Chloride-Induced Corrosion of Steel in Cracked OPC and PPC Concretes: Experimental Study
Publication: Journal of Materials in Civil Engineering
Volume 23, Issue 7
Abstract
The corrosion behavior of steel in cracked ordinary portland cement (OPC) and portland pozzolana cement (PPC) concretes when exposed to a chloride-rich environment is presented here. Three water-to-cement () ratios, and precrack widths of 0.2 and 0.4 mm were studied. A simple -shaped specimen with precracks under flexural load was used in the study; the specimen has a deformed steel bar of 12 mm diameter placed at the bottom with 20 mm clear cover. Measurements made include chloride ion penetrability, sorptivity, half-cell potential, resistivity, total charge passed and gravimetric weight loss. The chloride ion penetrability of PPC was found to be nearly three times lower than that of OPC. The reduction in the gravimetric weight loss of rebars in PPC with respect to those in OPC is in the range of about 1.5 to 2.0 in the case of precracked concretes. The reduction in diameter (i.e., caused by pitting) is higher for OPCs. Studies showed that PPC is significantly superior to the corresponding uncracked OPCs in terms of corrosion inhibition even under cracked conditions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Authors acknowledge the assistance rendered by the staff of Advanced Concrete Testing & Evaluation Laboratory and Advanced Materials Laboratory, CSIR-SERC. First author would like to acknowledge discussions with his colleague Dr. J. K. Dattatreya, Scientist, during the course of study. This paper is being published with the kind permission of the Director of CSIR-SERC, Chennai.
References
Alonso, C., Andrade, C., Rodriguez, J., and Diez, J. M. (1998). “Factors controlling cracking of concrete affected by reinforcement corrosion.” Mater. Struct., 31, 435–441.
American Concrete Institute (ACI). (1996). “Corrosion of metals in concrete.” ACI222R-01, Detroit.
American Concrete Institute (ACI). (2009). “Building code requirements for structural concrete and commentary.” ACI 318-09, Detroit.
American Concrete Institute (ACI). (2009). “Control of cracking in concrete structures.” ACI 224.1R-07, Detroit.
Arya, C., and Ofori-Darko, F. K. (1996). “Influence of crack frequency on reinforcement corrosion in concrete.” Cem. Concr. Res., 26(3), 345–353.
Arya, C., and Xu, Y. (1995). “Effect of cement type on chloride binding and corrosion of steel in concrete.” Cem. Concr. Res., 25(4), 893–902.
ASTM. (2003). “Standard practice for preparing, cleaning, and evaluating corrosion test specimens.” ASTM G1, Philadelphia.
ASTM. (2004). “Standard test method for electrical indication of concrete’s ability to resist chloride penetration.” ASTM C1202-97, Philadelphia.
Austin, S. A., Lyons, R., and Ing, M. J. (2004). “Electrochemical behaviour of steel reinforced concrete during accelerated corrosion testing.” Corrosion, 60(2), 203–212.
Beeby, A. W. (1978). “Corrosion of reinforcing steel in concrete and its relation to cracking.” Struct. Eng. Part A, 56A(3), 77–81.
Bentur, A., Diamond, S., and Berke, S. (1998). Steel corrosion in concrete: Fundamentals and civil engineering practice, E & FN Spon, London.
Bijen, J. (1996). “Benefits of slag and fly ash.” Constr. Build. Mater., 10(5), 309–314.
Bilodeau, A., Sivasundaram, V., Painter, K. E., and Malhotra, V. M. (1994). “Durability of concrete incorporating high volumes of fly ash from sources in the U.S.” ACI Mater. J., 91(1), 3–12.
British Standards Institution (BSI). (1985). “Structural use of concrete—Part 2: Code of practice for special circumstances.” BS 8110-2, London.
Bureau of Indian Standards (BIS). (2005). “Code of practice for plain and reinforced concrete.” IS 456:2000 (reaffirmed), New Delhi.
Bureau of Indian Standards (BIS). (1991). “Indian standard specification for portland pozzolana cement (fly ash based).” IS 1489 (Part I):1991, New Delhi.
Cabrera, J. G. (1996). “Deterioration of concrete due to reinforcement steel corrosion.” Cem. Concr. Compos., 18, 47–59.
Comité Euro-International du Béton (CEB). (1989). Durable concrete structures, Bulletin d’information No. 182, Design guide, 2nd Ed., Paris.
Congqi, Fang, Karin, Lundgren, Mario, Plos, and Kent, Gylltoft (2006). “Bond behaviour of corroded reinforcing steel bars in concrete.” Cem. Concr. Res., 36(10), 1931–1938.
Coutinho, J. S. (2003). “The combined benefits of CPF and RHA in improving the durability of concrete structures.” Cem. Concr. Compos., 25, 51–59.
Dias, W. P. S. (2004). “Influence of drying on concrete sorptivity.” Mag. Concr. Res., 56(9), 537–543.
Dinakar, P., Babu, K. G., and Santhanam, M. (2007). “Corrosion behaviour of blended cements in low and medium strength concretes.” Cem. Concr. Compos., 29, 136–145.
Florida Department of Transportation (FDOT). (2000). “An accelerated laboratory method for corrosion of reinforced concrete using impressed current.” Manual of Florida sampling and testing methods, Tallahassee, FL, 6.
Francois, R., and Maso, J. C. (1988). “Effect of damage in reinforced concrete on carbonation or chloride penetration.” Cem. Concr. Res., 18, 961–970.
Gadve, S. A., Mukherjee, A., and Malhotra, S. N. (2009). “Corrosion of steel reinforcements embedded in FRP wrapped concrete.” Constr. Build. Mater., 23, 153–161.
Güneyisi, E., Özturan, T., and Gesolu, M. (2006). “Performance of plain and blended cement concretes against corrosion cracking.” Int. Symp. on Measuring, Monitoring and Modeling Concrete Properties, Part 2, Maria S. Konsta-Gdoutos, ed., 189–198.
Holm, J. (1987). “Comparison of the corrosion potential of calcium chloride and a calcium nitrate based non-chloride accelerator-a macro-cell corrosion approach.” Corrosion, concrete, and chlorides-steel corrosion in concrete: Causes and restraints, W. Francis and Gibson, ed., SP-102, ACI, 35–49.
Liu, Y., and Weyers, R. E. (1996). “Time to cracking for chloride induced corrosion in reinforced concrete.” Corrosion of reinforcement in concrete construction, C. L. Page, P. B. Bamforth, and J. W. Figg, eds., The Royal Society of Chemistry, 88–104.
Maaddawy, T. A. El, and Soudki, K. A. (2003). “Effectiveness of impressed current technique to simulate corrosion of steel reinforcement in concrete.” J. Mater. Civ. Eng., 15(1), 41–47.
Mackechnie, J., and Alexander, M. G. (1996). “Marine exposure of concrete under selected South African conditions.” Proc, 3rd ACI/CANMET Int. Conf. on the Performance of Concrete in Marine Environment, Canada, 205–216.
Malhotra, V. M., and Mehta, P. K. (2002). High performance, high volume fly ash concrete: Materials, mixture proportioning, properties, construction practice, and case histories, Marquardt Printing, Ottawa, Canada.
Mangat, P., Khatib, J., and Molloy, B. (1994). “Microstructure, chloride diffusion and reinforcement corrosion in blended cement paste and concrete.” Cem. Concr. Compos., 16(2), 73–81.
Mangat, P., and Molloy, B. (1991). “Factors influencing chloride induced corrosion of reinforcement in concrete.” Mater. Struct., 25(7), 404–411.
Mohammed, T. U., Otsuki, N., and Hamada, H. (2003). “Corrosion of steel bars in cracked concrete under marine environment.” J. Mater. Civ. Eng., 15(5), 460–469.
Mohammed, T. U., Otsuki, N., Hisada, M., and Shibata, T. (2001). “Effect of crack width and bar types on corrosion of steel in concrete.” J. Mater. Civ. Eng., 13(3), 194–201.
Ohno, Y., Praparntanatorn, S., and Suzuki, L. (1996). “Influence of cracking and water cement ratio on macrocell corrosion of steel in concrete.” Corrosion of reinforcement in concrete construction, C. L. Page, P. B. Bamforth and J. W. Figg, eds., The Royal Society of Chemistry, 88–104.
Okaba, S. H., El-Dieb, A. S., and Reda, M. M. (1997). “Evaluation of the corrosion resistance of latex modified concrete (LMC).” Cem. Concr. Res., 27(6), 861–868.
Okada, K., and Miyagawa, T. (1980). “Chloride corrosion of reinforcing steel in cracked concrete.” Performance of concrete in marine environment, V. M. Malhotra, ed., SP-65, ACI, 237–254.
Otieno, M. B. (2008). “Corrosion propagation in cracked and uncracked concrete.” M.S. thesis, Univ. of Cape Town, South Africa.
Pettersson, K., Jorgensen, O., and Fidjestol, P. (1996). “The effect of the cracks on reinforcement corrosion in high performance concrete in a marine environment.” Third CANMET/ACI International conference on performance in marine environment, V. M. Malhotra, ed., SP 163, 185–200.
Rajamane, N. P., et al. (2008). “Studies on evaluation of durability of cracked RC members using fly ash concrete subjected to accelerated corrosion and carbonation.” GAP-02541, SERC, Chennai (internal report).
Raupach, M. (1996). “Corrosion of steel in the area of cracks in concrete—Laboratory tests and calculations using a transmission line model.” Corrosion of reinforcement in concrete construction, C. L. Page, P. B. Bamforth, and J. W. Figg, eds., The Royal Society of Chemistry, 13–23.
Sahmaran, M., Victor, C. Li, and Andrade, C. (2008). “Corrosion resistance performance of steel-reinforced engineered cementitious composite beams.” ACI Mater. J., 105(3), 243–250.
Sakr, K. (2005). “Effect of cement type on the corrosion of reinforcing steel bars exposed to acidic media using electrochemical techniques.” Cem. Concr. Res., 35, 1820–1826.
Saraswathy, V., and Song, H. W. (2008). “Evaluation of cementitious repair mortars for corrosion resistance.” Portugaliae Electrochimica Acta, 26(5), 417–432.
Saricimen, H., Maslehuddin, M., AI-Tayyib, A. J., and AI-Mana, A. I. (1995). “Permeability and durability of blended cement concrete cured in the field and laboratory conditions.” ACI Mater. J., 9(2), 111–116.
Schießl, P., and Rapauch, M. (1997). “Laboratory studies and calculations on the influence of crack width on chlorideinduced corrosion of steel in concrete.” ACI Mater. J., 94(1), 56–62.
Scott, A., and Alexander, M. G. (2007). “The influence of binder type, cracking and cover on corrosion rates of steel in chloride-contaminated concrete.” Mag. Concr. Res., 59(7), 495–505.
Sharp, J. V., Figg, J. W., and Leeming, M. B. (1988). “The assessment of corrosion of reinforcement in marine concrete by electrochemical and other methods.” Concrete in marine environment, Proc., 2nd Int. Conf., V. M. Malhotra, ed., ACI SP-109, 105–125.
Sivasundaram, V., Carette, G. G., and Malhotra, V. M. (1989). “Properties of concrete incorporating low quantity of cement and high volumes of low calcium fly ash.” Fly Ash, Silica Fume, Slag, and Natural Pozzolans in Concrete-Proc., 3rd Int. Conf., V. M. Malhotra, ed., SP-114(1), 45–71.
Suzuki, K., Ohno, Y., Praparntanatorn, S., and Tamura, H. (1990). Mechanism of steel corrosion in cracked concrete, corrosion of reinforcement in concrete, C. Page, K. Treadaway, and P. Bamforth, eds., London, Society of Chemical Industry, 19–28.
Thangavel, K., Muralidharan, S., and Saraswathy, V. (2009). “Migrating VS admixed corrosion inhibitors for steel in Portland, Pozzolana and Slag cement concretes under macrocell condition.” Arabian J. Sci. Eng., 34(2C), 81–93.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Aug 15, 2010
Accepted: Dec 22, 2010
Published online: Jun 15, 2011
Published in print: Jul 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.