Propeller Jet–Induced Suspended-Sediment Concentration
Publication: Journal of Hydraulic Engineering
Volume 142, Issue 4
Abstract
When subjected to a strong swirling jet flow induced by a rotating ship’s propeller, the bed of a waterway may undergo significant changes. These changes will not only cause instability to quay structures and damage the protection work of the beds/banks of rivers and canals, but also resuspend the bed sediment. The latter likely will pollute the water column and affect the aquatic life. In this study, the propeller-jet velocity and sediment-concentration profiles downstream of a propeller are measured using an acoustic Doppler velocity profiler and a suction device, respectively. The estimates obtained by using formulas for the axial velocity and four published methods for calculating the reference near-bed concentration of suspended sediment are compared with the experimental data. Moreover, the behavior underlying the temporal and spatial variations in seabed scour and sediment suspension is also investigated. A new set of equations for estimating the sediment concentration profiles is developed. The new equations generally yield reasonably good estimates of the reference concentration and Rouse number at the measurement locations within the scour hole and on the deposition mound. The proposed modified Rouse equation produces reasonable predictions that are consistent with the experimental data.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank the Maritime and Port Authority of Singapore, the Hamburg Port Authority, and the DHI-NTU Water & Environment Research Centre for funding this research. They also wish to thank Mr. Y. Xie for conducting the experiments.
References
Akiyama, J., and Fukushima, Y. (1986). Entrainment of noncohesive sediment into suspension, Univ. of Mississippi, University, MS, 804–813.
Albertson, M. L., Dai, Y. B., Jensen, R. A., and Rouse, H. (1950). “Diffusion of submerged jets.” Trans. Am. Soc. Civ. Eng., 115(1), 639–664.
Berger, W., Felkel, K., Hager, M., Oebius, H., and Schale, E. (1981). “Courant provoque par les bateaux protection des berges et solutionpour eviterl’erosion du lit du haut rhin.” Proc., PIANC, 25th Congress, Edinburgh, Scotland.
Blaauw, H. G., and van de Kaa, E. J. (1978). “Erosion of bottom and sloping banks caused by the screw race of manoevring ships.” Delft Hydraulics Laboratory, Delft, Netherlands.
Chin, C. O., Chiew, Y. M., Lim, S. Y., and Lim, F. H. (1996). “Jet scour around vertical pile.” J. Water. Port Coast. Ocean Eng., 59–67.
Dargahi, B. (2003). “Three-dimensional modelling of ship-induced flow and erosion.” Proc. ICE-Water Mar. Eng., 156(2), 193–204.
Dietrich, W. E. (1982). “Settling velocity of natural particles.” Water Resour. Res., 18(6), 1615–1626.
Einstein, H. A. (1950). “The bed-load function for sediment transportation in open channel flows.” No. 1026, U.S. Dept. of Agriculture.
Fuehrer, M., and Römisch, K. (1977). “Effects of modern ship traffic on islands and oceans waterways and their structures.” Proc., PIANC 24th Congress, Leningrad, Russia.
García, M., and Parker, G. (1991). “Entrainment of bed sediment into suspension.” J. Hydraul. Eng., 414–435.
García, M. H., Admiraal, D. M., and Rodriguez, J. F. (1999). “Sediment entrainment functions for navigation-induced resuspension.” Univ. of Illinois Civil Engineering Studies, Urbana, IL.
Gucinski, H. (1982). Sediment suspension and resuspension from small-craft induced turbulence, Anne Arundel Community College, Arnold, MD.
Hamill, G. A. (1987). “Characteristics of the screw wash of a manoeuvring ship and the resulting bed scour.” Ph.D. dissertation, Queen’s Univ. of Belfast, Belfast, Northern Ireland.
Hamill, G. A., and Johnston, H. T. (1993). “The decay of maximum velocity within the initial stages of a propeller wash.” J. Hydraul. Res., 31(5), 605–613.
Hashmi, H. N. (1993). “Erosion of a granular bed at a quay wall by a ship’s screw wash.” Ph.D. dissertation, Queen’s Univ. of Belfast, Belfast, Northern Ireland.
Hong, J. H., Chiew, Y. M., and Cheng, N. S. (2013). “Scour caused by a propeller jet.” J. Hydraul. Eng., 1003–1012.
Itakura, T., and Kishi, T. (1980). “Open channel flow with suspended sediments.” J. Hydraul. Div., 106(8), 1325–1343.
Kelly, C. A., Ayoko, G. A., Brown, R. J., and Swaroop, C. R. (2005). “Underwater emissions from a two-stroke outboard engine: A comparison between an EAL and an equivalent mineral lubricant.” Mater. Des., 26(7), 609–617.
Lam, W., Hamil, G. A., Song, Y. C., Robinson, D. J., and Raghunathan, S. (2011). “A review of the equations used to predict the velocity distribution within a ship’s propeller jet.” Ocean Eng., 38(1), 1–10.
McGarvey, J. A. (1996). “The influence of the rudder on the hydrodynamics, and the resulting bed scour, of a ship’s screw wash.” Ph.D. dissertation, Queen’s Univ. of Belfast, Belfast, Northern Ireland.
Oebius, H., and Schuster, S. (1975). “Modelversuchezurfrage der beschadigung von flussohlendurch die schiffahrtversuchsanstalt fur wasserbau und schiffbau.” Berlin.
Rouse, H. (1938). “Experiments on the mechanics of sediment suspension.” Proc., 5th Int. Congress for Applied Mechanics, Wiley, New York.
Schmidt, W. (1925). Der Massenaustausch in freierLuft und verwandteErscheinungen, HenriGrand, Hamburg, Germany.
Situ, R., Brown, R. J., and Loberto, A. (2010). “Experimental study of the concentration field of discharge from a boat propeller.” Environ. Fluid Mech., 10(6), 657–675.
Smith, J. D., and McLean, S. R. (1977). “Spatially averaged flow over a wavy surface.” J. Geophys. Res., 82(12), 1735–1746.
Stewart, D. P. J. (1992). “Characteristics of a ship’s screw wash and the influence of quay wall proximity.” Ph.D. dissertation, Queen’s Univ. of Belfast, Belfast, Northern Ireland.
van Rijn, L. C. V. (1984). “Sediment transport. Part II: Suspended load transport.” J. Hydraul. Eng., 1613–1641.
Verhey, H. J. (1983). “The stability of bottom and banks subjected to the velocities in the propeller jet behind ships.” 8th Int. Harbour Congress, Antwerp, Belgium.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Sep 21, 2014
Accepted: Sep 13, 2015
Published online: Dec 21, 2015
Published in print: Apr 1, 2016
Discussion open until: May 21, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.