Calibration of a Marsh-Porosity Finite Element Model: Case Study from a Macrotidal Creek and Floodplain in Northern Australia
Publication: Journal of Hydraulic Engineering
Volume 144, Issue 2
Abstract
This study reports on the key findings from the application of a marsh-porosity model to a complex floodplain environment in northern Australia. The paper addresses the fundamental challenges associated with leakage in the marsh-porosity model, which have previously been described in the literature but have received little recent attention and for which limited guidance is available. A sensitivity analysis was carried out by adjusting the marshing parameters on the floodplain and assessing the effect on the simulated depth in Buffalo Creek. The statistical measures showed a significant improvement in the model performance at the most upstream site, using a combination of low porosity and element elimination on the floodplain. These measurements highlight the importance of focusing on the wetting and drying parameters as well as the bed roughness, in calibrating the marsh-porosity models in macrotidal floodplain environments. This paper also presents the parameter values and a summary of how they can be used to assist future practitioners.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors of this paper are grateful to the Power and Water Corporation in the Northern Territory for funding of this research. Special thanks to Trevor Durling, Martin Loipersberger, and Jordan Phasey for their insight and support.
References
Al-Asadi, K., and Duan, J. G. (2015). “Three-dimensional hydrodynamic simulation of tidal flow through a vegetated marsh area.” J. Hydraul. Eng., 1–8.
Ashall, L. M., Mulligan, R. P., van Proosdij, D., and Poirier, E. (2016). “Application and validation of a three-dimensional hydrodynamic model of a macro-tidal salt marsh.” Coastal Eng., 114, 35–46.
Ballesteros, J. A., Bodoque, J. M., Díez-Herrero, A., Sanchez-Silva, M., and Stoffel, M. (2011). “Calibration of floodplain roughness and estimation of flood discharge based on tree ring evidence and hydraulic modelling.” J. Hydrol., 403(1–2), 103–115.
Bates, P. D. (2000). “Development and testing of a subgrid scale model for moving-boundary hydrodynamic problems in shallow water.” Hydrol. Process., 14(11–12), 2073–2088.
Bell, S., and Amghar, M. (2002). Modeling scenarios for South East Queensland regional water quality management strategy, Cooperative Research Centre for Coastal Zone, Indooroopilly, Australia.
Büttner, O., Otte-White, K., Krüger, F., Meon, G., and Rode, M. (2006). “Numerical modeling of floodplain hydraulics and suspended sediment transport and deposition at the event scale in the Middle River Elbe, Germany.” Acta Hydrochimica et Hydrobiologica, 34, 265–278.
Cea, L., and French, J. R. (2012). “Bathymetric error estimation for the calibration and validation of estuarine hydrodynamic models.” Estuarine Coastal Shelf Sci., 100, 124–132.
Chow, V. T. (1959). Open-channel hydraulics, McGraw-Hill, New York.
Cunge, J. A., and Wegner, M. (1964). “Numerical integration of Barre de Saint Venant equations by means of an implicit scheme of finite differences.” La Houille Blanche, 1, 34–35.
Horritt, M. S., Bates, P. D., and Mattinson, M. J. (2006). “Effects of mesh resolution and topographic representation in 2D finite volume models of shallow water fluvial flow.” J. Hydrol., 329(1–2), 306–314.
Jung, H. C., et al. (2012). “Calibration of two-dimensional floodplain modeling in the central Atchafalaya basin floodway system using SAR interferometry.” Water Resour. Res., 48(7), 1–13.
Kärnä, T., et al. (2011). “A fully implicit wetting-drying method for DG-FEM shallow water models, with an application to the Scheldt estuary.” Comput. Methods Appl. Mech. Eng., 200(5–8), 509–524.
King, I. P. (2001). “Modeling of marshes and wetlands.” J. Coastal Res., 27, 76–87.
King, I. P. (2014). RMA2: A two dimensional finite element model for flow in estuaries and streams: Version 8.5K, Resource Modeling Associates, Sydney, Australia.
King, I. P., and Roig, l. C. (1988). “Two-dimensional finite element models for flood plains and tidal flats.” Proc., Int. Conf. on Computational Methods in Flow Analysis, Okayama, Japan, 711–718.
Li, L., Wang, X. H., and Williams, D. (2010). “Modeling of three dimensional tidal dynamics in Darwin Harbor, Australia.” Aust. New Zealand Ind. Appl. Math. J., 52, 103–123.
Martyr, R. C., et al. (2013). “Simulating hurricane storm surge in the lower Mississippi River under varying flow conditions.” J. Hydraul. Eng., 492–501.
Mason, D. C., Cobby, D. M., Horritt, M. S., and Bates, P. D. (2003). “Floodplain friction parameterization in two-dimensional river flood models using vegetation heights derived from airborne scanning laser altimetry.” Hydrol. Process., 17(9), 1711–1732.
Mazda, Y., Kobashi, D., and Okada, S. (2005). “Tidal-scale hydrodynamics within mangrove swamps.” Wetlands Ecol. Manage., 13(6), 647–655.
Mazda, Y., Wolanski, E., King, B., Sase, A., Ohtsuka, D., and Magi, M. (1997). “Drag force due to vegetation in mangrove swamps.” Mangroves Salt Marshes, 1(3), 193–199.
McKinnon, A. D., Smit, N., Townsend, S., and Duggan, S. (2006). “Darwin harbor: Water quality and ecosystem structure in a tropical harbor in the early stages of urban development.” The environment in Asia Pacific harbors, E. Wolanski, ed., Springer, Dordrecht, Netherlands, 433–459.
Medeiros, S. C., and Hagen, S. C. (2013). “Review of wetting and drying algorithms for numerical tidal flow models.” Int. J. Numer. Methods Fluids, 71(4), 473–487.
Murphy, A. H., and Epstein, E. S. (1988). “Skill scores and correlation coefficients in model verification.” Mon. Weather Rev., 117(3), 572–582.
Néelz, S., and Pender, G. (2013). “Benchmarking the latest generation of 2D hydraulic modelling packages.”, Environment Agency, Bristol, U.K.
Nielsen, C., and Apelt, C. (2003). “Parameters affecting the performance of wetting and drying in a two-dimensional finite element long wave hydrodynamic model.” J. Hydraul. Eng., 628–636.
Patterson, R. (2014). “Upper Darwin Harbor dye study, Palmerston outfall.” BEng. thesis, Charles Darwin Univ., Darwin, Australia.
Ridd, P. V., Wolanski, E., and Mazda, Y. (1990). “Longitudinal diffusion in mangrove fringed tidal creeks.” EstuarineCoastal Shelf Sci., 31(5), 541–554.
RMA (Resource Management Associates). (2005). “Flooded islands pre-feasibility study, RMA delta model calibration report.” Fairfield, CA.
Roache, P. J. (1997). “Quantification of uncertainty in computational fluid dynamics.” Ann. Rev. Fluid Mech., 29(1), 123–160.
Roig, L. C. (1989). “A finite element technique for simulating flows in tidal flats.” M.S. thesis, Univ. of California, Davis, CA.
Smagorinsky, J. (1963). “General circulation experiments with the primitive equations.” Mon. Weather Rev., 91(3), 99–164.
Valentine, E., Patterson, R., and Morgan, N. (2010). “Hydrodynamic modeling of Darwin Harbor, 2005-2010, History, Development and Interpretation: Report 4.” Charles Darwin Univ., Darwin, Australia.
Warner, J. C., Defne, Z., Haas, K., and Arango, H. G. (2013). “A wetting and drying scheme for ROMS.” Comput. Geosci., 58, 54–61.
Werner, M. G. F., Hunter, N. M., and Bates, P. D. (2005). “Identifiability of distributed floodplain roughness values in flood extent simulation.” J. Hydrol., 314(1–4), 139–157.
Williams, D., Wolanski, E., and Spagnol, S. (2006). “Hydrodynamics of Darwin Harbor.” Chapter 26, The environment in Asia Pacific harbors, E. Wolanski, ed., Springer, Dordrecht, Netherlands, 461–476.
Wolanski, E., Jones, M., and Bunt, J. S. (1980). “Hydrodynamics of a tidal creek-mangrove swamp system.” Aust. J. Mar. Freshwater Res., 31(4), 431–450.
Wood, J. D., Ramsey, J. S., and Kelley, S. W. (1999). “Two dimensional hydrodynamic modeling of Barnstable harbor and Great Marsh, Barnstable, MA.” Applied Coastal Research and Engineering, Mashpee, MA.
Wu, Y., Falconer, R. A., and Struve, J. (2001). “Mathematical modeling of tidal currents in mangrove forests.” Environ. Model. Software, 16(1), 19–29.
Zokagoa, J., and Soulaïmani, A. (2010). “Modelling of wetting-drying transitions in free surface flows over complex topographies.” Comput. Methods Appl. Mech. Eng., 199(33–36), 2281–2304.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jun 15, 2016
Accepted: Aug 8, 2017
Published online: Dec 14, 2017
Published in print: Feb 1, 2018
Discussion open until: May 14, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.