Modal Analysis of Turbulent Flow near an Inclined Bank–Longitudinal Structure Junction
Publication: Journal of Hydraulic Engineering
Volume 147, Issue 3
Abstract
The present study examines the effect of upstream channel bank angle on the turbulent flow characteristics and the underlying coherent structures associated with the development of local scour in the vicinity of the leading edge of a longitudinal structure. Three laboratory experiments with channel bank angles of 28°, 45°, and 65° were carried out. Flow measurements were obtained employing a stereoscopic particle image velocimetry (SPIV) system. The characteristics of underlying energetic flow features in each of the experiments were investigated by using the proper orthogonal decomposition (POD) and optimized dynamic mode decomposition (optDMD) techniques. The SPIV results indicated that for a moderate bank slope , the horseshoe vortex (HV) amplifies turbulent kinetic energy and, consistently, bed shear stresses that consequently contribute to the local scour development. As the channel bank angle increases, and thus the degree of flow obstruction decreases, the intensity of HV declines and eventually diminishes for . Thus, the erosional capacity of the flow is reduced. The modal analyses specified that with the increase of channel bank angle, the flow energy is distributed among a larger number of POD modes and the similarity between the POD and DMD modes decreases. The relatively low energy content of the POD and DMD modes suggests the aperiodic behavior of the main necklace vortex and verifies the significant reduction in its coherency with the channel bank slope.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The support of the National Cooperative Highway Research Program (Grant No. NCHRP-HR 24–36) for this study is gratefully acknowledged. The authors are also grateful for discussions with Travis Askham. JNK acknowledges support from the Air Force Office of Scientific Research (AFOSR) Grant No. FA9550-17-1-0329.
References
Adrian, R. J., and J. Westerweel. 2011. Particle image velocimetry. Cambridge, UK: Cambridge University Press.
Apsilidis, N., P. Diplas, C. L. Dancey, and P. Bouratsis. 2015. “Time-resolved flow dynamics and Reynolds number effects at a wall-cylinder junction.” J. Fluid Mech. 776: 475–511. https://doi.org/10.1017/jfm.2015.341.
Apsilidis, N., P. Diplas, C. L. Dancey, and P. Bouratsis. 2016. “Effects of wall roughness on turbulent junction flow characteristics.” Exp. Fluids 57 (1): 12. https://doi.org/10.1007/s00348-015-2098-0.
Askham, T., and J. N. Kutz. 2018. “Variable projection methods for an optimized dynamic mode decomposition.” SIAM J. Appl. Dyn. Syst. 17 (1): 380–416. https://doi.org/10.1137/M1124176.
Berkooz, G., P. Holmes, and J. L. Lumley. 1993. “The proper orthogonal decomposition in the analysis of turbulent flows.” Annu. Rev. Fluid Mech. 25 (1): 539–575. https://doi.org/10.1146/annurev.fl.25.010193.002543.
Dawson, S. T., M. S. Hemati, M. O. Williams, and C. W. Rowley. 2016. “Characterizing and correcting for the effect of sensor noise in the dynamic mode decomposition.” Exp. Fluids 57 (3): 1–19. https://doi.org/10.1007/s00348-016-2127-7.
Devenport, W. J., and R. L. Simpson. 1990. “Time-dependent and time-averaged turbulence structure near the nose of a wing-body junction.” J. Fluid Mech. 210 (1): 23–55.
Dey, S., and A. K. Barbhuiya. 2005. “Flow field at a vertical-wall abutment.” J. Hydraul. Eng. 131 (12): 1126–1135. https://doi.org/10.1061/(ASCE)0733-9429(2005)131:12(1126).
Duan, J. G., L. He, X. Fu, and Q. Wang. 2009. “Mean flow and turbulence around experimental spur dike.” Adv. Water Resour. 32 (12): 1717–1725. https://doi.org/10.1016/j.advwatres.2009.09.004.
Eshkevari, S. S., N. Heydari, J. N. Kutz, S. N. Pakzad, P. Diplas, and S. S. Eshkevari. 2019. “Operational vision-based modal identification of structures: A novel framework.” In Proc., 12th Int. Workshop on Structural Health Monitoring. Paris: SAFRAN. https://doi.org/10.12783/shm2019/32502.
Golub, G. H., and V. Pereyra. 1973. “The differentiation of pseudo-inverses and nonlinear least squares problems whose variables separate.” SIAM J. Numer. Anal. 10 (2): 413–432. https://doi.org/10.1137/0710036.
Gutierrez-Castillo, P., and B. Thomases. 2019. “Proper orthogonal decomposition (POD) of the flow dynamics for a viscoelastic fluid in a four-roll mill geometry at the stokes limit.” J. Non-Newtonian Fluid Mech. 264 (Feb): 48–61. https://doi.org/10.1016/j.jnnfm.2018.12.009.
Heydari, N., and P. Diplas. 2020. “Flow dynamics in the vicinity of a gravel embedded vertical retaining wall: Conditions corresponding to the initial stages of local erosion.” Environ. Fluid Mech. 20 (1): 203–225. https://doi.org/10.1007/s10652-019-09715-8.
Higham, J. E., W. Brevis, J. C. Keylock, and A. Safarzadeh. 2017. “Using modal decompositions to explain the sudden expansion of the mixing layer in the wake of a groyne in a shallow flow.” Adv. Water Resour. 107: 451–459. https://doi.org/10.1016/j.advwatres.2017.05.010.
Jeon, J., J. Y. Lee, and S. Kang. 2018. “Experimental investigation of three-dimensional flow structure and turbulent flow mechanisms around a nonsubmerged spur dike with a low length-to-depth ratio.” Water Resour. Res. 54 (5): 3530–3556. https://doi.org/10.1029/2017WR021582.
Katul, G. G., and M. B. Parlange. 1995. “Analysis of land surface heat fluxes using the orthonormal wavelet approach.” Water Resour. Res. 31 (11): 2743–2749. https://doi.org/10.1029/95WR00003.
Khosronejad, A., P. Diplas, D. Angelidis, Z. Zhang, N. Heydari, and F. Sotiropoulos. 2020. “Scour depth prediction at the base of longitudinal walls: A combined experimental, numerical, and field study.” Environ. Fluid Mech. 20 (2): 459–478. https://doi.org/10.1007/s10652-019-09704-x.
Khosronejad, A., J. L. Kozarek, P. Diplas, C. Hill, R. Jha, P. Chatanantavet, N. Heydari, and F. Sotiropoulos. 2018. “Simulation-based optimization of in-stream structures design: Rock vanes.” Environ. Fluid Mech. 18 (3): 695–738. https://doi.org/10.1007/s10652-018-9579-7.
Kirkil, G., S. G. Constantinescu, and R. Ettema. 2005. “The horseshoe vortex system around a circular bridge pier on equilibrium scoured bed.” In Proc., ASCE—EWRI World Water and Environmental Resources Congress: Impacts of Global Climate Change, edited by R. Walton, 1–12. Reston, VA: ASCE.
Koken, M., and G. Constantinescu. 2008. “An investigation of the flow and scour mechanisms around isolated spur dikes in a shallow open channel: 1. Conditions corresponding to the initiation of the erosion and deposition process.” Water Resour. Res. 44 (8): W08406. https://doi.org/10.1029/2007WR006489.
Koopman, B. O. 1931. “Hamiltonian systems and transformation in Hilbert space.” Proc. Natl. Acad. Sci. 17 (5): 315–318. https://doi.org/10.1073/pnas.17.5.315.
Kutz, J. N. 2013. Data-driven modeling & scientific computation: Methods for complex systems & big data. Oxford, UK: Oxford University Press.
Lumley, J. L. 1970. “Toward a turbulent constitutive relation.” J. Fluid Mech. 41 (2): 413–434. https://doi.org/10.1017/S0022112070000678.
Molinas, A., K. Kheireldin, and B. Wu. 1998. “Shear stress around vertical wall abutments.” J. Hydraul. Eng. 124 (8): 822–830. https://doi.org/10.1061/(ASCE)0733-9429(1998)124:8(822).
Nguyen, T., E. Kappes, S. King, Y. Hassan, and V. Ugaz. 2018. “Time-resolved PIV measurements in a low-aspect ratio facility of randomly packed spheres and flow analysis using modal decomposition.” Exp. Fluids 59 (8): 127. https://doi.org/10.1007/s00348-018-2583-3.
Paik, J., and F. Sotiropoulos. 2005. “Coherent structure dynamics upstream of a long rectangular block at the side of a large aspect ratio channel.” Phys. Fluids 17 (11): 115104. https://doi.org/10.1063/1.2130743.
Peltier, Y., S. Erpicum, P. Archambeau, M. Pirtton, and B. Dewals. 2014. “Meandering jets in shallow rectangular reservoirs: Pod analysis and identification of coherent structures.” Exp. Fluids 55 (6): 1740. https://doi.org/10.1007/s00348-014-1740-6.
Pope, S. B. 2001. Turbulent flows. New York: ASME.
Rajaratnam, N., and B. A. Nwachukwu. 1983. “Flow near groin-like structures.” J. Hydraul. Eng. 109 (3): 463–480. https://doi.org/10.1061/(ASCE)0733-9429(1983)109:3(463).
Roussinova, V., A. M. Shinneeb, and R. Balachandar. 2010. “Investigation of fluid structures in a smooth open-channel flow using proper orthogonal decomposition.” J. Hydraul. Eng. 136 (3): 143–154. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000155.
Schmid, P. J. 2010. “Dynamic mode decomposition for numerical and experimental data.” J. Fluid Mech. 656: 5–28. https://doi.org/10.1017/S0022112010001217.
Schmid, P. J., D. Violato, and F. Scarano. 2012. “Decomposition of time-resolved tomographic PIV.” Exp. Fluids 52 (6): 1567–1579. https://doi.org/10.1007/s00348-012-1266-8.
Shields, A. F. 1936. Application of similarity principles and turbulence research to bed-load movement. Pasadena, CA: California Institute of Technology.
Towne, A., O. T. Schmidt, and T. Colonius. 2018. “Spectral proper orthogonal decomposition and its relationship to dynamic mode decomposition and resolvent analysis.” J. Fluid Mech. 847 (6): 821–867. https://doi.org/10.1017/jfm.2018.283.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Jan 10, 2020
Accepted: Sep 25, 2020
Published online: Dec 28, 2020
Published in print: Mar 1, 2021
Discussion open until: May 28, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.