Cross-Flow Turbine Design for Energy Production and Discharge Regulation
Publication: Journal of Hydraulic Engineering
Volume 141, Issue 3
Abstract
Cross-flow turbines are very efficient and cheap turbines that allow a very good cost/benefit ratio for energy production located at the end of conduits carrying water from a water source to a tank. In this paper, a new design procedure for a cross-flow turbine working with a variable flow rate is proposed. The regulation of the head immediately upstream the turbine is faced by adopting a shaped semicircular segment moving around the impeller. The maximum efficiency of the turbine is attained by setting the velocity of the particles entering the impeller at about the velocity of the rotating system at the impeller inlet. If energy losses along the pipe are negligible, the semicircular segment allows always a constant hydraulic head and a constant velocity at the impeller inlet, even with variable flow rate. The decrease of the turbine efficiency along with the inlet surface reduction is first investigated; a design methodology, using also computational fluid dynamics simulations, is then proposed for both the cases of negligible and not negligible energy losses along the pipe.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported in this paper has been supported by the Hydroenergy project, Programma Operativo del Fondo Europeo di Sviluppo Regionale (P.O. F.E.S.R.) 2007–2013, Sicily.
References
ANSYS-CFX [Computer software]. Canonsburg, PA, ANSYS.
ANSYS ICEM CFD [Computer software]. Canonsburg, PA, ANSYS.
Carravetta, A., del Giudice, G., Fecarotta, O., and Ramos, H. (2012). “Energy production in water distribution networks: A pat design strategy.” Water Resour. Manage., 26(13), 3947–3959.
Carravetta, A., del Giudice, G., Fecarotta, O., and Ramos, H. (2013). “PAT design strategy for energy recovery in water distribution networks by electrical regulation.” Energies, 6(1), 411–424.
Carravetta, A., Fecarotta, O., Sinagra, M., and Tucciarelli, T. (2014). “Cost-benefit analysis for hydropower production in water distribution networks by a pump as turbine.” J. Water Resour. Plann. Manage., 04014002.
Carravetta, A., and Giugni, M. (2006). “Functionality factors in the management and rehabilitation of water networks. Management of water networks.” Proc., Conf. on Efficient Management of Water Networks–Design and Rehabilitation Techniques, P. Bertola and M. Franchini, eds., American Medical Group Association (AMGA), 40–56.
Costa Pereira, N. H., and Borges, J. E. (1996). “Study of the nozzle flow in a cross-flow turbine.” Int. J. Mech. Sci., 38(3), 283–302.
Haurissa, J., Wahyudi, S., Irawan, Y. S., and Soenoko, R. (2012). “The cross flow turbine behavior towards the turbine rotation quality, efficiency, and generated power.” J. Appl. Sci. Res., 8(1), 448–453.
Joshi, S., Gordon, A., Holloway, L., Chang, L., and Kojabadi, H. M. (2005). “Development of a stand alone micro-hydro system using pump as turbine technology for low head sites in remote areas.” Proc., Power System Conf., Iran.
Kaniecki, M. (2002). “Modernization of the outflow system of cross-flow turbines.” Task Q., 6(4), 601–608.
Khosrowpanah, S., Alberton, M. L., and Fiuzat, A. A. (1984). “Historical overview of cross-flow turbine.” Int. Water Power Dam Constr., 36(10), 38–43.
Khurana, S., and Kumar, A. (2011). “Small hydro power—A review.” Int. J. Therm. Technol., 1(1), 107–110.
Kokubu, K., Son, S. W., Kanemoto, T., and Choi, Y. D. (2011). “Internal flow analysis on a micro cross-flow type hydro turbine at very low specific speed range.” Proc., Asian Int. Conf. on Fluid Machinery and the Fluid Power Technology Exhibition, B. Prasad, ed., Dept. of Mechanical Engineering, IIT Madras, Chennai, India.
Paish, O. (2002). “Small hydro power: Technology and current status.” Renew. Sustain. Energy Rev., 6(6), 537–556.
Ramuz, D., et al. (2005). “Modelling and simulation of a doubly fed induction generator in stand-alone variable speed hydro turbine.” Proc., European Conf. on Power Electronics and Applications, EPE Association, Brussels, Belgium.
Sammartano, V., Aricò, C., Carravetta, A., Fecarotta, O., and Tucciarelli, T. (2013). “Banki-Michell optimal design by computational fluid dynamics testing and hydrodynamic analysis.” Energies, 6(5), 2362–2385.
Singh, D. (2009). “Resource assessment handbook.” Proc., Asian and Pacific Center for Transfer of Technology of the United Nations–Economic and Social Commission for Asia and the Pacific (ESCAP), Delhi, India, 16–34.
Verhaart, P. (1983). “Blade calculations for water turbines of the Banki type.”, Dept. of Mechanical Engineering, Eindhoven Univ. of Technology, Eindhoven, The Netherlands.
Zimny, J., Michalak, P., Bielik, S., and Szczotka, K. (2013). “Directions in development of hydropower in the world, in Europe and Poland in the period 1995–2011.” Renew. Sustain. Energy Rev., 21, 117–130.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Nov 11, 2013
Accepted: Oct 22, 2014
Published online: Nov 21, 2014
Published in print: Mar 1, 2015
Discussion open until: Apr 21, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.