Modeling Control Valves in Water Distribution Systems Using a Continuous State Formulation
Publication: Journal of Hydraulic Engineering
Volume 140, Issue 11
Abstract
Control valves are commonly used for the operation of water distribution systems. Modeling these devices typically requires that their operating states are known, or that a computationally expensive search is undertaken over all possible operating states. This paper presents a novel method of modeling control valves (including flow control, pressure sustaining, pressure reducing and check valves) in extended-period simulations of water distribution systems. Instead of the normal discrete control problem formulation, it is approached with the Karush-Kuhn-Tucker equations for an optimization problem with constraints. The proposed method does not prerequire the operating state (open, closed, active) of each valve to be determined, as this is done implicitly. Pipe and valve flow rates and nodal heads are determined by: (1) minimizing deviations from targets at control valves, and (2) satisfy the state equations (conservation of mass and energy) by solving a constrained least-squares problem. Sensitivity equations with respect to the control variables (valve settings) are derived from the state equations, and the control variables are updated using Levenberg-Marquardt iterations. The results of simple problems and case studies are presented to demonstrate the effectiveness of the approach.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bazaraa, M. S., Sherali, H. D., and Shetty, C. M. (1993). Nonlinear programming—Theory and algorithms, 2nd Ed., Wiley, Hoboken, NJ.
Carpentier, P., Cohen, G., and Hamam, Y. (1985). Water network equilibrium, variational formulation and comparison of numerical algorithms, EURO VII, Bologna, Italy.
Chandrashekar, M., and Stewart, K. H. (1975). “Sparcity oriented analysis of large pipe networks.” J. Hydraul. Div., 101(4), 341–355.
Collins, M., Cooper, L., Helgason, R., Kennington, R., and Leblanc, L. (1978). “Solving the pipe network analysis problem using optimization techniques.” Manage. Sci., 24(7), 747–760.
Cross, H. (1936). “Analysis of flow in networks of conduits or conductors.”, Univ. of Illinois Engineering Experimental Station, Urbana-Champaign, IL.
Deuerlein, J., Cembrowicz, R. G., and Dempe, S. (2005). “Hydraulic simulation of water supply networks under control.” World Water and Environmental Resources Congress (EWRI05), ASCE, Reston, VA.
Deuerlein, J., Simpson, A. R., and Gross, E. (2008). “The never ending story of modeling control-devices in hydraulic systems analysis.” 10th Int. Water Distribution System Analysis Conf. (WDSA), ASCE, Reston, VA.
Deuerlein, J. W., Simpson, A. R., and Dempe, S. (2009). “Modeling the behavior of flow regulating devices in water distribution systems using constrained nonlinear programming.” J. Hydraul. Eng., 970–982.
Epanet 2.00.12 [Computer software]. 〈http://www.epa.gov/nrmrl/wswrd/dw/epanet.html〉 (Jun. 12, 2014).
Epp, R., and Fowler, A. G. (1970). “Efficient code for steady-state flows in networks.” J. Hydraul. Div., 96(1), 43–56.
Lam, C. F., and Wolla, M. L. (1972). “Computer analysis of water distribution systems: Part II—Numerical solution.” J. Hydraul. Div., 98(3), 447–460.
Martin, D. W., and Peters, G. (1963). “The application of Newton’s method to network analysis by digital computer.” J. Inst. Water Eng., 17(2), 115–129.
Ortega, J. M., and Rheinboldt, W. C. (1970). Iterative solution of nonlinear equations in several variables, Academic Press, New York, London.
Piccolo [Computer software]. 〈http://www.safege.com/en/innovation/modelling/piccolo/〉 (Jun. 12, 2014).
Piller, O. (1995). “Modeling the behavior of a network—Hydraulic analysis and sampling procedures for parameter estimation.” Ph.D. thesis, Applied Mathematics from Mathematics and Computer Science Doctoral School, Univ. of Bordeaux (PRES), Talence, France.
Piller, O., and Brémond, B. (2001). “Modeling of pressure regulating devices: A problem now solved.” Bridging the gap, ASCE, Reston, VA, 1–10.
Piller, O., Gancel, G., and Propato, M. (2005). “Slow transient pressure regulation in water distribution systems.” Eighth Int. Conf. on Computing and Control in the Water Industry CCWI05, Water Management for the 21st Century, Centre for Water Systems, Dept. of Engineering, Univ. of Exeter, Exeter, U.K.
Piller, O., and van Zyl, J. E. (2009). “Pressure-driven analysis of network sections supplied via high-lying nodes.” Computing and control in the water industry, integrating water systems, Taylor and Francis group, London, 257–262.
Porteau [Computer software]. 〈http://porteau.irstea.fr/〉 (Jun. 12, 2014).
Rossman, L. A. (2000). EPANET user’s manual, U.S. Environmental Protection Agency, Cincinnati, OH.
Simpson, A. (1999). “Modeling of pressure regulating devices: The last major problem to be solved in hydraulic simulation.” Water Resources Planning and Management Conf., ASCE, Reston, VA.
Todini, E., and Pilati, S. (1988). “A gradient projection algorithm for the analysis of pipe networks.” Computer applications for water supply and distribution, Research Study Press, Taunton, U.K.
Wood, D. J., and Charles, C. O. A. (1972). “Hydraulic network analysis using linear theory.” J. Hydraul. Div., 98(7), 1157–1170.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Aug 1, 2013
Accepted: May 20, 2014
Published online: Jul 8, 2014
Published in print: Nov 1, 2014
Discussion open until: Dec 8, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.