Flow Rate Measurements under Sluice Gates
Publication: Journal of Irrigation and Drainage Engineering
Volume 143, Issue 6
Abstract
Sluice gates are commonly used in canals for control and measurement of the flow. The discharge under sluice gates can be determined through the energy-momentum method (EM), the orifice flow rate equations and the application of the -theorem of the dimensional analysis. The different discharge methods available, for free and submerged hydraulic jump including the transition between flows, were compared with experimental data. The performance of the different calibration methods was analyzed. The test program was conducted in the laboratory flume and in the experimental irrigation canal of the University of Évora, Portugal. The test program shows that the evaluation of the discharge under sluice gates for free and submerged flows and for the transition between both flows through the methods based in the EM were those who had better results. For the studied gates openings, the results also show that the methods that consider the division of the submerged flow in partial and totally submerged did not improve the discharge results.
Get full access to this article
View all available purchase options and get full access to this article.
References
Almeida, M., Figueiredo, J., and Rijo, M. (2002). “SCADA configuration and control modes implementation on an experimental water supply canal.” Proc., 10th IEEE Mediterranean Conf. on Control and Automation (MED2002), Campus of the Instituto Superior Técnico, Lisbon, Portugal.
Ansar, M. (2001). “Discussion of ‘Simultaneous flow over and under a gate’.” J. Irrig. Drain. Eng., 325–328.
Baume, J. P., Malaterre, P. O., Gilles, B., and Benoit, L. G. (2005). “SIC: A 1D hydrodynamic model for river and irrigation canal modelling and regulation.” Métodos Numéricos em Recursos Hídricos, Associação Brasileira de Recursos Hídricos, Brazil.
Belaud, G., Cassan, L., and Baume, J. P. (2009). “Calculation of contraction coefficient under sluice gates and application to discharge measurement.” J. Hydraul. Eng., 1086–1091.
Bijankhan, M., Ferro, V., and Kouchakzadeh, S. (2012). “New stage-discharge relationships for free and submerged sluice gates.” Flow Meas. Instrum., 28, 50–56.
Bijankhan, M., and Kouchakzadeh, S. (2011). “Discussion of ‘Benchmark of discharge calibration methods for submerged sluice gates’ by Carlos Sepúlveda, Manuel Gómez, and José Rodellar.” J. Irrig. Drain. Eng., 56–57.
Bos, M. G. (1989). “Discharge measurement structures.” International Institute for Land Reclamation and Improvement, Wageningen, Netherlands.
Brunner, G. W. (2016). “HEC-RAS, river analysis system hydraulic reference manual—Version 5.0.” U.S. Army Corps of Engineers, Hydrologic Engineering Center, Davis, CA.
Chow, V. T. (1959). Open-channel hydraulic, McGraw-Hill, New York.
Clemmens, A. J., Strelkoff, T. S., and Replogle, J. A. (2003). “Calibration of submerged radial gates.” J. Hydraul. Eng., 680–687.
Clemmens, A. J., Wahl, T. L., Bos, M. G., and Replogle, J. A. (2001). “Water measurement with flumes and weirs.” International Institute for Land Reclamation and Improvement, Wageningen, Netherlands.
Cunge, J. A., and Woolhiser, D. A. (1975). Irrigation systems, Water Resources Publications, Fort Collins, CO.
Duarte, J., Rato, L., Shirley, P., and Rijo, M. (2011). “Multi-platform controller interface for SCADA application.” 18th Int. Federation of Automatic Control World Congress, Milano, Italy, 7885–7890.
Erbisti, P. C. F. (2014). Design of hydraulic gates, CRC Press, Boca Raton, FL.
Ferro, V. (2000). “Simultaneous flow over and under a gate.” J. Irrig. Drain. Eng., 190–193.
Ferro, V. (2001). “Closure to ‘Simultaneous flow over and under a gate’.” J. Irrig. Drain. Eng., 325–328.
Habibzadeh, A., Vatankhah, A. R., and Rajaratnam, N. (2011). “Role of energy loss on discharge characteristics of sluice gates.” J. Hydraul. Eng., 1079–1084.
HEC-RAS version 5.0 [Computer software]. U.S. Army Corps of Engineers, Institute for Water Resources, Davis, CA.
Henderson, F. M. (1966). Open channel flow, Macmillan, New York.
Henry, H. R. (1950). “Discussion to ‘Diffusion of submerged jets.’ by M. L. Albertson, Y. B. Dai, R. A. Jensen and H. Rouse.” Trans. ASCE, 115, 687–694.
Lencastre, A. (1983). Hidráulica Geral [General hydraulics], Edição Luso-Brasileira, Lisbon, Portugal (in Portuguese).
Lewin, J. (1995). Hydraulic gates and valves in free surface flow and submerged outlets, Thomas Telford, London.
Lin, C. H., Yen, J. F., and Tsai, C. T. (2002). “Influence of sluice gate contraction coefficient on distinguishing condition.” J. Irrig. Drain. Eng., 249–252.
MATLAB [Computer software]. MathWorks, Natick, MA.
Montes, J. S. (1997). “Irrotational flow and real fluid effects under planar sluice gates.” J. Hydraul. Eng., 219–232.
NuHCC (Hydraulic and Canal Control Centre). (2016). “Experimental irrigation canal of the hydraulics and canal control centre of the University of Évora, Portugal.” ⟨http://canais.nuhcc.uevora.pt/⟩ (Mar. 14, 2016).
Rajaratnam, N., and Subramanya, K. (1967). “Flow equation for the sluice gate.” J. Irrig. Drain. Eng., 93(IR3), 167–186.
Raju, K. G. R. (1981). Flow through open channels, TATA McGraw-Hill Publishing Company Limited, New Delhi, India.
Rijo, M. (2003). “Local automatic control modes in an experimental irrigation canal.” Irrig. Drain. Syst., 17(3), 179–193.
Roth, A., and Hager, W. H. (1999). “Underflow of standard sluice gate.” Exp. Fluids, 27(4), 339–350.
Sepúlveda, C. (2007). “Instrumentation, model identification and control of an experimental irrigation canal.” Ph.D. thesis, Technical Univ. of Catalonia, Barcelona, Spain.
Sepúlveda, C., Gómez, M., and Rodellar, J. (2009). “Benchmark of discharge calibration methods for submerged sluice gates.” J. Irrig. Drain. Eng., 676–682.
SIC version 4.22 [Computer software]. Cemagref, France.
Swamee, P. K. (1992). “Sluice-gate discharge equations.” J. Irrig. Drain. Eng., 56–60.
Yen, J. F., Lin, C. H., and Tsai, C. T. (2001). “Hydraulic characteristics and discharge control of sluice gates.” J. Chin. Inst. Eng., 24(3), 301–310.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jun 13, 2016
Accepted: Nov 28, 2016
Published online: Feb 7, 2017
Published in print: Jun 1, 2017
Discussion open until: Jul 7, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.