Abstract
A newly developed and validated numerical model that accounts for the coupled hydro-bio-mechanical processes in municipal solid waste (MSW) landfills, was employed to assess influence of various field conditions and system variables on the performance of bioreactor landfills. The numerical model integrates a hydraulic two-phase flow model which assumes landfill leachate and gas as two immiscible phases, a mechanical model based on plain-strain formulation of Mohr-Coulomb constitutive law, and a first-order decay biodegradation model for modeling coupled hydro-bio-mechanical processes in bioreactor landfills. The influence of typical field conditions and system variables, namely, the landfill slope configuration, geometric configuration of the leachate recirculation system, and the mode of leachate injection on the bioreactor landfill performance were evaluated. The bioreactor landfill performance was investigated with regards to hydraulic behavior (e.g., moisture distribution, waste saturation, pore water and capillary pressures), extent of biodegradation and mechanical response (e.g., slope stability, landfill settlement, in-plane shear behavior of composite liner system) during the operation of leachate injection. Overall, this parametric study concluded that various field conditions and system variables significantly influence the performance of bioreactor landfills. Therefore, these system variables must be properly accounted for when optimizing the performance of bioreactor landfills undergoing coupled hydro-bio-mechanical processes during the leachate injection operations.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This project is funded by the U.S. National Science Foundation (Grant CMMI # 1537514), which is gratefully acknowledged.
References
Barlaz, M. A., Schaefer, D. M., and Ham, R. K. (1989). “Bacterial population development and chemical characteristics of refuse decomposition in a simulated sanitary landfill.” Appl. Environ. Microbiol., 55(1), 55–65.
Breitmeyer, R. J., and Benson, C. H. (2011). “Measurement of unsaturated hydraulic properties of municipal solid waste.” Proc., Geo-Frontier 2011 Geotechnical Special Publication No. 211, J. Han and D. Alazamora, eds., ASCE, Reston, VA, 1433–1442.
Chen, Y. M., Xu, X. B., and Zhan, L. T. (2012). “Analysis of solid-liquid-gas interactions in landfilled municipal solid waste by a bio-hydro-mechanical coupled model.” Sci. China Tech. Sci., 55(1), 81–89.
El-Fadel, M., and Khoury, R. (2000). “Modeling settlement in MSW landfills: A critical review.” Crit. Rev. Environ. Sci. Technol., 30(3), 327–361.
Faour, A. A., Reinhart, D. R., and You, H. (2007). “First-order kinetic gas generation model parameters for wet landfills.” Waste Manage., 27(7), 946–953.
FLAC version 7.0 [Computer software]. Itasca Consulting Group, Inc., Minneapolis.
Giri, R. K., and Reddy, K. R. (2014a). “Design charts for selecting minimum setback distance from side slope to horizontal trench system in bioreactor landfills.” Geotech. Geol. Eng., 32(4), 1017–1027.
Giri, R. K., and Reddy, K. R. (2014b). “Slope stability of bioreactor landfills during leachate injection: Effects of geometric configurations of horizontal trench systems.” Geomech. Geoeng., 10(2), 126–138.
Haydar, M. M., and Khire, M. V. (2005). “Leachate recirculation using horizontal trenches in bioreactor landfills.” J. Geotech. Geoenviron. Eng., 837–847.
Hettiarachchi, C. H., Meegoda, J. N., and Hettiarachchi, P. (2009). “Effect of gas and moisture on modeling of bioreactor landfill settlement.” Waste Manage., 29(3), 1018–1025.
ITRC (Interstate Technology and Regulatory Council). (2006). Characterization, design, construction and monitoring of bioreactor landfills, Washington, DC.
Jain, P., Townsend, T. G., and Tolaymat, T. H. (2010). “Steady-state design of horizontal systems for liquids addition at bioreactor landfills.” Waste Manage., 30(12), 2560–2569.
Jones, D. R. V., and Dixon, N. (2005). “Landfill lining stability and integrity: The role of waste settlement.” Geotext. Geomembr., 23(1), 27–53.
Matasović, N., and Kavazanjian, E., Jr. (1998). “Cyclic characterization of OII landfill solid waste.” J. Geotech. Geoenviron. Eng., 197–210.
McDougall, J. R. (2007). “A hydro-bio-mechanical model for settlement and other behaviour in landfilled waste.” J. Comput. Geotech., 34(4), 229–246.
Reddy, K. R., Hettiarachchi, H., Parakalla, N., Gangathulasi, J., Bogner, J., and Lagier, T. (2009). “Hydraulic conductivity of MSW in landfills.” J. Environ. Eng., 677–683.
Reddy, K. R., Kosgi, S., and Motan, E. S. (1996). “Interface shear behavior of landfill composite liner systems: A finite element analysis.” Geosynthetics Int., 3(2), 247–275.
Reddy, K. R., Kumar, G., and Giri, R. K. (2017a). “Influence of dynamic coupled hydro-bio-mechanical processes on response of municipal solid waste and liner system in bioreactor landfills.” Waste Manage., 63, 143–160.
Reddy, K. R., Kumar, G., and Giri, R. K. (2017b). “Modeling coupled processes in municipal solid waste landfills: An overview with key engineering challenges.” Int. J. Geosynthetics Ground Eng., 3(1), 6.
Reddy, K. R., Kumar, G., and Giri, R. K. (2017c). “Numerical modeling of the shear response of a composite liner system with municipal solid waste degradation in landfills.” Geotechnical Frontiers 2017 (GSP 276), T. L. Brandon and R. J. Valentine, eds., ASCE, Reston, VA, 52–63.
Reddy, K. R., Motan, E. S., and Oliver, C. (1999). “Parametric seismic evaluation of landfill liner and final cover slopes.” J. Solid Waste Technol. Manage., 26(1), 1–9.
Reinhart, D. R., and Townsend, T. G. (1997). Landfill bioreactor design and operation, Lewis Publishers, Washington, DC.
Richards, L. A. (1931). “Capillary conduction of liquids through porous mediums.” J. Appl. Phys., 1(5), 318–333.
Sharma, H. D., and Reddy, K. R. (2004). Geoenvironmental engineering: Site remediation, waste containment, and emerging waste management technologies, Wiley, Hoboken, NJ.
Sia, A. H. I., and Dixon, N. (2012). “Numerical modelling of landfill lining system-waste interaction: Implications of parameter variability.” Geosynthetics Int., 19(5), 393–408.
Sowers, G. F. (1973). “Settlement of waste disposal fills.” Proc., 8th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 2, USSR, Moscow, 207–210.
USEPA (U.S. Environmental Protection Agency). (1994). The hydrologic evaluation of landfill performance (HELP) model: User’s guide for version 3, Washington, DC.
van Genuchten, M. T. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
Wasti, Y., and Özdüzgün, Z. B. (2001). “Geomembrane-geotextile interface shear properties as determined by inclined board and direct shear box tests.” Geotext. Geomembr., 19(1), 45–57.
Xu, Q., Tolaymat, T., and Townsend, T. G. (2012). “Impact of pressurized liquids addition on landfill slope stability.” J. Geotech. Geoenviron. Eng., 472–480.
Yesiller, N., Hanson, J. L., Cox, J. T., and Noce, D. E. (2014). “Determination of specific gravity of municipal solid waste.” Waste Manage., 34(5), 848–858.
Zekkos, D., Bray, J., Kavazanjian, E., Matasovic, N., Ratje, E., Riemer, M., and Stokoe, K. (2006). “Unit weight of municipal solid waste.” J. Geotech. Geoenviron. Eng., 1250–1261.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Oct 11, 2016
Accepted: Jun 26, 2017
Published online: Nov 7, 2017
Published in print: Jan 1, 2018
Discussion open until: Apr 7, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.