Abstract
The pore size distributions of hardened cement pastes were studied in the research reported in this paper in order to investigate whether there was a relationship with the risk of freeze thaw related distress. Mercury intrusion porosimetry (MIP) and cyclic freezing and thawing tests were used to assess cement pastes with different water-to-cement (w/c) ratios and supplementary cementitious materials. Typical pavement mixtures contain a range of pore sizes similar to those in aggregate prone to D-cracking. Such pore sizes are reported to resist drying, thus they may increase saturation and so the risk of damage under freezing and thawing.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to acknowledge the financial support from Federal Highway Administration (FHWA) and Transportation Pooled Fund (TPF), along with help and support from CP Tech center lab staff.
References
Abell, A. B., Willis, K. L., and Lange, D. A. (1999). “Mercury intrusion porosimetry and image analysis of cement-based materials.” J. Colloid Interface Sci., 211(1), 39–44.
American Concrete Institute (ACI). (1996). “Guide for use of normal weight aggregate in concrete.”, Farmington Hills, MI.
Alexander, M., and Mindess, S. (2005). Aggregates in concrete, Taylor and Francis, London.
ASTM. (2012). “Standard specification for portland cement.”, Reston, VA.
ASTM. (2013a). “Standard specification for slag cement for use in concrete and mortars.”, Reston, VA.
ASTM. (2013b). “Standard terminology related to thermal insulation.”, Reston, VA.
Chindaprasirt, P., Jaturapitakkul, C., and Sinsiri, T. (2005). “Effect of fly ash fineness on compressive strength and pore size of blended cement paste.” Cement Concrete Compos., 27(4), 425–428.
Cook, R. A., and Hover, K. C. (1999). “Mercury porosimetry of hardened cement pastes.” Cement Concrete Res., 29(6), 933–943.
Fagerlund, G. (1977). “The international cooperative test of the critical degree of saturation method of assessing the freeze/thaw resistance of concrete.” Mater. Struct., 10(4), 231–253.
Galle, C. (2001). “Effect of drying on cement-based materials pore structure as identified by mercury intrusion porosimetry: A comparative study between oven-, vacuum-, and freeze-drying.” Cement Concrete Res., 31(10), 1467–1477.
Kosmatka, S. H., Kerkhoff, B., and Panarese, W. C. (2002). Design and control of concrete mixtures, 14th Ed., Portland Cement Association, Skokie, IL.
Lange, D., Jennings, H. M., and Shah, S. P. (1994). “Image analysis techniques for characterization of pore structure of cement-based materials.” Cement Concrete Res., 24(5), 841–853.
Li, W., Pour-Ghaz, M., Castro, J., and Weiss, J. (2012). “Water absorption and critical degree of saturation relating to freeze-thaw damage in concrete pavement joints.” J. Mater. Civ. Eng, 299–307.
Marks, V. J., and Dubberke, W. (1982). “Durability of concrete and the Iowa pore index test.” Transportation Research Record 853, Transportation Research Board, Washington, DC, 25–30.
Mehta, P. K. (1986). Concrete: Structure, properties, and materials, Prentice-Hall, Englewood Cliffs, NJ.
Page, C. L., and Page, M. M. (2007). Durability of concrete and cement composites, Elsevier, Cambridge, U.K.
Pigeon, M., and Pleau, R. (1995). Durability of concrete in cold climates, CRC, Boca Raton, FL.
Sutter, L., Peterson, K., Julio-Betancourt, G., Hooton, D., Van, D. T., and Smith, K. (2008). “The deleterious chemical effects of concentrated deicing solutions on portland cement concrete.”, South Dakota DOT, Pierre, SD.
Taylor, P. C., Sutter, L. L., and Weiss, W. J. (2012). “Investigation of deterioration of joints in concrete pavements.”, National Concrete Pavement Technology Center, Iowa State Univ., Ames, IA.
Uchikawa, H., Hanehara, S., and Sawaki, D. (1991). “Structure change of hardened mortar by drying.” J. Res. Onoda Cem. Co., 43(124), 1–14.
Villani, C., Spragg, R., Pour-Ghaz, M., and Weiss, J. W. (2012). “The role of deicing salts on the non-linear moisture diffusion coefficient of cementitious materials during drying.” Proc., Int. Symp. on Brittle Matrix Composites, A. M. Brandt, J. Olek, M. A. Glinicki, and C. K. Y. Leung, eds., Institute of Fundamental Technological Research of the Polish Academy of Sciences, Warsaw, Poland, 1–14.
Washburn, E. W. (1921). “Note on a method of determining the distribution of pore sizes in a porous material.” Proc. Natl. Acad. Sci. USA, 7(4), 115–116.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jun 6, 2013
Accepted: Feb 5, 2014
Published online: Jul 16, 2014
Discussion open until: Dec 16, 2014
Published in print: Mar 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.