Effect of Soil Parameters on Elastic Characteristics of Subgrade Materials
Publication: Journal of Materials in Civil Engineering
Volume 24, Issue 4
Abstract
In this paper, state-dependent elastic characteristics of granular subgrade materials were investigated, assuming various field conditions. For this purpose, a series of resonant column tests were conducted. The test materials were cohesionless soils consisting of clean and silty sands with different fines contents. The effects of moisture content, overconsolidation ratio, relative density, and confining stress on the elastic modulus were analyzed. From the test results, it was observed that the initial shear modulus, , decreases with increasing moisture content because of reduced particle contact friction. Higher fines content produced a more pronounced modulus reduction at the same moisture content. It was also found that the effect of fines content on becomes smaller as the relative density and confining stress increase. These results indicate that the moisture effect on is important at shallow depths such as subgrade layers. A modulus reduction factor was proposed, which can reflect the effect of the soil parameters on elastic modulus. A resilient modulus () model modified on the basis of the test results was proposed and finite-element analyses were conducted. Two case examples were selected from the literature to verify the proposed model. Predicted values obtained using the proposed model showed reasonable agreement with measured values from the selected case examples.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the Basic Science Research Program through the National Research Foundation of Korea (NRF) grant funded by the Korean government (MEST) (No. 2011-0030845).
References
ABAQUS 6.7 [Computer software]. (2007). SIMULIA, Providence, RI.
AASHTO. (1994). “Standard method of test for resilient modulus of unbound granular base/subbase materials and subgrade soils.” SHRP Protocol P46, AASHTO Designation T294-94, Washington, DC.
ASTM. (2001). “Standard test methods for modulus and damping of soils by the resonant column method.” D4015, Philadelphia, PA.
Butalia, T. S., Huang, J., Kim, D. G., and Croft, F. (2002). “Effect of moisture content and pore water pressure buildup on resilient modulus of cohesive soils in Ohio.” Symp. on Resilient Modular Testing for Pavement Components, ASTM, West Conshohocken, PA, 70–84.
Chen, J., Hossain, M., and Latorella, T. M. (1999). “Use of falling weight deflectometer and dynamic cone penetrometer in pavement evaluation.” Transportation Research Record 1655, Transportation Research Board, Washington, DC, 145–151.
Drumm, E. C., Reeves, J. S., Madgett, M. R., and Trolinger, W. D. (1997). “Subgrade resilient modulus correction for saturated effects.” J. Geotech. Geoenviron. Eng.JGGEFK, 123(7), 663–670.
George, K. P., Bajracharya, M., and Stubstad, R. (2004). “Subgrade characterization employing the falling weight deflectometer.” Transportation Research Record 1869, Transportation Research Board, Washington, DC, 73–79.
Hardin, B. O., and Black, W. L. (1966). “Sand stiffness under various triaxial stresses.” J. Soil Mech. Found. Div., 92(2), 27–42JSFEAQ.
Heydinger, A. G., and Davies, B. O. A. (2006). “Analysis of variations of pavement subgrade soil water content.” Proc., 4th Int. Conf. on Unsaturated Soils, ASCE, Reston, VA, 247–257.
Houston, W. N., Houston, S. L., and Anderson, T. W. (1993). “Stress state considerations for resilient modulus testing pavement subgrade.” Transportation Research Record 1406, Transportation Research Board, Washington, DC, 124–132.
Jamiolkowski, M., Lancellotta, R., and Lo Presti, D. (1994). “Remarks on the stiffness at small strains of six Italian clays.” Proc., Int. Symp. on Pre-Failure Deformation Characteristics of Geomaterials, Int. Society of Soil Mechanics and Geotechnical Engineering (ISSMEGE), London, 1–20.
Ke, L., Nazarian, S., Abdallah, I., and Yung, D. (2000). “A sensitivity study of parameters involved in design with seismic moduli.” Research Rep. 1780-2, Center for Highway Materials Research, Univ. of Texas at El Paso, El Paso, TX.
Khoury, N., and Zaman, M. (2004). “Correlation between resilient modulus, moisture variation, and soil suction for subgrade Soils.” Transportation Research Record 1874, Transportation Research Board, Washington, DC, 99–107.
Kim, D. S., Kweon, G. C., and Lee, K. H. (2001). “Alternative method of determining resilient modulus of subgrade soils using a static triaxial test.” Can. Geotech. J.CGJOAH, 38(1), 107–116.
Kim, D. S., and Stokoe, K. H. (1992). “Characterization of resilient modulus of compacted subgrade soils using resonant column and torsional shear tests.” Transportation Research Record 1369, Transportation Research Board, Washington, DC, 83–91.
Kumar, J., and Clayton, C. R. I. (2007). “Effect of sample torsional stiffness on resonant column test results.” Can. Geotech. J.CGJOAH, 44(2), 221–230.
Kung, H. S., Lin, H. D., Yang, S., and Huang, W. (2006). “Resilient modulus and plastic strain of unsaturated cohesive subgrade soils.” Proc., 4th Int. Conf. on Unsaturated Soils, ASCE, Reston, VA, 189, 541–552.
Ladd, R. S. (1978). “Preparing test specimens using undercompaction.” Geotech. Test. J.GTJODJ, 1(1), 16–23.
Lambe, T. W., and Whitmann, R. V. (1969). Soil mechanics, Wiley, New York.
Lanzo, G., Vucetic, M., and Doroudian, M. (1997). “Reduction of shear modulus at small strains in simple shear.” J. Geotech. Geoenviron. Eng.JGGEFK, 123(11), 1035–1042.
Lee, J., Kim, J., and Kang, B. (2009). “Normalized resilient modulus model for subbase and subgrade based on stress-dependent modulus degradation.” J. Transp. Eng.SEJTAO, 135(9), 600– 610.
Li, J., and Qubain, B. S. (2002). “Resilient modulus variation with water content.” Symp. on Resilient Modular Testing for Pavement Components, ASTM, West Conshohocken, PA, 59–69.
Meng, J., and Rix, G. J. (2003). “Reduction of equipment-generated damping in resonant column measurements.” GéotechniqueGTNQA8, 53(5), 503–512.
Mohammad, L. N., Herath, A., Abu-Farsakh, M. Y., Gaspard, K, and Gudishala, R. (2007). “Prediction of resilient modulus of cohesive subgrade soils from dynamic cone penetrometer test parameters.” J. Mater. in Civil Eng.JMCEE7, 19(11), 986–992.
Monismith, C. L. (1992). “Analytically based asphalt pavement design and rehabilitation: Theory to practice, 1962-1992.” Transportation Research Record 1354, Transportation Research Board, Washington, DC, 5–28.
Najarian, S., Yuan, D., and Williams, R. (2003). “A simple method for determining modulus of base and subgrade materials.” Resilient modulus testing for pavement components, ASTM STP 1437, West Conshohocken, PA.
Nazarian, S., and Williams, R. R. (2007). “Correlation of resilient and seismic modulus test results.” J. Mater. Civ. Eng.JMCEE7, 19(12), 1026–1032.
Nazzal, M. D., Mohammad, L. N. (2010). “Estimation of resilient modulus of subgrade soils for design of pavement structures.” J. Mater. Civ. Eng.JMCEE7, 22(7), 726–734.
Park, S. W., and Lytton, R. L. (2004). “Effect of stress-dependent modulus and Poisson’s ratio on structural responses in thin asphalt pavements.” J. Transp. Eng.SEJTAO, 130(3), 387–394.
Qian, X., Gray, D. H., and Woods, R. D. (1993). “Voids and granulometry: effects on shear modulus of unsaturated sands.” J. Geotech. Eng.JGENDZ, 119(2), 295–314.
Richart, F. E. Jr., Hall, J. R., and Woods, R. D. (1970). Vibrations of soils and foundations, Prentice Hall, Englewood Cliffs, NJ.
Salgado, R., Bandini, P., and Karim, A. (2000). “Stiffness and strength of silty sand.” J. Geotech. Geoenviron. Eng.JGGEFK, 126(5), 451–462.
Sawangsuriya, A., Edil, T. B., and Bosscher, P. J. (2009). “Modulus-suction-moisture relationship for compacted soils in postcompaction state.” J. Geotech. Geoenviron. Eng.JGGEFK, 135(10), 1390–1403.
Shibuya, S., et al. (1992). “Elastic deformation properties of geomaterials.” Soils Found., 32(3), 26–46.
Thompson, M. R. (1989). “Factors affecting the resilient moduli of the soils and granular materials.” Proc., Workshop on Resilient Modulus Testing, Oregon State Univ., Corvallis, OR.
Uzan, J. (1992). “Resilient characterization of pavement materials.” Int. J. Numer. Anal. Methods Geomech.IJNGDZ, 16(6), 453–459.
Witczak, M. W., Qi, X., and Mirza, M. W. (1995). “Use of nonlinear subgrade modulus in AASHTO design procedure.” J. Transp. Eng.JTPEDI, 121(3), 273–282.
Yang, S., Huang, W., and Tai, Y. (2005). “Variation of resilient modulus with soil suction for compacted subgrade soils.” Transportation Research Record 1913, Transportation Research Board, National Research Council, Washington, DC, 99–106.
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Jan 7, 2011
Accepted: Sep 14, 2011
Published online: Sep 16, 2011
Published in print: Apr 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.