Experiments on Discharge Equations of Compound Broad-Crested Weirs
Publication: Journal of Irrigation and Drainage Engineering
Volume 135, Issue 4
Abstract
A linear combination of traditional discharge equations for simple rectangular and/or triangular weirs is proposed to describe the discharge equations of compound broad-crested (CBC) weirs. The CBC weirs are composed of rectangular, triangular, and/or truncated triangular weirs. Dimensionless discharge equations have been also derived. Laboratory experiments on discharge relations for flows over four CBC weirs were conducted in this study in order to calibrate the proposed discharge equations. The experiments were carried out under the conditions of the -ratio of water heads above upper and lower crests less than 0.54, and a dimensionless discharge less than 2.174. The result shows that the differences between the calculated discharges by the proposed equations and the measured ones are less than 3% for flows over these CBC weirs under the present experimental conditions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Experiments were conducted at the Institute of Planning and Hydraulic Research, Water Resources Agency, Ministry of Economic Affairs in Taiwan. The partial support from the National Science Council in Taiwan (No. UNSPECIFIED96-2625-Z-006-014) to C.-D. J. is also acknowledged.
References
Boiten, W., and Pitlo, H. R. (1982). “The -shape broad-crested weir.” J. Irrig. and Drain. Div., 108(2), 142–160.
Bos, M. G. (1976). Discharge measurement structures, International Institute for Land Reclamation and Improvement, Wagemingen, The Netherlands.
Chow, V. T. (1959). Open-channel hydraulics, McGraw-Hill, New York.
French, R. H. (1986). Open-channel hydraulics, McGraw-Hill, New York.
Göğüs, M., Define, Z., and Özkandemir, V. (2006). “Broad-crested weirs with rectangular compound cross sections.” J. Irrig. and Drain. Eng., 132(3), 272–280.
Hager, W. H., and Schwalt, M. (1994). “Broad-crested weir.” J. Irrig. and Drain. Eng., 120(1), 13–25.
Henderson, F. M. (2006). Open channel flow, Macmillan, New York.
Jan, C. D., Chang, C. J., and Lee, M. H. (2006). “Discussion of ‘Design and calibration of compound sharp-crested weir’ by J. Martinez et al.” J. Hydraul. Eng., 132(8), 868–871.
Nato, D., Nezu, I., and Nakagawa, A. (1993). “Hydrodynamic behavior of compound rectangular open channel.” J. Hydraul. Eng., 119(3), 390–408.
Martinez, J., Reca, J., Morillas, M. T., and López, J. G. (2005). “Design and calibration of a compound sharp-crested weir.” J. Hydraul. Eng., 131(2), 112–116.
Ramamurty, A. S., Udoyara, S. T., and Rao, M. V. J. (1988). “Characteristic of square-edged and round-nosed broad-crested weirs.” J. Irrig. and Drain. Eng., 114(1), 61–73.
Ranga Raju, K. G. (1993). Flow through open channel, McGraw-Hill, New York.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Jan 2, 2008
Accepted: Nov 8, 2008
Published online: Jan 26, 2009
Published in print: Aug 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.