Neutron Scattering for Moisture Detection in Foamed Asphalt
Publication: Journal of Materials in Civil Engineering
Volume 25, Issue 7
Abstract
Foamed warm-mix asphalt (WMA) has been widely accepted and used in the United States and many other countries around the world. However, several key concerns about WMA technology still need to be answered, including the major issue of moisture-induced damage. Because of the reduced production temperatures and the foaming process with water, moisture may be entrapped in pavements after compaction. The trapped moisture decreases the adhesion between asphalt binder and aggregates and the cohesion among asphalt binder, resulting in stripping and other forms of pavement distress. The neutron scattering technique provides a unique tool for the determination of the microscopic structure of asphalt and for the detection of the presence of moisture and its spatial distributions in asphalt. In particular, small-angle neutron scattering (SANS) in the wave vector transfer range from is suitable to probe the spatial density fluctuations in the real space from , which has a resolution several orders of magnitude higher than direct imaging techniques. In this study, the SANS technique was utilized to characterize the microstructure of asphalt and to detect the water spatial distributions in foamed asphalt. Two types of asphalt binder and ordinary and heavy water were used to make samples at 150°C using a laboratory foaming device. The samples were then measured using the SANS instrument at the National Institute of Standard and Technology (NIST) Center for Neutron Research (NCNR). The results show that there is no water entity less than 0.1 μm present in the foamed asphalt. Even if moisture does exist in foamed asphalt, it does not cause any structural changes to the asphalt within 0.1 μm.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Yang Zhang acknowledges the support from the Clifford G. Shull fellowship at ORNL. The authors acknowledge the support of NIST and the U.S. Dept. of Commerce in providing the neutron research facilities used in this work. Identification of a commercial product does not imply recommendation or endorsement by the NIST, nor does it imply that the product is necessarily the best for the stated purpose. This work utilized facilities at the NIST Center for Neutron Research supported in part by the National Science Foundation under Agreement No. DMR-0454672.
References
Berliner, R., Popvici, M., Herwig, K. W., Berliner, M., Jennings, H. M., and Thomas, J. J. (1998). “Quasi-elastic neutron scattering study of the effect of water to cement ratio on the hydration kinetics of tricalcium silicate.” Cem. Concr. Res., 28(2), 231–244.
Caro, S., Masad, E., Bhasin, A., and Little, D. N. (2008). “Moisture susceptibility of asphalt mixtures, Part 1: Mechanisms.” Int. J. Pavement Eng., 9(2), 81–98.
Chen, X., and Huang, B. (2008). “Evaluation of moisture damage in hot mix asphalt using simple performance and Superpave indirect tensile tests.” Constr. Build. Mater., 22(9), 1950–1962.
Cheng, J., Shen, J., and Xiao, F. (2011). “Moisture susceptibility of warm-mix asphalt mixtures containing nanosized hydrated lime.” J. Mater. Civ. Eng., 23(11), 1552–1559.
Chowdhury, A., and Button, J. W. (2008). “A review of warm mix asphalt.”, Texas Transportation Institute, College Station, TX.
D’Angelo, J., et al. (2008). “Warm mix asphalt: European practice.”, FHwA, U.S. Dept. of Transportation, Washington, DC.
Diefenderfer, S. D., McGhee, K. K., and Donaldson, B. M. (2007). “Installation of warm mix asphalt projects in Virginia.”, Virginia Dept. of Transportation, Richmond, VA.
FitzGerald, S. A., Neumann, D. A., Rush, J. J., Bentz, D. P., and Livingston, R. A. (1998). “In situ quasi-elastic neutron scattering study of the hydration of tricalcium silicate.” Chem. Mater., 10(1), 397–402.
Hammouda, B., Ho, D. L., and Kline, S. (2004). “Insight into clustering in poly(ethylene oxide) solutions.” Macromolecules, 37(18), 6932–6937.
Huang, B., Shu, X., Dong, Q., and Shen, J. (2010). “Laboratory evaluation of moisture susceptibility of hot-mix asphalt containing cementitious fillers.” J. Mater. Civ. Eng., 22(7), 667–673.
Hurley, C., and Prowell, B. (2006). “Evaluation of potential processes for use in warm mix asphalt.” J. Assoc. Asphalt Paving Technol., 75, 41–90.
Kiggundu, B. M., and Roberts, F. L. (1988). “Stripping in HMA mixtures: State-of-the-art and critical review of test methods.”, National Center for Asphalt Technology (NCAT), Auburn Univ., Auburn, AL.
Kim, F. H., Penumadu, D., and Hussey, D. S. (2012). “Water distribution variation in partially saturated granular materials using neutron imaging.” J. Geotech. Geoenv. Eng., 138(2), 147–154.
Kline, S. R. (2006). “Reduction and analysis of SANS and USANS data using IGOR Pro.” J. Appl. Crystallogr., 39, 895–900.
Kutay, M. E., and Ozturk, H. I. (2012). “Investigation of moisture dissipation in foamed-based warm mix asphalt using synchrotron-based X-ray microtomography.” J. Mater. Civ. Eng., 24(6), 674–683.
Liu, D., Zhang, Y., Chen, C.-C., Mou, C.-Y., Poole, P. H., and Chen, S.-H. (2007). “Observation of the density minimum in deeply supercooled confined water.” Proc. Natl. Acad. Sci., 104(23), 9570–9574.
Liu, D., et al. (2008). “Density measurement of 1-d confined water by small angle neutron scattering method: Pore size and hydration level dependences.” J. Phys. Chem. B, 112(14), 4309–4312.
Liu, J., Saboundjian, S., Li, P., Connor, B., and Brunette, B. (2011). “Laboratory evaluation of sasobit-modified warm mix asphalt for Alaskan conditions.” J. Mater. Civ. Eng., 23(11), 1498–1505.
Lopes, R. T., Bessa, A. P., Braz, D., and de Jesus, E. F. O. (1999). “Neutron computerized tomography in compacted soil.” Appl. Radiat. Isot., 50(2), 451–458.
Martin, J. E., and Hurd, A. J. (1987). “Scattering from fractals.” J. Appl. Crystallogr., 20(2), 61–78.
Middleton, B., and Forfylow, R. W. (2009). “Evaluation of warm-mix asphalt produced with the double barrel green process.” Transp. Res. Rec., 2126, 19–26.
Rassamdana, H., and Sahimi, M. (1996). “Asphalt flocculation and deposition: II. Formation and growth of fractal aggregates.” AIChE J., 42(12), 3318–3332.
Schmets, A., Kringos, N., Pauli, T., Redelius, P., and Scarpas, T. (2010). “On the existence of wax-induced phase separation in bitumen.” Int. J. Pavement Eng., 11(6), 555–563.
Schmidt, P. W. (1991). “Small-angle scattering studies of disordered, porous and fractal systems.” J. Appl. Crystallogr., 24, 414–435.
Shu, X., Huang, B., Shrum, E. D., and Jia, X. (2012). “Laboratory evaluation of moisture susceptibility of foamed warm mix asphalt containing high percentages of RAP.” Constr. Build. Mater., 35(10), 125–130.
Spalla, O. (2002). “General theorems in small-angle scattering.” Chapter 3, Neutron, X-rays and light: Scattering methods applied to soft condensed matter, P. Lindner and T. Zemb, eds., Elsevier, Amsterdam, North Holland, 49–71.
Tao, M., and Mallick, R. (2009). “Effects of warm-mix asphalt additives on properties of reclaimed asphalt pavement material.” Transp. Res. Rec., 2126, 151–160.
Thomas, J. J., FitzGerald, S. A., Neumann, D. A., and Livingston, R. A. (2001). “State of water in hydrating tricalcium silicate and portland cement pastes as measured by quasi-elastic neutron scattering.” J. Am. Ceram. Soc., 84(8), 1811–1816.
Xiao, F., Punith, V. S., Putman, B., and Amirkhanian, S. N. (2011). “Utilization of foaming technology in warm-mix-asphalt mixtures containing moist aggregates.” J. Mater. Civ. Eng., 23(9), 1328–1337.
Xiao, F., Jordan, J., and Amirkhanian, S. N. (2009). “Laboratory investigation of moisture damage in warm mix asphalt containing moist aggregate.” Transportation Research Record 2126, Transportation Research Board, Washington, DC, 115–124.
Xiao, F., Zhao, W., Gandhi, T., and Amirkhanian, S. (2010). “Influence of anti-stripping additives on moisture susceptibility of warm mix asphalt mixtures.” J. Mater. Civ. Eng., 22(10), 1047–1055.
Zhang, Y., Lagi, M., Fratini, E., Baglioni, P., Mamontov, E., and Chen, S.-H. (2009a). “Dynamic susceptibility of supercooled water and its relation to the dynamic crossover phenomenon.” Phys. Rev. E, 79(4), 040201.
Zhang, Y., et al. (2008). “Observation of dynamic crossover and dynamic heterogeneity in hydration water confined in aged cement paste.” J. Phys.: Condens. Matter, 20(50), 502101.
Zhang, Y., et al. (2009b). “Absence of the density minimum of supercooled water in hydrophobic confinement.” J. Phys. Chem. B, 113(15), 5007–5010.
Zhang, Y., et al. (2011a). “Density hysteresis of heavy water confined in a nanoporous silica matrix.” Proc. Natl. Acad. Sci., 108(30), 12206–12211.
Zhang, Y., et al. (2011b). “Density measurement of confined water with neutron scattering.” Proc. Natl. Acad. Sci., 108(47), E1193–E1194.
Zhao, S., Huang, B., Shu, X., Jia, X., and Woods, M. (2012). “Laboratory performance evaluation of warm mix asphalt containing high percentages of RAP.” Transportation Research Record 2294, Transportation Research Board, Washington, DC, 98–105.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Sep 6, 2012
Accepted: Dec 12, 2012
Published online: Dec 14, 2012
Published in print: Jul 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.