Analytical Model for Water Inflow of an Archimedes Screw Used in Hydropower Generation
Publication: Journal of Hydraulic Engineering
Volume 139, Issue 2
Abstract
Archimedes screws have become increasingly popular throughout Europe to drive hydropower plants using residual flow from a stream or river. This heightened usage of such screws during the past few years is attributable to their robustness, simplicity, and fish friendliness. Presently the dimensioning of a hydropower site equipped with an Archimedes screw is dependent mainly on the experience of the design engineer. This is so because there is no appropriate theory for the optimal hydraulic design of screws used at hydropower sites, especially for the water-inflow conditions. In this paper, a new analytical model for the water inflow is derived, and the optimal values of the inflow parameters are determined to achieve a planned inflow to the screw.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported generously by the Deutsche Forschungsgemeinschaft Grant No. NU294/1-1. The authors are also grateful to Professor Moshe Kam and Professor Leonid Hrebien of the ECE Department of Drexel University for providing research facilities for this project.
References
Aigner, D. (2008). Überfälle—Wasserbauliche Mittelungen—Aktuelle Forschungen im Wasserbau 1993–2008, Heft 36, Institut für Wasserbau und Technische Hydromechanik der TU Dresden, Selbstverlag der Technischen Universität Dresden, Dresden.
Bollrich, G., and Preissler, G. (1992). Technische Hydromechanik Band 1, 3rd Ed., Verlag für Bauwesen, Berlin.
Brada, K. (1996a). Schneckentrogpumpe als Mikroturbine, in Wasserkraftanlagen—Klein- und Kleinstkraftwerke, 1st Ed., expert-Verlag, Malsheim.
Brada, K. (1996b). “Wasserkraftschnecke—Eigenschaften und Verwendung.” Proc., Sixth Int. Symp. on Heat Exchange and Renewable Energy, Szczecin, 43–52.
Horch, J. C. (1916). “Proefnemingen met een watervijzel.” De Ingenieur, 49, 945–954.
Kantert, P. (2008). Praxishandbuch Schneckenpumpe—Ratgeber und Entscheidungshilfe für Planer, Bauherren und Betreiber, 1st Ed., F. Hirthammer Verlag, München.
Kleemann, J., and Hellmann, D. H. (2003). “Gutachten zur Wirkungsgradbestimmung an einer Wasserkraftschnecke Fabrikat RITZ-ATRO.”, Lehrstuhl für Strömungs- und Verdrängermaschinen (professiorship), Fachbereich Maschinenbau und Verfahrenstechnik (Dept.), Technische Universität Kaiserslautern, Mai.
Koetsier, T., and Blauwendraat, H. (2004). “The archimedian screw-pump: A note on its invention and the development of theory.” Int. Symp. on History of Machines and Mechanisms: Proc., HMM2004, Marco Ceccarell, ed., Kluwer, Dordrecht, Netherlands.
Lashofer, A., Kaltenberger, F., and Pelikan, F. (2011). “Wie gut bewährt sich die Wasserkraftschnecke in der Praxis.” Wasserwirtschaft, 7–8, 76–82.
Muysken, J. (1932). “Berekening van het nuttig effect van de vijzel.” De Ingenieur, 21, 77–91.
Nagel, G., and Radlik, K.-A. (1988). Wasserförderschnecken—Planung, Bau und Betrieb von Wasserhebeanlagen, 1st Ed., Udo Pfriemer Buchverlag, Wiesbaden und Berlin.
Rorres, C. (2000). “The turn of the screw: Optimal design of an Archimedes screw.” J. Hydraul. Eng., 126(1), 72–80.
Rühlmann, M. (1862). Allgemeinen Maschinenlehre, 1st Ed., Verlag von C.A. Schwetschke und Sohn, Braunscheig.
Schmalz, W. (2010). “Untersuchungen zum Fischabstieg und Kontrolle möglicher Fischschäden durch die Wasserkraftschnecke an der Wasserkraftanlage Walkmühle an der Werra in Meiningen—Fischökologische und Limnologische Untersuchungsstelle Südthüringen.”, Thüringer Landesanstalt für Umwelt und Geologie, Jena.
Simms, D. L. (2010a). “Adventures of an innovation over two millenia: The water-screw and its variants: Part I. Origins and designs.” Atti Della Fondazione Giorgio Ronchi, LXV(2), 197–215.
Simms, D. L. (2010b). “Adventures of an innovation over two millenia: The water-screw and its variants: Part II. In and out of use.” Atti Della Fondazione Giorgio Ronchi, LXV(5), 643–678.
Simms, D. L. (2010c). “Adventures of an innovation over two millenia: The water-screw and its variants: Part III. Back in uses.” Atti Della Fondazione Giorgio Ronchi, LXV(2), 197–215.
Weisbach, J. (1855). Lehrbuch der Ingenieur- und Maschinen Mechanik, 1st Ed., Verlag von Friedrich Vieweg und Sohn, Braunscheig.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Feb 8, 2012
Accepted: Jul 6, 2012
Published online: Jul 23, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.