Rosette Diffusers for Dense Effluents
Publication: Journal of Hydraulic Engineering
Volume 143, Issue 4
Abstract
Laboratory experiments on rosette diffusers for dense concentrate disposal from seawater desalination plants are reported. The rosettes each had four nozzles pointing upwards at 60° and arranged 90° apart in planform. Single and multiple risers in two planform orientations in stationary environments were tested for various riser spacing. Three-dimensional laser-induced fluorescence (3DLIF) was used to map tracer concentration fields from which the dilution, length, and thickness at the end of the near field were obtained. The effect of riser spacing depends on the dimensionless parameter , where is the riser spacing, the nozzle diameter, and the jet densimetric Froude number. For , the results were independent of riser spacing but the near-field dilution was approximately 27% lower than it is for a single jet. For the dilution, near-field length decrease, and empirical equations for their dependence on spacing were proposed. Dilution is less dependent on riser spacing than might be expected based on multiport diffuser results. This is because the jets from a rosette diffuser do not readily merge and block penetration of entrained diluting water, so the diffuser can be shorter for the same dilution.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors are indebted to U.S. Bureau of Reclamation for their financial support. We are also very grateful for numerous illuminating conversations on the topic of brine diffusers with Brett Miller of the University of New South Wales Water Research Laboratory.
References
Abessi, O., and Roberts, P. J. W. (2014). “Multiport diffusers for dense discharges.” J. Hydraul. Eng., .
Abessi, O., and Roberts, P. J. W. (2015a). “Dense jet discharges in shallow water.” J. Hydraul. Eng., .
Abessi, O., and Roberts, P. J. W. (2015b). “Dense jet videos, rosette tracer concentration profilies.” ⟨https://www.youtube.com/watch?v=o4UE545V93g⟩.
Abessi, O., and Roberts, P. J. W. (2016). “Multiport diffusers for dense discharge in flowing ambient water.” J. Hydraul. Eng., in press.
Fischer, B., List, J. E., Imberger, J., Brooks, N. H. (1979). Mixing in inland and coastal waters, Academic Press, San Diego.
Isaacson, M. S., Koh, R. C. Y., and Brooks, N. H. (1983). “Plume dilution for diffusers with multiple risers.” J. Hydraul. Eng., 199–220.
Kikkert, G. A., Davidson, M. J., and Nokes, R. I. (2007). “Inclined negatively buoyant discharges.” J. Hydraul. Eng., 545–554.
Kwon, S. J., and Seo, I. W. (2005). “Experimental investigation of wastewater discharges from a rosette-type diffuser using PIV.” KSCE J. Civ. Eng., 9(5), 355–362.
Miller, B. M, and Tarrade, L. (2010a). “Design considerations of outlet discharges for large seawater desalination projects in Australia.” 6th Int. Conf. on Marine Wastewater Discharges, MWWD 2010, Avanzi Middle East (FZE), Sharjah, UAE.
Miller, B. M. (2011). “Design of large desalination discharge with multiport jets.” Int. Symp. on Outfall Systems, International Water Association, London.
Miller, B. M., Cunningham, I. L., and Timms, W. A. (2007). “Physical modeling of the sea water concentrate diffuser for the Sydney desalination study.”, Univ. of New South Wales, Water Research Laboratory, Sydney, Australia.
Miller, B. M., and Tarrade, L. (2010b). “Design considerations of outlet discharges for large seawater desalination projects in Australia.” 6th Int. Conf. on Marine Wastewater Discharges, Avanzi Middle East (FZE), Sharjah, UAE.
Roberts, P. J. W., and Abessi, O. (2014). “Optimization of desalination diffusers using three-dimensional laser-induced fluorescence.”, United States Bureau of Reclamation, School of Civil and Environmental Engineering Georgia Institute of Technology, Atlanta.
Roberts, P. J. W., Ferrier, A., and Daviero, G. J. (1997). “Mixing in inclined dense jets.” J. Hydraul. Eng., 693–699.
Roberts, P. J. W., and Snyder, W. H. (1993a). “Hydraulic model study for the Boston outfall. I: Riser configuration.” J. Hydraul. Eng., 970–987.
Roberts, P. J. W., and Snyder, W. H. (1993b). “Hydraulic model study for the Boston outfall. II: Environmental performance.” J. Hydraul. Eng., 988–1002.
Shao, D., and Law, A. W.-K. (2010). “Mixing and boundary interactions of 30 and 45° inclined dense jets.” Environ. Fluid Mech., 10(5), 521–553.
Tarrade, L., and Miller, B. M (2010). “Physical modeling of the Victorian desalination plant outfall.”, Univ. of New South Wales, Water Research Laboratory, Sydney, Australia.
Tarrade, L., Rayner, D. S., and Miller, B. M. (2009). “Physical modeling of brine diffuser.”, Univ. of New South Wales, Water Research Laboratory, Sydney, Australia.
Tian, X., and Roberts, P. J. W. (2003). “A 3D LIF system for turbulent buoyant jet flows.” Exp. Fluids, 35(6), 636–647.
Tian, X. and Roberts, P. J. W. (2011). “Experiments on marine wastewater diffusers with multiport rosettes.” J. Hydraul. Eng., 1148–1159.
Tian, X., Roberts, P. J. W., and Daviero, G. J. (2004). “Marine wastewater discharges from multiport diffusers. I: Unstratified stationary water.” J. Hydraul. Eng., 1137–1146.
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Jun 25, 2015
Accepted: Sep 2, 2016
Published online: Nov 11, 2016
Published in print: Apr 1, 2017
Discussion open until: Apr 11, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.