Experimental and Numerical Analysis of Side Weir Flows in a Converging Channel
Publication: Journal of Hydraulic Engineering
Volume 143, Issue 7
Abstract
This paper investigates the lateral outflow over a short-crested side weir inserted in a converging rectangular channel with linearly decreasing width in the flow direction. This type of overflow device induces a spatially varied free-surface flow with decreasing discharge and, because of the convergent geometry, it can potentially improve the performance of the distribution channels commonly used in irrigation systems, sewer networks, wastewater plants, and hydropower facilities for flow diversion and control and for flood protection. A laboratory investigation is carried out to analyze the main hydraulic characteristics of this kind of flow and assess the improvement in outflow efficiency compared to the conventional rectangular side weir in a prismatic channel. Only subcritical steady flow conditions are considered. Experimental data show that the Froude number in the main channel downstream of the weir and the dimensionless weir height are significant variables to describe the outflow efficiency, and they confirm that the nonprismaticity of the main channel induces a noticeable increase in outflow performance. Furthermore, the experimental results show that the assumption of constant specific energy usually adopted in one-dimensional side weir flow modeling is reasonably valid, despite the considerable increase in the velocity-head and momentum correction coefficients along the side weir. Finally, the comparison between experimental data and numerical results shows that the classic one-dimensional modeling approach can adequately predict the main engineering aspects of side weir flows in nonprismatic channels.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The Associate Editor and the reviewers are kindly acknowledged for their valuable comments that have greatly contributed to the improvement of the paper.
References
Aghayari, F., Honar, T., and Keshavarzi, A. (2009). “A study of spatial variation of discharge coefficient in broad-crested inclined side weirs.” Irrig. Drain., 58(2), 246–254.
Borghei, S. M., Jalili, M. R., and Ghodsian, M. (1999). “Discharge coefficient for sharp-crested side weir in subcritical flow.” J. Hydraul. Eng., 1051–1056.
Borghei, S. M., and Parvaneh, A. (2011). “Discharge characteristics of a modified oblique side weir in subcritical flow.” Flow Meas. Instrum., 22(5), 370–376.
Castro-Orgaz, O., and Hager, W. H. (2012). “Subcritical side-weir flow at high lateral discharge.” J. Hydraul. Eng., 777–787.
Chow, V. T. (1959). Open-channel hydraulics, McGraw-Hill, Singapore.
Citrini, D. (1942). “Canali rettangolari con portata e larghezza gradualmente variabili [Rectangular channels with gradually varied discharge and width].” L’Energia Elettrica, 19(5), 254–262 (in Italian).
Corbett, D. M., et al. (1943). “Stream-gaging procedure, U.S. geological survey.”, U.S. Government Printing Office, Washington, DC.
Cunge, J. A., Holly, F. M., and Verwey, A. (1980). Practical aspects of computational river hydraulics, Pitman, London.
De Marchi, G. (1934). “Saggio di teoria del funzionamento degli stramazzi laterali [Theory on side weir flows].” L’Energia Elettrica, 12(11), 849–860 (in Italian).
El-Khashab, A., and Smith, V. H. (1976). “Experimental investigation of flow over side weirs.” J. Hydraul. Div., 102(9), 1255–1268.
Emiroglu, M. E., Agaccioglu, H., and Kaya, N. (2011). “Discharging capacity of rectangular side weir in straight open channels.” Flow Meas. Instrum., 22(4), 319–330.
Emiroglu, M. E., Kaya, N., and Agaccioglu, H. (2010). “Discharge capacity of labyrinth side weir located on a straight channel.” J. Irrig. Drain Eng., 37–46.
Gentilini, B. (1938). “Ricerche sperimentali sugli sfioratori longitudinali [Experimental investigations on side weirs].” L’Energia Elettrica, 15(9), 583–595 (in Italian).
Gisonni, C., and Hager, W. H. (1997). “Short sewer sideweir.” J. Irrig. Drain Eng., 354–363.
Haddadi, H., and Rahimpour, M. (2012). “A discharge coefficient for a trapezoidal broad-crested side weir in subcritical flow.” Flow Meas. Instrum., 26, 63–67.
Hager, W. H. (1987). “Lateral outflow over side weirs.” J. Hydraul. Eng., 491–504.
Hager, W. H. (1999). Wastewater hydraulics: Theory and practice, Springer, Berlin.
Hager, W. H., and Volkart, P. U. (1986). “Distribution channels.” J. Hydraul. Eng., 935–952.
Honar, T., and Javan, M. (2007). “Discharge coefficient in oblique side weirs.” Iran Agric. Res., 25–26(1–2), 27–36.
Jalili, M. R., and Borghei, S. M. (1996). “Discussion of ‘Discharge coefficient of rectangular side weirs’ by R. Singh, D. Manivannan, and T. Satyanarayana.” J. Irrig. Drain Eng., 132.
Kouchakzadeh, S., and Vatankhah Mohammad-Abadi, A. R. (2002). “Spatially varied flow in non-prismatic channels. I: Dynamic equation.” Irrig. Drain., 51(1), 41–50.
Michelazzo, G., Oumeraci, H., and Paris, E. (2015). “Laboratory study on 3D flow structures induced by zero-height side weir and implications for 1D modeling.” J. Hydraul. Eng., .
Muslu, Y., Tozluk, H., and Yüksel, E. (2003). “Effect of lateral water surface profile on side weir discharge.” J. Irrig. Drain Eng., 371–375.
Nandesamoorthy, T., and Thomson, A. (1972). “Discussion of ‘Spatially varied flow over side-weirs’” by K. Subramanya and S. C. Awasthy.” J. Hydraul. Div., 98(12), 2234–2235.
Novak, G., Kozelj, D., Steinman, F., and Bajcar, T. (2013). “Study of flow at side weir in narrow flume using visualization techniques.” Flow Meas. Instrum., 29, 45–51.
Parvaneh, A., Borghei, S. M., and Jalili Ghazizadeh, M. R. (2011). “Discussion of ‘Discharge capacity of labyrinth side weir located on a straight channel’ by M. E. Emiroglu, N. Kaya, and H. Agaccioglu.” J. Irrig. Drain Eng., 743–745.
Parvaneh, A., Borghei, S. M., and Jalili Ghazizadeh, M. R. (2012). “Hydraulic performance of asymmetric labyrinth side weirs located on a straight channel.” J. Irrig. Drain Eng., 766–772.
Pilotti, M., Maranzoni, A., Tomirotti, M., and Valerio, G. (2011). “1923 Gleno dam break: Case study and numerical modeling.” J. Hydraul. Eng., 480–492.
Ramamurthy, A. S., and Carballada, L. B. (1980). “Lateral weir flow model.” J. Hydraul. Div., 106(1), 9–25.
Ranga Raju, K. G., Gupta, S. K., and Prasad, B. (1979). “Side weir in rectangular channel.” J. Hydraul. Div., 105(5), 547–554.
Říha, J., and Zachoval, Z. (2014). “Discharge coefficient of a trapezoidal broad-crested side weir for low approach Froude numbers.” J. Hydraul. Eng., 140(8), .
Singh, R., Manivannan, D., and Satyanarayana, T. (1994). “Discharge coefficient of rectangular side weirs.” J. Irrig. Drain. Eng., 814–819.
Subramanya, K., and Awasthy, S. C. (1972). “Spatially varied flow over side weirs.” J. Hydraul. Div., 98(1), 1–10.
Swamee, P. K., Pathak, S. K., Mohan, M., Agrawal, S. K., and Ali, M. S. (1994). “Subcritical flow over rectangular side weir.” J. Irrig. Drain. Eng., 212–217.
Ura, M., Kita, Y., Akiyama, J., Moriyama, H., and Jha, A. K. (2001). “Discharge coefficient of oblique side-weirs.” J. Hydrosci. Hydraul. Eng., 19(1), 85–96.
Uyumaz, A. (1997). “Side weir in U-shaped channels.” J. Hydraul. Eng., 639–646.
Yen, B. C., and Wenzel, H. G. (1970). “Dynamic equations for steady spatially varied flow.” J. Hydraul. Div., 96(3), 801–814.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Mar 31, 2016
Accepted: Oct 26, 2016
Published ahead of print: Feb 19, 2017
Published online: Feb 21, 2017
Published in print: Jul 1, 2017
Discussion open until: Jul 21, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.