Free-Surface versus Rigid-Lid LES Computations for Bridge-Abutment Flow
This article has been corrected.
VIEW CORRECTIONPublication: Journal of Hydraulic Engineering
Volume 141, Issue 9
Abstract
Two separate large eddy simulations (LES) are carried out to investigate the effects of accurate computation of the curvilinear water-surface deformation of the flow through a bridge contraction. One LES employs the rigid-lid boundary condition at the water surface, while the other uses a highly accurate level-set method (LSM), which allows the water surface to adjust itself freely in response to the flow. The simulation with the LSM is validated with data from complementary physical model tests under analogous geometrical and flow conditions. Streamwise velocity, bed-shear stress and second-order turbulence statistics obtained from both simulations are compared, and it is shown that the turbulence structure of this flow is influenced strongly by the water-surface deformation. While bed-shear stresses and first-order statistics are very similar for both cases, the instantaneous turbulence structure and consequently, the second-order statistics, are distinctly different. The correct prediction of the water-surface deformation of such flows is deemed important for the accuracy of their simulation.
Get full access to this article
View all available purchase options and get full access to this article.
References
Biglari, B., and Sturm, T. W. (1998). “Numerical modeling of flow around bridge abutments in compound channel.” J. Hydraul. Eng., 156–164.
Bomminayuni, S., and Stoesser, T. (2011). “Turbulence statistics in an open-channel flow over a rough bed.” J. Hydraul. Eng., 1347–1358.
Chrisohoides, A., Sotiropoulos, F., and Sturm, T. W. (2003). “Coherent structures in flat-bed abutment flow: Computational fluid dynamics simulations and experiments.” J. Hydraul. Eng., 177–186.
Kang, S., and Sotiropoulos, F. (2012). “Numerical modeling of 3D turbulent free surface flow in natural waterways.” Adv. Water Resour., 40, 23–36.
Kara, S., Stoesser, T., and Sturm, T. W. (2012). “Turbulence statistics in compound channels with deep and shallow overbank flows.” J. Hydraul. Res., 50(5), 482–493.
Kara, S., Stoesser, T., Sturm, T. W., and Mulahasan, S. (2015). “Flow dynamics through a submerged bridge opening with overtopping.” J. Hydraul. Res., 53(2), 186–195.
Kim, D., Kim, D., Kim, J. H., and Stoesser, T. (2010). “Large eddy simulation of flow and solute transport in ozone contact chambers.” J. Environ. Eng., 22–31.
Kim, D., Kim, J. H., and Stoesser, T. (2013). “Hydrodynamics, turbulence and solute transport in ozone contact chambers.” IAHR J. Hydraul. Res., 51(5), 558–568.
Kim, S. J., and Stoesser, T. (2011). “Closure modeling and direct simulation of vegetation drag in flow through emergent vegetation.” Water Resour. Res., 47(10), W10511.
Koken, M., and Constantinescu, G. (2008). “An investigation of the flow and scour mechanisms around isolated spur dikes in a shallow open channel. 1. Conditions corresponding to the initiation of the erosion and deposition process.” Water Resour. Res., 44(8), W08406.
Koken, M., and Constantinescu, G. (2009). “An investigation of the dynamics of coherent structures in a turbulent channel flow with a vertical sidewall obstruction.” Phys. Fluids, 21(8), 085104.
Melville, B. W. (1992). “Local scour at bridge abutments.” J. Hydraul. Eng., 615–631.
Melville, B. W. (1995). “Bridge abutment scour in compound channels.” J. Hydraul. Eng., 863–868.
Nagata, N., Hosoda, T., Nakato, T., and Muramoto, Y. (2005). “Three-dimensional numerical model for flow and bed deformation around river hydraulic structures.” J. Hydraul. Eng., 1074–1087.
Nicoud, F., and Ducros, F. (1999). “Subgrid-scale stress modelling based on the square of the velocity gradient tensor.” Flow Turbul. Combust, 62(3), 183–200.
Oliveto, G., and Hager, W. H. (2002). “Temporal evolution of clear-water pier and abutment scour.” J. Hydraul. Eng., 811–820.
Ouillon, S., and Dartus, D. (1997). “Three-dimensional computation of flow around groyne.” J. Hydraul. Eng., 962–970.
Paik, J., Ge, L., and Sotiropoulos, F. (2004). “Toward the simulation of complex 3D shear flows using unsteady statistical turbulence models.” Int. J. Heat Fluid Flow, 25(3), 513–527.
Paik, J., and Sotiropoulos, F. (2005). “Coherent structure dynamics upstream of a long rectangular block at the side of a large aspect ratio channel.” Phys. Fluids, 17(11), 115104.
Rodi, W., Constantinescu, G., and Stoesser, T. (2013). “Large-eddy simulation in hydraulics.” IAHR-Monograph, CRC Press/Balkema, Leiden, Netherlands.
Stoesser, T. (2010). “Physically realistic roughness closure scheme to simulate turbulent channel flow over rough beds within the framework of LES.” J. Hydraul. Eng., 812–819.
Stoesser, T. (2014). “Large-eddy simulation in hydraulics: Quo Vadis?” J. Hydraul. Res., 52(4), 441–452.
Stoesser, T., Kim, S. J., and Diplas, P. (2010). “Turbulent flow through idealized emergent vegetation.” J. Hydraul. Eng., 1003–1017.
Stoesser, T., and Nikora, V. (2008). “Flow structure over square bars at intermediate submergence: Large eddy simulation (LES) study of bar spacing effect.” Acta Geophysica, 56(3), 876–893.
Sturm, T. W. (2006). “Scour around bankline and setback abutments in compound channels.” J. Hydraul. Eng., 21–32.
Sturm, T. W., and Janjua, N. S. (1994). “Clear-water scour around abutments in floodplains.” J. Hydraul. Eng., 956–972.
Teruzzi, A., Ballio, F., and Armenio, V. (2009). “Turbulent stresses at the bottom surface near an abutment: Laboratory-scale numerical experiment.” J. Hydraul. Eng., 106–117.
Yue, W. S., Lin, C. L., and Patel, V. C. (2006). “Large-eddy simulation of turbulent flow over a fixed two-dimensional dune.” J. Hydraul. Eng., 643–651.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jun 6, 2014
Accepted: Mar 2, 2015
Published online: May 14, 2015
Published in print: Sep 1, 2015
Discussion open until: Oct 14, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.