Analysis of Structural Changes in Cold-Formed Steel Profiles Caused by Production Technology
Publication: Journal of Materials in Civil Engineering
Volume 23, Issue 9
Abstract
Because of different production technology, the calculation of cold-formed profiles significantly differs from that of hot-rolled profiles. Formation of various section shapes from the basic sheets induces changes in material mechanical properties, which manifest themselves through different yield point, ultimate tensile strength, modulus of elasticity and reduced elongation percentage. Yield stress distribution over the cross section also changes, the largest values are in the corners of the profile. This paper presents testing results obtained from tensile coupons taken from different regions within profiles and compression tests on complex stub columns. Results are shown on cumulative diagrams and compared with those obtained from the base strip coupons. Before testing, a detailed measurement of real geometric properties of profiles was performed to determine the initial geometric imperfections of samples. The obtained results represent important parameters in determining appropriate buckling curves of centrically compressed members made from cold-formed profiles.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Iron and Steel Institute (AISI). (2007). North American specification for the design of cold-formed steel structural members, AISI-S100, Washington, DC.
ASTM. (1986). “Standard method for notched bar impact testing of metallic materials.” E23-86, West Conhohoken, PA.
ASTM. (2004). “Standard test methods for analyses of metals in refuse-derived fuel by atomic absorption spectroscopy.” E885-88, West Conhohoken, PA, (withdrawn 2009).
Bešević, M. (1999). “Contribution to the analysis of centrically compressed members made from cold formed profiles.” Ph.D. thesis, Faculty of Civil Engineering, Univ. of Belgrade, Belgrade, Serbia.
Bešević, M., and Budjevac, D. (1993). “Joining methods for cold formed profiles.” Proc. from the Faculty of Civil Engineering Subotica No. 9, Univ. of Novi Sad, Faculty of Civil Engineering, Subotica, Serbia.
Ellobody, E., and Young, B. (2005). “Structural performance of cold-formed high strength stainless steel columns.” J. Constr. Steel Res., 61, 1631–1649.
Gao, L., Sun, H.Jin, F., and Fan, H. (2008). “Load-carrying capacity of high-strength box-section I: Stub columns.” J. Constr. Steel Res., 65(4), 918–924.
Gardner, L., and Nethercot, D. A. (2004). “Experiments on stainless steel hollow sections—Part 1: Material and cross-sectional behavior.” J. Constr. Steel Res., 60, 1291–1318.
Institution of Civil Engineers (ICE). (2006). Eurocode 3: Design of steel structures/parts 1–3: General—Cold formed thin gauge members and sheeting, BS EN 1993-1-3, London.
Linder, J. (2000). “Stability of structural members—General report.” J. Constr. Steel Res., 55, 29–44.
Liu, Y., and Young, B. (2003). “Buckling of stainless steel square hollow section compression members.” J. Constr. Steel Res., 59, 165–177.
Rondal, J. (2000). “Cold formed of steel members and structure—General report.” J. Constr. Steel Res., 55(1), 155–158.
Yu, W. (1985). Cold-formed steel design, Wiley-Interscience, New York.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Dec 24, 2010
Accepted: Mar 10, 2011
Published online: Mar 12, 2011
Published in print: Sep 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.