Buried Lifting Sprinkling Irrigation Device
Publication: Journal of Irrigation and Drainage Engineering
Volume 144, Issue 1
Abstract
Sprinkler irrigation is widely used in agricultural irrigation as an important component of conserving water. Traditional fixed-sprinkler irrigation systems interfere with farming operations. To address this shortcoming, a novel self-extending sprinkler irrigation device was developed that resides beneath the tillage layer during cultivation and harvesting. When pressurized water flows into the buried sprinkler, the sprinkler begins to rotate and release water at its ejection point. With the increase in moisture content, the soil shear strength is significantly reduced until it is effectively zero, resulting in the sprinkler rising above the ground surface for irrigation. The sprinkler can retract below the tillage layer under atmospheric pressure after irrigation, and no equipment remains exposed. No manual installation or removal of equipment is required during the sprinkler’s operation, which greatly reduces the labor associated with the current fixed-sprinkler irrigation systems. An analysis of the ground-breaking capacity and retraction capability of the novel sprinkler device revealed that it can rise above the ground surface for sprinkling and retract in most cases. The results of this demonstration project showed that the device is convenient to use, durable, and cost-effective for agricultural irrigation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Key Research and Development Plan (2016YFC0400104) and the Youth Innovation Promotion Association CAS (2017477).
References
Ayars, J. E., et al. (1999). “Subsurface drip irrigation of row crops: A review of 15 years of research at the Water Management Research Laboratory.” Agric. Water Manage., 42(1), 1–27.
Belder, P., Spiertz, J., Bouman, B., Lu, G., and Tuong, T. P. (2005). “Nitrogen economy and water productivity of lowland rice under water-saving irrigation.” Field Crop. Res., 93(2), 169–185.
Bishop, A. W., Alpan, I., Blight, G. E., and Donald, I. B. (1960). “Factors controlling the strength of partly saturated cohesive soils.” Conf. on Shear Strength Cohesive Soils, ASCE, New York, 503–532.
Braz-Tangerino, F., et al. (2014). “Visión del regadío.” Ingeniería del Agua, 18(1), 39–53 (in Spanish).
Cheng, H. H. (2003). “Investigation on cohesion for the fine-grained saturation soil in the city of Shantou.” GZ. Arch., 6, 6–9 (in Chinese).
Chinese Standards. (2007). “Technical specification for sprinkler irrigation.” GB/T50085-2007, Beijing.
Clemmens, A. J. (2000). Measuring and improving irrigation system performance at the field level, Irrigation Association of Australia, Melbourne, Australia, 190–199.
Falkenmark, M., Lundqvist, J., and Widstrand, C. (1989). “Macro-scale water scarcity requires micro-scale approaches: Aspects of vulnerability in semi-arid development.” Nat. Resour. Forum, 13(4), 258–267.
Falkenmark, M., and Molden, D. (2008). “Wake up to realities of river basin closure.” Water Resour. Dev., 24(2), 201–215.
Falkenmark, M., and Rockström, J. (2010). “Building water resilience in the face of global change: From a blue-only to a green-blue water approach to land-water management.” J. Water Resour. Plann. Manage., 606–610.
Fedoroff, N. V., et al. (2010). “Radically rethinking agriculture for the 21st century.” Science, 327(5967), 833–834.
Fredlund, D. G., Morgenstern, N. R., and Widger, R. A. (1978). “The shear strength of unsaturated soils.” Can. Geotech. J., 15(3), 313–321.
Fredlund, D. G., and Rahardjo, H. (1993). Soil mechanics for unsaturated soils, Wiley, New York.
Fredlund, D. G., Xing, A., Fredlund, M. D., and Barbour, S. L. (1996). “The relationship of the unsaturated soil shear to the soil-water characteristic curve.” Can. Geotech. J., 33(3), 440–448.
Han, W., Wu, P., Zhou, L., Liu, W., and Zhang, Y. (2012). “Lateral-pipe layout design in fixed-pipeline sprinkler irrigation systems.” Afr. J. Agric. Res., 7(19), 2978–2982.
Jacinthe, P. A., and Lal, R. (2009). “Tillage effects on carbon sequestration and microbial biomass in reclaimed farmland soils of southwestern Indiana.” Soil Sci. Soc. Am. J., 73(2), 605–613.
Kato, Y., Okami, M., and Katsura, K. (2009). “Yield potential and water use efficiency of aerobic rice (Oryza sativa L.) in Japan.” Field Crop. Res., 113(3), 328–334.
Khan, S., and Hanjra, M. A. (2009). “Footprints of water and energy inputs in food production—Global perspectives.” Food Policy, 34(2), 130–140.
Lambe, T. W., and Whitman, R. V. (2008). Soil mechanics SI version, Wiley, New York.
Merriam, J. L., and Keller, J. (1978). Farm irrigation system evaluation: A guide for management, Dept. of Agriculture Irrigation Engineering, Utah State Univ., Logan, UT.
Mushtaq, S., Dawe, D., Lin, H., and Moya, P. (2006). “An assessment of the role of ponds in the adoption of water-saving irrigation practices in the Zhanghe irrigation system, China.” Agric. Water Manage., 83(1), 100–110.
Pereira, L. S., Oweis, T., and Zairi, A. (2002). “Irrigation management under water scarcity.” Agric. Water Manage., 57(3), 175–206.
Rajak, D., Manjunatha, M. V., Rajkumar, G. R., Hebbara, M., and Minhas, P. S. (2006). “Comparative effects of drip and furrow irrigation on the yield and water productivity of cotton (Gossypium hirsutum L.) in a saline and waterlogged vertisol.” Agric. Water Manage., 83(1), 30–36.
Romero, P., García, J., and Botía, P. (2006). “Cost-benefit analysis of a regulated deficit-irrigated almond orchard under subsurface drip irrigation conditions in southeastern Spain.” Irrig. Sci., 24(3), 175–184.
Shiklomanov, I. A. (2000). “Appraisal and assessment of world water resources.” Water Int., 25(1), 11–32.
Tejero, I. G., Zuazo, V. H. D., Bocanegra, J. A. J., and Fernández, J. L. M. (2011). “Improved water-use efficiency by deficit-irrigation programmes: Implications for saving water in citrus orchards.” Sci. Hortic-Amsterdam, 128(3), 274–282.
Terzaghi, K., Peck, R. B., and Mesri, G. (1996). Soil mechanics in engineering practice, 3rd Ed., Wiley, New York.
Tuong, P., Bouman, B., and Mortimer, M. (2015). “More rice, less water-integrated approaches for increasing water productivity in irrigated rice-based systems in Asia.” Plant Prod. Sci., 8(3), 231–241.
Whitlow, R. (1990). Basic soil mechanics, 2nd Ed., Longman Scientific & Technical, Harlow, U.K.
Yohannes, F., and Tadesse, T. (1998). “Effect of drip and furrow irrigation and plant spacing on yield of tomato at Dire Dawa, Ethiopia.” Agric. Water Manage., 35(3), 201–207.
Zapata, N., Playán, E., Skhiri, A., and Burguete, J. (2009). “Simulation of a collective solid-set sprinkler irrigation controller for optimum water productivity.” J. Irrig. Drain. Eng., 13–24.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Mar 15, 2017
Accepted: Jul 21, 2017
Published online: Nov 8, 2017
Published in print: Jan 1, 2018
Discussion open until: Apr 8, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.