Generalized Flexible Method for Simulating Transient Pipe Network Hydraulics
Publication: Journal of Hydraulic Engineering
Volume 144, Issue 7
Abstract
Characteristic solution methods, namely the method of characteristics (MOC) and wave characteristics method (WCM), are widely used for simulating transient pipe network flows. Because the MOC computes solutions at interior nodes, it features higher spatial resolution, whereas the WCM makes simplifications that yield more efficient computations. Practical analyses require numerical methods that are both accurate and computationally efficient. To benefit from the advantages of the two approaches, a generalized characteristic method (GCM) is developed in this paper by combining a flexible friction approximation with a variable reach scheme. Significantly, computational savings are realized by selectively providing greater accuracy and higher resolution solutions only where needed via more interior reaches and higher order solutions; further, the new method reduces to either of the MOC and WCM, thereby showing their intrinsic similarities. Multiple examples compare and contrast the numerical methods. From these, unsteady friction effects and, more importantly, spatial resolution are shown to be directly affected by the interior reach treatment, thus exposing a limitation for solution methods with too few interior reaches. Overall, the key contribution of this work is a methodology featuring a similar degree of accuracy to the MOC, but with a computational cost better than that of the WCM.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
For their financial support, the authors thank the National Sciences and Engineering Research Council of Canada and FP&P HydraTek. The three anonymous reviewers and associated editor also are thanked for their feedback, review comments, and discussions, each of which contributed to a much improved article.
References
Boyd, G. R., et al. (2004). “Intrusion within a simulated water distribution system due to hydraulic transients. II: Volumetric method and comparison of results.” J. Environ. Eng., 778–783.
Brunone, B., Golia, U. M., and Greco, M. (1991). “Some remarks on the momentum equation for fast transients.” Int. Meeting on Hydraulic Transients with Column Separation, 9th Round Table, International Association for Hydraulic Research, Valencia, Spain, 201–209.
Chaudhry, M. H. (2014). “Transient flow equations.” Chapter 2, Applied hydraulic transients, 3rd Ed., Springer, New York, 35–64.
Chaudhry, M. H., and Hussaini, M. Y. (1985). “Second-order accurate explicit finite difference schemes for waterhammer analysis.” J. Fluid Eng., 107(4), 523–529.
Ebacher, G., Besner, M-C., Lavoie, J., Jung, B. S., Karney, B. W., and Prévost, M. (2011). “Transient modeling of a full-scale distribution system: Comparison with field data.” J. Water Resour. Plann. Manage., 173–182.
Ferrante, M., Brunone, B., and Meniconi, S. (2009). “Leak detection in branched pipe systems coupling wavelet analysis and a Lagrangian model.” J. Water Supply Res., 58(2), 95–106.
Friedman, M., et al. (2004). Verification and control of pressure transients and intrusion in distribution systems, American Water Works Association Research Foundation, Denver.
Holloway, M. B., and Chaudhry, M. H. (1985). “Stability and accuracy of waterhammer analysis.” Adv. Water Resour., 8(3), 121–128.
Huang, Y., Duan, H.-F., Zhao, M., Zhang, Q., Zhao, H., and Zhang, K. (2017). “Transient influence zone based decomposition of water distribution networks for efficient transient analysis.” Water Resour. Manage., 31(6), 1915–1929.
Jung, B. S., Boulos, P. F., and Altman, T. (2011). “Optimal transient network design: A multi-objective approach.” J. AWWA, 103(4), 118–128.
Jung, B. S., Boulos, P. F., and Wood, D. J. (2009). “Effect of pressure-sensitive demand on surge analysis.” J. AWWA, 101(4), 100–111.
Kim, S. (2007). “Impedance matrix method for transient analysis of complicated pipe networks.” J. Hydraul. Res., 45(6), 818–828.
León, A., Ghidaoui, M., Schmidt, A., and García, M. (2008). “Efficient second-order accurate shock-capturing scheme for modeling one- and two-phase water hammer flows.” J. Hydraul. Eng., 970–983.
Liou, C., and Wylie, E. (2014). “Approximation of the friction integral in water hammer equations.” J. Hydraul. Eng., 06014008.
Nault, J. D., Karney, B. W., and Jung, B. S. (2016). “Algebraic water hammer: Global formulation for simulating transient pipe network hydraulics.” World Environmental and Water Resources Congress 2016, EWRI, West Palm Beach, FL, 191–201.
Ramalingam, D., Lingireddy, S., and Wood, D. J. (2009). “Using the WCM for transient modeling of water distribution networks.” J. AWWA, 101(2), 75–89.
Streeter, V. L., and Wylie, E. B. (1967). Hydraulic transients, McGraw-Hill, New York.
Vardy, A. E., and Brown, J. M. B. (1996). “On turbulent, unsteady, smooth-pipe flow.” Proc., Int. Conf. on Pressure Surges and Fluid Transients, BHR Group, Harrogate, U.K., 289–311.
Vítkovský, J. P., Bergant, A., Simpson, A. R., and Lambert, M. F. (2006). “Systematic evaluation of one-dimensional unsteady friction models in simple pipelines.” J. Hydraul. Eng., 696–708.
Vítkovský, J. P., Lambert, M., Simpson, A., and Bergant, A. (2000). “Advances in unsteady friction modelling in transient pipe flow.” Proc., 8th Int. Conf. on Pressure Surges, BHR, Hague, Netherlands.
Vítkovský, J. P., Lee, P. L., Zecchin, A. C., Simpson, A. R., and Lambert, M. F. (2011). “Head- and flow-based formulations for frequency domain analysis of fluid transients in arbitrary pipe networks.” J. Hydraul. Eng., 556–568.
Wood, D. J. (2005). “Waterhammer analysis—Essential and easy (and efficient).” J. Environ. Eng., 1123–1131.
Wood, D. J., Dorsch, R. G., and Lightner, C. (1966). “Wave plan analysis of unsteady flow in closed conduits.” J. Hydraul. Div., 92(2), 83.
Wood, D. J., Lingireddy, S., and Boulos, P. F. (2005a). “The wave characteristic method.” Chapter 2, Pressure wave analysis of transient flow in pipe distribution systems, MWH Software, Pasadena CA, 2.1–2.36.
Wood, D. J., Lingireddy, S., Boulos, P. F., Karney, B. W., and McPherson, D. L. (2005b). “Numerical methods for modeling transient flow in distribution systems.” J. AWWA, 97(7), 104–115.
Wylie, E. B. (1983). “The microcomputer and pipeline transients.” J. Hydraul. Eng., 1723–1739.
Wylie, E. B., and Streeter, V. L. (1978). “Solution by characteristics method.” Chapter 3, Fluid transients, McGraw-Hill, New York, 31–65.
Wylie, E. B., and Streeter, V. L. (1993). Fluid transients in systems, Prentice-Hall, Englewood Cliffs, NJ.
Zecchin, A. C., Lambert, M. F., Simpson, A. R., and White, L. B. (2010). “Frequency-domain modeling of transients in pipe networks with compound nodes using a Laplace-domain admittance matrix.” J. Hydraul. Eng., 739–755.
Zhao, M., and Ghidaoui, M. (2004). “Godunov-type solutions for water hammer flows.” J. Hydraul. Eng., 341–348.
Zielke, W. (1968). “Frequency-dependent friction in transient pipe flow.” J. Basic Eng., 90(1), 109–115.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 144 • Issue 7 • July 2018
Copyright
©2018 American Society of Civil Engineers.
History
Received: Apr 3, 2017
Accepted: Sep 18, 2017
Published online: Apr 19, 2018
Published in print: Jul 1, 2018
Discussion open until: Sep 19, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.