Effectiveness of Lithium Nitrate in Mitigating Alkali-Silica Reaction in the Presence of Fly Ashes of Varying Chemical Compositions
Publication: Journal of Materials in Civil Engineering
Volume 26, Issue 7
Abstract
In this study, quantitative analysis of the combined effects of fly ash and lithium admixture in mitigating alkali-silica reaction (ASR) in portland cement mortars prepared with Spratt limestone was investigated. The results from this investigation suggested that mortar bar expansions could be correlated with specific oxide(s) content in the fly ash through exponential relationships. The dosage of lithium nitrate required for ASR mitigation in mortars containing fly ashes having CaO content less than 23.50% was found to be less than that in the control mortars. Since lithium nitrate was found to be effective in reducing the expansions of control (no fly ash) mortars and mortars containing fly ashes, economic solutions can be obtained in both. However, the use of lithium nitrate was not needed for mortars containing fly ashes having CaO content less than 14.40%. A linear relationship between the oxide content of fly ash and the lithium dosage was found to exist, that can be used to optimize the lithium dosage as a function of fly ash composition to provide an economic solution for ASR mitigation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank the Office of Naval Research and the Naval Facilities Engineering Service Center (NAVFAC ESC) for providing support for this research. Also the authors would like to extend their gratitude to the fly ash suppliers for this project including Headwater Resources, DBA Salt River Materials Group, Nebraska Ash Company, and Separation Technologies, LLC.
References
ACI. (2004). “Use of fly ash in concrete.” 232.2R-03, Farmington Hills, MI.
ASTM. (2008). “Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete.” ASTM C 618, West Conshohocken, PA.
Bian, Q., Nishibayashi, S., Kuroda, T., Wu, X., and Tang, M. (1996). “Various chemicals in suppressing expansion due to alkali–silica reaction.” Proc., 10th Int. Conf. on Alkali–Aggregate Reaction, CSIRO Division of Building Construction and Engineering, Melbourne, Australia, 868.
Bleszynski, R. F., and Thomas, M. D. A. (1997). “Microstructural studies of alkali-silica reaction in fly ash concrete immersed in alkaline solutions.” Adv. Cem. Based Mater. J., 7(2), 66–78.
Bumrongjaroen, W., Muller, I. S., and Pegg, I. L. (2007). “Characterization of glassy phase in fly ash from Iowa State University.”, Turner Fairbank Research Center Federal Highway Administration, Washington, DC, 1–53.
Collins, C., Ideker, J., Willis, G., and Kurtis, K. (2004). “Examination of the effects of LiOH, LiCl, and LiNO3 on ASR.” Cem. Concr. Res., 34(8), 1403–1414.
CSA. (2003). “Cementitious materials for use in concrete.” A 3001, Toronto, 30.
Diamond, S., and Lopez-Flores, F. (1981). “On the distinction in physical and chemical characteristics between lignitic and bituminous fly ashes. Effects of fly ash incorporation in cement and concrete.” S. Diamond, ed., Proc., MRS Symp., Materials Research Society, Boston, 34–44.
Dunstan, E. R. (1981). “The effect of fly ash on concrete alkali aggregate reaction.” Cem. Concr. Aggregates, 3(2), 101–104.
Durand, B. (2000). “More results about the use of lithium salts and mineral admixtures to inhibit ASR in concrete.” Proc., 11th Int. Conf. on Alkali–Aggregate Reaction, Centre de Recherche Interuniversitaire sur le Beton, QC, Canada, 623.
Folliard, K. J., Thomas, M. D. A., and Kurtis, K. E. (2006). “Guidelines for the use of lithium to mitigate or prevent alkali-silica reaction (ASR).” Publication No. FHWA-RD-03-047, Federal Highway Administration, U.S. Dept. of Transportation, Washington, DC.
Harish, K. V., Rangaraju, P. R., and Vempati, R. (2010). “Fundamental investigations into performance of a carbon neutral rice husk ash as a SCM.” J. Transp. Res. Board, 2164, 26–35.
Kurtis, K., and Monteiro, P. (2003). “Chemical additives to control expansion of ASR gel: Proposed mechanisms of control.” J. Mater. Sci., 38(9), 2027–2036.
Kurtis, K., Monteiro, P., and Meyer-Ilse, W. (2000). “Examination of the effect of LiCl on ASR gel expansion.” Proc., 11th Int. Conf. on Alkali–Aggregate Reaction, Centre de Recherche Interuniversitaire sur le Beton, Quebec, 51.
Lawrence, M., and Vivian, H. F. (1961). “The reactions of various alkalis with silica.” Australian J. Appl. Sci., 12(1), 96–103.
Malvar, L. J., and Lenke, L. R. (2006). “Efficiency of fly ash in mitigating alkali-silica reaction based on chemical composition.” ACI Mater. J., 103(5), 319–326.
Malvar, L. J., and Lenke, L. R. (2009). “Alkali-silica reaction criteria for accelerated mortar bar tests based on field performance data.” World of Coal Ash (WOCA) Conf., Lexington, KY.
McCoy, W. J., and Caldwell, A. G. (1951). “New approach to inhibiting alkali aggregate expansion.” J. Am. Concr. Inst., 22(9), 693–706.
McKeen, R. G., Lenke, L. R., and Pallachulla, K. K. (1998). “Mitigation of alkali-silica reactivity in New Mexico. Report to the Research Bureau, New Mexico Dept. of Transportation.” ATR Institute, Materials Research Center, Univ. of New Mexico, Albuquerque, NM.
McKeen, R. G., Lenke, L. R., Pallachulla, K. K., and Barringer, W. L. (2000). “Mitigation of alkali-silica reactivity in New Mexico.”, Washington, DC, 9–16.
Mehta, P. K. (1985). “Influence of fly ash characteristics on the strength of portland-fly ash mixtures.” Cem. Concr. Res. J., 15(4), 669–674.
Mo, X., Yu, C., and Xu, Z. (2003). “Long-term effectiveness and mechanism of LiOH in inhibiting alkali–silica reaction.” Cem. Concr. Res., 33(1), 115–119.
Obla, K. H., Hill, R. L., Thomas, M. D. A., Shashiprakash, S. G., and Perebatova, O. (2003). “Properties of concrete containing ultra-fine fly ash.” ACI Mater. J., 100(5), 426–433.
Papadakis, V. G. (2000a). “Effect of fly ash on portland cement systems. Part I: Low-calcium fly ash.” Cem. Concr. Res., 30(10), 1647–1654.
Papadakis, V. G. (2000b). “Effect of fly ash on portland cement systems. Part II: High-calcium fly ash.” Cem. Concr. Res., 30(10), 1647–1654.
Ravina, D. (1980). “Optimized determination of PFA (fly ash) fineness with reference to pozzolanic activity.” Cem. Concr. Res., 10(4), 573–580.
Ravina, D. (1981). “Production and collection of fly ash for use in concrete.” Effects of fly ash incorporation in cement and concrete, S. Diamond, ed., Proc., MRS Symp., Materials Research Society, Boston, 2–11.
Rogers, C. (1999). “Multi-Laboratory study of accelerated mortar bar test (ASTM C 1260) for alkali-silica reaction.” Cem. Concr. Aggregates, 21(2), 191–200.
Sakagushi, Y., Takumara, M., Kitagawa, A., Hori, T., Tomosawa, F., and Abe, M. (1989). “The inhibiting effect of lithium compounds on alkali-silica reaction.” Proc., 8th Int. Conf. on Alkali-Aggregate Reaction in Concrete, Kyoto, Japan, Elsevier Applied Science, London, U.K., 229–234.
Schneider, J. F., Hasparyk, N. P., Silva, D. A., and Monteiro, P. J. M. (2008). “Effect of lithium nitrate on the alkali-silica reaction gel.” J. Am. Ceramic Soc., 91(10), 3370–3374.
Shehata, M., Thomas, M. D. A., and Bleszynski, R. F. (1999). “The effect of fly composition on the chemistry of pore solution.” Cem. Concr. Res., 29(12), 1915–1920.
Shehata, M. H., and Thomas, M. D. A. (2000). “The effect of fly ash composition on the expansion of concrete due to alkali-silica reaction.” Cem. Concr. Res., 30(7), 1063–1072.
Stark, D. (1992). “Lithium salt admixtures—An alternative method to prevent expansive alkali–silica reactivity.” 9th Int. Conf. on AAR in Concrete, The Concrete Society, Wexham, U.K., 1017–1025.
Thomas, M. D. A. (1996). “Field studies of fly ash concrete structures containing reactive aggregates.” Mag. Concr. Res., 48(177), 265–279.
Thomas, M. D. A., Baxter, S., Stokes, D., and Hill, R. (2001). “The combined use of fly ash and lithium nitrate for controlling expansion due to alkali-silica reaction.” Int. Center for Aggregates Research 9th Annual Symp. Aggregates—Concrete, Bases and Fines, Austin, TX, Aggregates Foundation for Technology, Research and Education, Alexandria, VA, 15.
Thomas, M. D. A., Hooper, R., and Stokes, D. B. (2000). “Use of lithium-containing compounds to control expansion in concrete due to ASR.” 11th Int. Conf. on AAR in Concrete, Centre de recherche sur les infrastructures de béton (CRIB), Laval Univ., QC, Canada, 783–792.
Thomas, M. D. A., Shehata, M. H., Shashiprakash, S. G., Hopkins, D. S., and Cail, K. (1999). “Use of ternary cementitious systems containing silica fume and fly ash in concrete.” Cem. Concr. Res., 29(8), 1207–1214.
Touma, W. E., Fowler, D. W., and Carrasquillo, R. L. (2001). “Alkali-silica reaction in portland cement concrete: Testing methods and mitigation alternatives.” Research Rep. ICAR 301-1F, International Center for Aggregates Research, Univ. of Texas, Austin, TX, 520.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 26 • Issue 7 • July 2014
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 21, 2012
Accepted: Jul 30, 2013
Published online: Aug 1, 2013
Published in print: Jul 1, 2014
Discussion open until: Sep 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.