Numerical Investigation of the Influence of Viscoelastic Deformation on the Pressure-Leakage Behavior of Plastic Pipes
Publication: Journal of Hydraulic Engineering
Volume 142, Issue 3
Abstract
It has been well established that leakage from pipes is more sensitive to changes in pressure than the square root relationship predicted by the orifice equation. The main reason for this is that leak areas are not static, but vary with changes in system pressure. While previous studies have shown that the leak area is a linear function of pressure for elastic materials, the effect of the viscoelastic behavior of plastic pipes on the pressure-leakage response is not yet well understood. In this study, finite element analysis was used to investigate the effect of viscoelastic behavior on round holes and longitudinal cracks in both high density polyethylene (HDPE) and polyvinylchloride (PVC) pipes. The standard differential equation for linear viscoelastic deformation was then calibrated to the finite element results, resulting in equations that accurately describe the viscoelastic variation in leak areas as functions of time. The results also showed that the time-dependent behaviors of both pipe materials are proportional to their elastic behavior, and stabilize after about 12 h. The total deformations of HDPE and PVC pipes were found to be approximately 220 and 122% of their respective elastic deformations.
Get full access to this article
View all available purchase options and get full access to this article.
References
ABAQUS [Computer software]. Dassault Systemes Simulia, Waltham, MA.
Andrews, E. H. (1968). Fracture in polymers, 1st Ed., Oliver and Boyd Ltd, London.
Ávila, H. (2003). “Determination of parameters for longitudinal faults and leaks in residential connections in PVC pipes.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Universidad de Los Andes, Bogotá, Columbia.
Banks, H. T., Hu, S., and Kenz, Z. R. (2011). “A brief review of elasticity and viscoelasticity.” Adv. Appl. Math. Mech., 3(1), 1–51.
Cassa, A. M., and Van Zyl, J. E. (2013). “Predicting the head-leakage slope of cracks in pipes subject to elastic deformations.” J. Water Supply: Res. Technol.—AQUA, 62(4), 214–223.
Cassa, A. M., and Van Zyl, J. E. (2014). “Predicting the leakage exponents of elastically deforming cracks in pipes.” Proc. Eng., 70(2014), 302–310.
Cassa, A. M., Van Zyl, J. E., and Laubscher, R. F. (2010). “A numerical investigation into the effect of pressure on holes and cracks in water supply pipes.” Urban Water J., 7(2), 109–120.
Covas, D., Stoianov, I., Mano, J. F., Ramos, H., Graham, N., and Maksimovic, C. (2005). “The dynamic effect of pipe-wall viscoelasticity in hydraulic transients. Part II—Model development, calibration and verification.” J. Hydraul. Res., 43(1), 56–70.
Covas, D., Stoianov, I., Ramos, H., Graham, N., and Maksimovic, C. (2004). “The dynamic effect of pipe-wall viscoelasticity in hydraulic transients. Part I—experimental analysis and creep characterization.” J. Hydraul. Res., 42(5), 517–532.
Farley, M., and Trow, S. (2003). Losses in water distribution networks, IWA, London, U.K.
Farshad, M. (2011). Plastic pipe systems: Failure investigation and diagnosis: Failure investigation and diagnosis, Elsevier, Philadelphia, PA.
Ferrante, M. (2012). “Experimental investigation of the effects of pipe material on the leak head-discharge relationship.” J. Hydraul. Eng., 736–743.
Ferrante, M., Brunone, B., and Meniconi, S. (2014). “Local and global leaks laws: The relationship between pressure and leakage for a single leak and for a district with leaks.” Water Resour. Manage. 28(11), 3761–3782.
Ferrante, M., Massari, C., Brunone, B., and Meniconi, S. (2011). “Experimental evidence of hysteresis in the head-discharge relationship for a leak in a polyethylene pipe.” J. Hydraul. Eng., 775–780.
Ferrante, M., Massari, C., Brunone, B., and Meniconi, S. (2013). “Leak behaviour in pressurized PVC pipes.” Water Sci. Technol.: Water Supply, 13(4), 987–992.
Fung, Y. C (1993). “Viscoelasticity.” Biomechanics: Mechanical properties of living tissues, 2nd Ed., Springer, New York, 41–52.
Greyvenstein, B., and Van Zyl, J. E. (2007). “An experimental investigation into the pressure—Leakage relationship of some failed water pipes.” J. Water Supply: Res. Technol.—AQUA, 56(2), 117–124.
Griffel, W. (1966). “Discontinuity stresses in pressure vessels.” Handbook of formulas for stress and strain, F. Ungar Publishing Company, New York, 221.
Hildebrand, F. B. (1974). “Exponential approximation.” Introduction to numerical analysis, 2nd Ed., J. L. Farnsworth and S. L. Langman, eds., McGraw-Hill, New Delhi, 457–458.
Janson, L. (2003). Plastic pipes for water supply and sewage disposal, 4th Ed., Borealis, Majornas CopyPrint, Stockholm, Sweden.
Jasinoski, S. C., and Reddy, B. D. (2012). “Mechanics of cranial sutures during simulated cyclic loading.” J. Biomech., 45(11), 2050–2054.
Lambert, A., Fantozzi, M, Thornton, J. (2013). “Practical approaches to modeling leakage and pressure management in distribution systems– progress since 2005.” 12th Int. Conf. on Computing and Control for the Water Industry, CCWI2013, Elsevier Procedia, Perugia, Italy.
Massari, C., Ferrante, M., Brunone, B., and Meniconi, S. (2012). “Is the leak head-discharge relationship in polyethylene pipes a bijective function?” J. Hydraul. Res., 50(4), 409–417.
May, J. (1994). “Pressure dependent leakage.” World Water Environ. Eng., 17(8), 10.
Moore, G., and Kline, D. (1984). “Mechanical properties of polymers viscoelasticity.” Properties and processing of polymers for engineers, Prentice Hall, Englewood Cliffs, NJ, 92–114.
Pezzinga, G. (2014). “Evaluation of time evolution of mechanical parameters of polymeric pipes by unsteady flow runs.” J. Hydraul. Eng., 04014057.
SANS (South African National Standards). (2004). “Components of pressure pipe systems Part 1: Unplasticised poly(vinyl chloride) (PVC-U) pressure pipe systems.”, Standards South Africa, Pretoria, South Africa.
Schwaller, J., and Van Zyl, J. E. (2014). “Implications of the known pressure-response of individual leaks for whole distribution systems.” Procedia Eng., 70(2014), 1513–1517.
Soares, A., Covas, D., and Reis, L. (2008). “Analysis of PVC pipe-wall viscoelasticity during water hammer.” J. Hydraul. Eng., 1389–1394.
Soares, A., Covas, D., and Reis, L. (2011). “Leak detection by inverse transient analysis in an experimental PVC pipe system.” J. Hydroinform., 13(2), 153–166.
Stephens, M. L., Lambert, M. F., Simpson, A. R., and Vitkovsky, J. (2011). “Calibrating the water-hammer response of a field pipe network by using a mechanical damping model.” J. Hydraul. Eng., 1225–1237.
Tada, H., Paris, P., and Irwin, G. (2000). The stress analysis of cracks handbook, 3rd Ed., ASME Press, New York.
Thornton, J. (2003). “Managing leakage by managing pressure: A practical approach.” Water21, 5(5), 43–44.
Van Zyl, J. E., and Cassa, A. M. (2014). “Modeling elastically deforming leaks in water distribution pipes.” J. Hydraul. Eng., 182–189.
Van Zyl, J. E., and Clayton, C. R. I. (2007). “The effect of pressure on leakage in water distribution systems.” Proc. ICE: Water Manage., 160(2), 109–114.
Ward, I. M. (1971). Mechanical properties of solid polymers, Wiley, London.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jan 19, 2015
Accepted: Aug 25, 2015
Published online: Oct 14, 2015
Published in print: Mar 1, 2016
Discussion open until: Mar 14, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.