Road Roughness Limit Values Based on Measured Vehicle Vibration
Publication: Journal of Infrastructure Systems
Volume 23, Issue 2
Abstract
This study identified longitudinal road roughness limit values based on measured vibration induced in a road-vehicle-driver interaction system. The relations between measured vehicle vibration response and the international roughness index (IRI) were summarized. Frequency-weighted acceleration on the seat and dynamic load coefficient (DLC) were used to quantify ride comfort, ride safety, and the dynamic load of the vehicle and road. Linear relationship coefficients were identified or taken from references. The expected large range of vibration response root mean square (RMS) values was observed for the same level of IRI. IRI limit values were derived for chosen threshold values of vehicle vibration response as a function of vehicle velocity. Velocity-related IRI limit curves were proposed based on the fitting of IRI limit values lower envelope. IRI limit curves were compared with threshold proposals of other authors and width thresholds used in road maintenance. Some of the estimated IRI limit curves for DLC response were below thresholds used for road maintenance.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the VEGA Grant Agency of Slovak Academy of Sciences under Grant 02/0089/16.
References
Ahlin, K., Granlund, J., and Lundström, R. (2000). “Whole-body vibration when riding on rough roads—A shocking study.”, Swedish Road Administration, Borlange, Sweden, 81.
ASTM. (2003). “Standard practice for computing International Roughness Index of roads from longitudinal profile measurements.” ASTM E1926-98: 2003, West Conshohocken, PA.
Blanksby, C., Germanchev, A., Ritzinger, A., Elischer, M., and George, R. (2009). “Measuring heavy vehicle wheel loads dynamically.”, Austroads, Sydney, NSW, Australia.
Cantisani, G., and Loprencipe, G. (2010). “Road roughness and whole body vibration: Evaluation tools and comfort limits.” J. Transp. Eng., 818–826.
Cebon, D. (1999). Handbook of vehicle-road interaction, Swets&Zeitlinger, Lisse, Netherlands.
CEN (European Committee for Standardization). (2015). “Road and airfield surface characteristics—Test methods. Part 5: Determination of longitudinal unevenness indices.”, Brussels, Belgium.
Chen, Y., He, J., King, M., Chen, W., and Zhang, W. (2013). “Effect of driving conditions and suspension parameters on dynamic load-sharing of longitudinal-connected air suspensions.” Sci. China Technol. Sci., 56(3), 666–676.
ČSN. (2015). “Měření a hodnocení nerovnosti povrchů vozovek [Measurement and evaluation of road surface unevenness].” ČSN 73 6175, Czech Office for Standards, Metrology and Testing, Prague, Czech Republic (in Czech).
Dahlstedt, S. (2003). “Smooth enough? Estimated roughness on roads with low international roughness index.” Transp. Res. Rec., 1860, 144–151.
Elischer, M., Trevorrow, N., Callaway, L., and Blanksby, C. (2012). “Measuring and analysis of dynamic wheel loads.”, Austroads, Sydney, NSW, Australia.
Fichera, G., Scionti, M., and Garescì, F. (2007). “Experimental correlation between the road roughness and the comfort perceived in bus cabins.”, SAE International, Warrendale, PA.
Finnish Road Administration Professional Services. (2007). “Manual of the road surface condition measurement (Käsikirja tien pinnan kunnon mittaamisesta).” Helsinki, Finland, 55 (in Finnish).
General Directorate of Public Roads and Bureau of Road Network Studies. (2002). “Pavement condition evaluation system SOSN–Annex B, Measurement principles and assessment of longitudinal road evenness of asphalt pavements in Pavement Maintenance System SOSN (System oceny stanu nawierzchni SOSN wytyczne stosowania—Załącznik B, Zasady pomiaru i oceny stanu równości podłużnej nawierzchni bitumicznych w systemie oceny stanu nawierzchni SOSN).” Warszava, Poland (in Polish).
Granlund, J. (2012). “Ride vibration and road condition.” 〈http://www.roadex.org/wp-content/uploads/2014/01/11.-Ride-vibration-and-road-condition-J-Granlund.pdf〉 (May 14, 2015).
Griffin, M. J. (2007). “Discomfort from feeling vehicle vibration.” Veh. Syst. Dyn., 45(7–8), 679–698.
Hassan, R. A., and McManus, K. (2003). “Assessment of interaction between road roughness and heavy vehicles.” Transp. Res. Rec., 1819, 236–243.
Ihs, A., Grudemo, S., and Wiklund, M. (2004). “The influence of road surface condition on driving comfort.”, Swedish National Road and Transport Research Institute, Linköping, Sweden, 131 (in Swedish).
ISO. (1995). “Mechanical vibration—Road surface profiles—Reporting of measured data.” ISO 8608, Geneva.
ISO. (1997). “Mechanical vibration and shock—Evaluation of human response to whole-body vibration. Part I: General requirements.” ISO 2631-1, Geneva.
Jacob, B., and Dolcemascolo, V. (1998). “Dynamic interaction between instrumented vehicles and pavements.” Proc., 5th Int. Symp. on Heavy Vehicle Weights and Dimensions, ARRB Group Limited, Vermont South, VIC, 142–160.
Kropáč, O., and Múčka, P. (2005). “Be careful when using the international roughness index as an indicator of road unevenness.” J Sound Vib., 287(4–5), 989–1003.
Kropáč, O., and Múčka, P. (2008). “Indicators of longitudinal unevenness of roads in the USA.” Int. J. Veh. Des., 46(4), 393–415.
Kulakowski, B. T., Streit, D. A., Wollyung, R. J., and Kenis, W. J. (1995). “A study of dynamic wheel loads conducted using a four-post road simulator.” Proc., 4th Int. Symp. on Heavy Vehicle Weights and Dimensions, Transportation Research Institute, Univ. of Michigan, Ann Arbor, MI, 301–307.
Magnusson, G., Dahlstedt, S., and Sjögren, L. (2002). “Measurements of the road surface longitudinal unevenness–Methods and necessary accuracy.”, Swedish National Road and Transport Institute, Sweden, 94 (in Swedish).
MATLAB version 7.3.0 [Computer software]. MathWorks, Natick, MI.
Merritt, D. K., Chang, G. K., and Rutledge, J. L. (2015). “Best practices for achieving and measuring pavement smoothness: A synthesis of state-of-practice.”, Transtec Group, Inc., Austin, TX, 58.
Mogilny, K. V., Lushnikov, N. A., and Krasikov, O. A. (2013). “Meždunarodnyj indeks rovnosti dorožnyh pokrytij i ego ispoľzovanie v stranah tamožennogo sojuza [International roughness index and its use in countries of the Customs Union].” Dorogi i mosty, 29(1), 92–110 (in Russian).
Múčka, P. (2013). “Correlation among road unevenness indicators and vehicle vibration response.” J. Transp. Eng., 771–786.
Múčka, P., and Granlund, J. (2012). “Comparison of longitudinal unevenness of old and repaired highway lanes.” J. Transp. Eng., 371–380.
Papagiannakis, A. T., Gharaibeh, N., Weissmann, J., and Wimsatt, A. (2009). “Pavement scores synthesis.”, Texas Transportation Institute, College Station, TX, 152.
Papagiannakis, A. T., Haas, R. C. G., Woodrooffe, J. H. F., and LeBlanc, P. (1988). “Effects of dynamic load on flexible pavements.” Transp. Res. Rec., 1207, 187–196.
Perera, R. W., Kohn, S. D., and Byrum, C. R. (2009). “Smoothness criteria for concrete pavements.”, Federal Highway Administration, Washington, DC.
Santagata, E., and Sciamanna, S. (2014). “Development of a new response-type road roughness measuring system.” Proc., 3rd Int. Conf. on Transportation Infrastructure—Sustainability, Eco-Efficiency and Conservation in Transportation Infrastructure Asset Management, ICTI 2014, CRC Press, Boca Raton, FL, 711–717.
Sayers, M. W., Gillespie, T. D., and Paterson, W. D. O. (1986). Guidelines for conducting and calibrating road roughness measurements, The World Bank, Washington, DC.
Sayers, M. W., and Karamihas, S. M. (1998). The little book of profiling, Transportation Research Institute, Univ. of Michigan, Ann Arbor, MI, 102.
Sun, L., Zhang, Z., and Ruth, J. (2001). “Modeling indirect statistics of surface roughness.” J. Transp. Eng., 105–111.
Tehrani, S. S., Falls, L. C., and Mesher, D. (2015). “Road users’ perception of roughness and the corresponding IRI threshold values.” Can. J. Civ. Eng., 42(4), 233–240.
The European Parliament and the Council of the European Union. (2002). “On the minimum health and safety requirements regarding the exposure of workers to the risks arising from physical agents (vibration).” Official Journal of the European Communities, Brussels, Belgium.
The Transtec Group. (2012). “Smoothness specifications online.” 〈http://www.smoothpavements.com〉 (Jan. 20, 2015).
TP. (2012). “Meranie a hodnotenie nerovnosti vozoviek pomocou zariadenia Profilograph GE (Measurement and evaluation of road unevenness by profilograph GE).” TP 04/2012, Ministry of Transport, Construction and Regional Development of the Slovak Republic, Bratislava, Slovak Republic (in Slovak).
Trafikverktet. (2012). “Paved road maintenance standard in 2011 (Underhallsstandard belagd väg 2011).”, Borlänge, Sweden (in Swedish).
Wang, F., and Easa, S. (2016). “Analytical evaluation of ride comfort on asphalt concrete pavements.” J. Test. Eval., 44(4), in press.
Wang, S., Zhang, J., and Yang, Z. (2010). “Experiment on asphalt pavement roughness evaluation based on passengers’ physiological and psychological reaction.” Proc., 10th Int. Conf. of Chinese Transportation Professionals (ICCTP) 2010: Integrated Transportation Systems: Green, Intelligent, Reliable, H. Wei, Y. Wang, J. Rong, and J. Weng, eds., ASCE, Reston, VA, 3852–3863.
Yu, J., Chou, E. Y. J., and Yau, J. T. (2006). “Development of speed-related ride quality thresholds using international roughness index.” Transp. Res. Rec., 1974, 47–53.
Zhang, J., Du, Y., and Su, R. (2011). “Investigating the relationship between pavement roughness and heart-rate variability by road driving test.” Proc., 3rd Int. Conf. on Road Safety and Simulation, Transport Research Board, Washington, DC.
Žuraulis, V., Pečeliūnas, R., and Jakutis, G. (2014). “Semi-active suspension influence on comfort sensation of a vehicle occupant.” Agric. Eng., 46(1), 116–124.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Jul 23, 2015
Accepted: May 24, 2016
Published online: Jul 18, 2016
Discussion open until: Dec 18, 2016
Published in print: Jun 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.