challenges, opportunities and solutions in structural engineering and construction, CRC Press, Boca Raton, FL, 645–649.
Ahmed, T., Ali, S., and Choudhury, J. (1990). “Investigation into the repair of short square columns using ferrocement.” Proc., Int. Symp. on Ferrocement, Taylor and Francis, New York, 277–285.
Alnuaimi, A. S., Hago, A., and Al-Jabri, K. S. (2006). “Flexural behaviour of ferrocement roof panels.” Wit. Trans. Built Env., 85, 93–102.
Alnuaimi, A. S., Hago, A. W., Al-Jabri, K. S., and Al-Saidy, A. H. (2009). “Investigation on the flexural behaviour of ferrocement pipes and roof panels subjected to bending moment.” Struct. Eng. Mech., 33(4), 503–527.
Arif, M., and Kaushik, S. K. (1999). “Mechanical behaviour of ferrocement composites: An experimental investigation.” Cement Concrete Compos., 21(4), 301–312.
Cheah, C. B., and Ramli, M. (2012). “Load capacity and crack development characteristics of HCWA–DSF high strength mortar ferrocement panels in flexure.” Constr. Build. Mater., 36, 348–357.
Clarke, R. P. (2010). “Study of full-scale elements of a ferrocement roof system for Caribbean application.” Constr. Build. Mater., 24(3), 221–229.
Ebead, U. A. (2002). Strengthening of reinforced concrete two-way slabs, Ph.D. thesis, Memorial Univ. of Newfoundland, St. John’s, NL, Canada.
Ebead, U. A. (2011). “Hybrid externally bonded/mechanically fastened fiber-reinforced polymer for RC beam strengthening.” ACI Struct. J., 108(6), 669–678.
Ebead, U. A., and Marzouk, H. (2002a). “Strengthening of two-way slabs subjected to moment and cyclic loading.” ACI Struct. J., 99(4), 435–444.
Ebead, U. A., and Marzouk, H. (2002b). “Strengthening of two-way slabs using steel plates.” ACI Struct. J., 99(1), 23–31.
Ebead, U. A., and Marzouk, H. (2004). “Fiber-reinforced polymer strengthening of two-way slabs.” ACI Struct. J., 101(5), 650–659.
Ebead, U. A., and Marzouk, H. (2005). “Tension-stiffening model for FRP-strengthened RC concrete two-way slabs.” Mater. Struct., 38(2), 193–200.
Ebead, U. A., and Saeed, H. (2013). “Hybrid shear strengthening system for reinforced concrete beams: An experimental study.” Eng. Struct., 49, 421–433.
Ebead, U. A., and Saeed, H. (2014). “Numerical modeling of shear strengthened reinforced concrete beams using different systems.” J. Compos. Constr., 04013031.
Elsayed, W. E., Ebead, U. A., and Neale, K. W. (2009). “Mechanically fastened FRP-strengthened two-way concrete slabs with and without cutouts.” J. Compos. Constr., 198–207.
Fahmy, E. H., Shaheen, Y. B. I., Abou Zeid, M. N., and Gaafar, H. M. (2012). “Ferrocement sandwich and hollow core panels for floor construction.” Can. J. Civ. Eng., 39(12), 1297–1310.
Ganesan, N., Indira, P. V., and Thadathil, S. P. (2011). “Effect of ferrocement wrapping system on strength and behavior of RC frames under reversed lateral cyclic loading.” Exp. Tech., 35(4), 23–28.
Greepala, V., and Nimityongskul, P. (2008). “Structural integrity of ferrocement panels exposed to fire.” Cement Concrete Compos., 30(5), 419–430.
Haddad, R. H., Shannag, M. J., and Moh’d, A. (2008). “Repair of heat-damaged RC shallow beams using advanced composites.” Mater. Struct., 41(2), 287–299.
Hashemi, S., and Al-Mahaidi, R. (2012). “Experimental and finite element analysis of flexural behavior of FRP-strengthened RC beams using cement-based adhesives.” Constr. Build. Mater., 26(1), 268–273.
Hussein, M., Kunieda, M., and Nakamura, H. (2012). “Strength and ductility of RC beams strengthened with steel-reinforced strain hardening cementitious composites.” Cement Concrete Compos., 34(9), 1061–1066.
Ibrahim, H. M. H. (2011). “Shear capacity of ferrocement plates in flexure.” Eng. Struct., 33(5), 1680–1686.
Jankowiak, I. (2012). “Analysis of RC beams strengthened by CFRP strips—Experimental and FEA study.” Arch. Civ. Mech. Eng., 12(3), 376–388.
Kaushik, S., Prakash, A., and Singh, A. (1990). “Inelastic buckling of ferrocement encased columns.” Proc., Int. Symp. on Ferrocement, Taylor and Francis, New York, 327–341.
Kazemi, M. T., and Morshed, R. (2005). “Seismic shear strengthening of R/C columns with ferrocement jacket.” Cement Concrete Compos., 27(7–8), 834–842.
Kotynia, R., Baky, H. A., Neale, K. W., and Ebead, U. A. (2008). “Flexural strengthening of RC beams with externally bonded CFRP systems: Test results and 3D nonlinear FE analysis.” J. Compos. Constr., 190–201.
Li, B., and Lam, E. S. S. (2012). “Strengthening of reinforced concrete beam-column joints using ferrocement.” Concrete Solutions, M. Grantham, V. Mechtcherine, and U. Schneck, eds., Taylor & Francis Group, London, 717–726.
Liao, H. P., and Fang, S. S. (2011). “An experimental study on flexural behavior of reinforced concrete beams strengthened with high-performance ferrocement.” Adv. Mater. Res., 163–167(1), 3772–3776.
Maalej, M., and Leong, K. S. (2005). “Engineered cementitious composites for effective FRP-strengthening of RC beams.” Compos. Sci. Technol., 65(7–8), 1120–1128.
Maalej, M., Quek, S. T., Ahmed, S. F. U., Zhang, J., Lin, V. W. J., and Leong, K. S. (2012). “Review of potential structural applications of hybrid fiber engineered cementitious composites.” Constr. Build. Mater., 36(7–8), 216–227.
Masood, A., Arif, M., Akhtar, S., and Haquie, M. (2003). “Performance of ferrocement panels in different environments.” Cement Concrete Res., 33(4), 555–562.
Moita, G. F., de Las Casas, E. B., Mantilla-Carrasco, E. V., and Bonifácio, S. N. (2003). “Experimental and numerical analysis of large ferrocement water tanks.” Cement Concrete Compos., 25(2), 243–251.
Mourad, S. M., and Shannag, M. J. (2012a). “Repair and strengthening of reinforced concrete square columns using ferrocement jackets.” Cement Concrete Compos., 34(2), 288–294.
Mourad, S. M., and Shannag, M. J. (2012b). “Repairing reinforced concrete rectangular columns using ferrocement laminates.” Concrete solutions, M. Grantham, V. Mechtcherine, and U. Schneck, eds., Taylor & Francis Group, London, 757–763.
Ombres, L. (2011). “Flexural analysis of reinforced concrete beams strengthened with a cement based high strength composite material.” Compos. Struct., 94(1), 143–155.
Ombres, L. (2012). “Debonding analysis of reinforced concrete beams strengthened with fibre reinforced cementitious mortar.” Eng. Fract. Mech., 81, 94–109.
Paramasivam, P., Lim, C. T. E., and Ong, K. C. G. (1998). “Strengthening of RC beams with ferrocement laminates.” Cement Concrete Compos., 20(1), 53–65.
Shang, S. P., Zeng, L. H., and Peng, H. (2005). “Nonlinear analysis of reinforced concrete beam strengthened with ferrocement.” Eng. Mech., 3, 21.
Shannag, M. J., and Al-Ateek, S. A. (2006). “Flexural behavior of strengthened concrete beams with corroding reinforcement.” Constr. Build. Mater., 20(9), 834–840.
Takiguchi, K. A. (2001). “Shear strengthening of reinforced concrete columns using ferrocement jacket.” ACI Struct. J., 98(5), 696–704.
Takiguchi, K. A. (2003). “An investigation into the behavior and strength of reinforced concrete columns strengthened with ferrocement jackets.” Cement Concrete Compos., 25(2), 233–242.
Thanoon, W. A., Yardim, Y., Jaafar, M. S., and Noorzaei, J. (2010). “Structural behaviour of ferrocement-brick composite floor slab panel.” Constr. Build. Mater., 24(11), 2224–2230.
Xiong, G. J., Wu, X. Y., Li, F. F., and Yan, Z. (2011). “Load carrying capacity and ductility of circular concrete columns confined by ferrocement including steel bars.” Constr. Build. Mater., 25(5), 2263–2268.
Yaqub, M., Bailey, C. G., Nedwell, P., Khan, Q. U. Z., and Javed, I. (2013). “Strength and stiffness of post-heated columns repaired with ferrocement and fibre reinforced polymer jackets.” Compos. Part B, 44(1), 200–211.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 27 • Issue 10 • October 2015
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jun 17, 2014
Accepted: Nov 21, 2014
Published online: Jan 6, 2015
Discussion open until: Jun 6, 2015
Published in print: Oct 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.