Static and Cyclic Out-of-Plane Response of Masonry Walls Strengthened Using Textile-Mortar System
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 11
Abstract
The work presented in this paper is a part of a comprehensive research project aimed at developing and testing a system for strengthening historical buildings. The system is composed of a combination of textile mesh and mortar. Representative wall specimens were tested for their out-of-plane flexural behavior under static and cyclic loadings. The parameters investigated include the types of masonry wall (concrete block, sandstone, and brick), mortar (natural lime and cement-based), and textile (bitumen coated E-glass, basalt, or coated basalt fibers). Companion specimens, strengthened using a steel wire mesh, were also tested for comparison. All textile-mortar reinforced masonry (TRM) wall specimens failed in a combination of transverse detachment of the textile-mortar matrix due to the transverse displacement of the blocks relative to each other, and combined transverse shear-tension fracturing of the textile fibers. Regardless of the mode of failure, the TRM specimens developed a substantial increase in their out-of-plane load and displacement capacities under static loading, and low stiffness and strength degradation, and considerable displacement capacities under cyclic loading. The wire mesh-mortar reinforced masonry specimens developed the highest load capacity but were the least ductile when compared to the TRM specimens.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The project is supported by the International Co-operation (INCO-MED) Program-European Commission, 6th Framework Program for Research, Technological Development and Demonstration, Contract No. UNSPECIFIED517765 (INCO). The writers are most grateful for this support and to the Faculty of Engineering and Architecture at the American University of Beirut (AUB) for providing the laboratory facilities.
References
ACI Committee. (2006). “Guide for the design and construction of structural concrete reinforced with FRP bars.” ACI 440.1R-06, Farmington Hills, MI.
ACI Committee. (2008). “Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures.” ACI 440.2R-08, Farmington Hills, MI.
Bournas, D. A., Lontou, P. V., Papanicolaou, C. G., and Triantafillou, T. C. (2007). “Textile-reinforced mortar versus fiber-reinforced polymer confinement in reinforced concrete columns.” ACI Struct. J., 104(6), 740–748.
CEB-FIB. (2001). “Externally bonded FRP reinforcement for RC structures.” Technical Rep., Bulletin No. 14.
Harajli, M., and ElKhatib, H. (2007). “Selection of mortar mixes for open and fully compatible next generation system for the rehabilitation of Mediterranean building heritage—OPEREHA.” Rep. No. Operha-D9-Labein-001-V01, Inco-MED Program, European Commission, 55.
Harajli, M., and ElKhatib, H. (2008). “Experimental evaluation of the behavior of masonry walls strengthened using textile-mortar system.” Rep. No. Operha-D11-Labein-002-V01, Inco-MED Program, European Commission, 29.
International Building Code (IBC). (2006). Int. Code Council, Country Club Hills, IL.
Papanicolaou, C. G., Triantafillou, T. C., Papathanasiou, M., and Karlos, K. (2007). “Textile reinforced mortar (TRM) versus FRP as strengthening material of URM walls: Out-of-plane cyclic loading.” Mat. and Struct., RILEM, 14(1), 143–157.
Triantafillou, T. C. (1998). “Strengthening of masonry structures using epoxy-bonded FRP laminates.” J. Compos. Constr., 2(2), 96–104.
Triantafillou, T. C., and Fardis, M. N. (1997). “Strengthening of historic masonry structures with composite materials.” Mat. and Struct., RILEM, 30(1), 486–496.
Triantafillou, T. C., Papanicolaou, C. G., Zissimopoulos, P., and Laourdekis, T. (2006). “Concrete confinement with textile-reinforced mortar jackets.” ACI Struct. J., 103(1), 28–37.
Uniform Building Code (UBC). (1997). “Structural engineering design provisions.” Int. Conf. of Building Officials, Vol. 2, Whittier, CA.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Nov 25, 2009
Accepted: May 7, 2010
Published online: May 13, 2010
Published in print: Nov 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.