Calculating Discharge from Culverts under Inlet Control Using Stage at the Inlet
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Irrigation and Drainage Engineering
Volume 140, Issue 2
Abstract
Discharge through circular culverts under inlet control can be calculated using several empirical and theoretical methods; however, most methods require knowledge of site-specific characteristics, and some may even require that a rating curve be developed for each individual culvert. This process is onerous and often too time-consuming for land managers. The objective of this study was to identify a simple and accurate method to determine discharge at culverts. In this study, discharge at culverts was measured in forested watersheds using trapezoidal flumes and salt tracer tests and compared to discharge estimated using theoretical and empirically derived equations. The equation that best estimated culvert discharge was determined. This equation requires two variables: the diameter of the culvert and the height of the water at the culvert inlet. While this study used capacitance devices to measure and record stage at the culvert inlet, simple staff gauges or crest gauges could be used to measure water height adequately and subsequently calculate discharge from culverts.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was conducted with the financial support of the National Council for Air and Stream Improvement and the Center for Wood Utilization.
References
Chanson, H. (1999). The hydraulics of open channel flow, an introduction, Edward Arnold Publishers, London.
Dasika, B. (1995). “New approach to design of culverts.” J. Irrig. Drain. Eng., 261–264.
French, J. L. (1955). “First progress report on hydraulics of culverts: Hydraulic characteristics of commonly used pipe entrances.”, National Bureau of Standards, Washington, DC.
Henderson, F. M. (1966). Open channel flow, Macmillan, New York.
Hudson, R., and Fraser, J. (2005). “Introduction to salt dilution gauging for streamflow measurement. Part IV: The mass balance (or dry injection) method.” Streamline Watershed Manage. Bull., 9(1), 6–12.
Moore, R. D. (2005). “Slug injection using salt in solution.” Streamline Watershed Manage. Bull., 8(2), 1–6.
Normann, J. M., Houghtalen, R. J., and Johnston, W. J. (2005). “Hydraulic design of highway culverts.” Hydraulic design series no. 5 (HDS-5), 2nd Ed., Federal Highway Administration, Norfolk, VA.
Rantz, S. E. (1982). “Measurement and computation of streamflow: Volume 1. Measurement of stage and discharge.”, U.S. Dept. of the Interior, Geological Survey, Washington, DC.
Robinson, A. R., and Chamberlain, A. R. (1960). “Trapezoidal flumes for open-channel flow measurement.” Trans. ASAE, 3(2), 120–128.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 19, 2012
Accepted: Jul 5, 2013
Published online: Jul 8, 2013
Published in print: Feb 1, 2014
Discussion open until: Mar 10, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.