Sand Transport over an Immobile Gravel Substrate
Publication: Journal of Hydraulic Engineering
Volume 139, Issue 2
Abstract
Experiments were conducted in a laboratory flume channel to evaluate the effects of increasing amounts of sand on its transport over and through an immobile coarse gravel bed. Detailed measurements of sand transport rate, bed texture, and bed topography were collected for four different discharges at approximately the same flow depth of 0.2 m for 11 different elevations of sand in the gravel bed. Sand transport was measured using both physical samples and a density cell. For a given flow rate, increases in the elevation of sand relative to gravel resulted in decreases of bed shear stress from 32–44% and increases in sand transport by three orders of magnitude. For the highest two discharges, the sand merged into a small number of long and low bed forms that translated through and over the gravel bed. A collapse of the transport data was accomplished by relating the sand transport rate to the bed shear stress scaled by the cumulative probability distribution function of the gravel surface evaluated at the height of the mean sand bed.
Get full access to this article
View all available purchase options and get full access to this article.
References
Aberle, J., Koll, K., and Dittrich, A. (2008). “Form induced stresses over rough gravel-beds.” Acta Geophys., 56(3), 584–600.
Almedeij, J. H., Diplas, P., and Al-Ruwaih, F. (2006). “Approach to separate sand from gravel for bed-load transport calculations in streams with bimodal sediment.” J. Hydraul. Eng., 132(11), 1176–1185.
Alonso, C. V., Theurer, F. D., and Zachmann, D. W. (1996). “Sediment intrusion and dissolved-oxygen transport model—SIDO.” Technical Rep., USDA-ARS National Sedimentation Laboratory, Oxford, MS.
Bouguet, J.-Y. (2008). “Camera calibration toolbox for Matlab®.”〈http://www.vision.caltech.edu/bouguetj/calib_doc/index.html〉 (Jul. 2, 2008).
Manes, C., Pokrajac, D., and McEwan, I. (2007). “Double-averaged open-channel flows with small relative submergence.” J. Hydraul. Eng., 133(8), 896–904.
Chiew, Y. M., and Parker, G. (1994). “Incipient motion on non-horizontal slopes.” J. Hydraul. Res., 32(5), 649–660.
Cooper, J. R., and Tait, S. J. (2008). “The spatial organization of time-averaged streamwise velocity and it correlation with the surface topography of water-worked gravel beds.” Acta Geophys., 56(3), 614–641.
Curran, J. C., and Wilcock, P. R. (2005). “Effect of sand supply on transport rates in a gravel-bed channel.” J. Hydraul. Eng., 131(11), 961–967.
Einstein, H. A. (1950). “The bed load function for sediment transportation in open channel flows.”, Soil Conservation Service, U.S. Dept. of Agriculture, Washington, DC.
Ferguson, R. I., Prestegaard, K. L., and Ashworth;, P. J. (1989). “Influence of sand on hydraulics and gravel transport in a braided gravel bed river.” Water Resour. Res., 25(4), 633–643.
Garcia, M. H. (2008). “Sediment transport and morphodynamics.” Chapter 2, Sedimentation engineering, processes, measurements, modeling, and practice, M. H. Garcia, ed., American Society of Civil Engineering, Reston, VA, 21–163.
Gibson, S., Abraham, D., Heath, R., and Schoellhamer, D. (2009). “Vertical gradational variability of fines deposited in a gravel framework.” Sedimentology, 56(3), 661–676.
Grams, P. E., and Wilcock, P. R. (2007). “Equilibrium entrainment of fine sediment from a coarse immobile bed.” Water Resour. Res., 43(10), W10420.
Hardy, R. J., Best, J. L., Land, S. N., and Carbonneau, P. E. (2009). “Coherent flow structures in a depth-limited flow over a gravel surface: The role of near-bed turbulence and influence of Reynolds number.” J. Geophys. Res., 114, F01003.
Hathaway, G. A. (1948). “Observations on channel changes, degradation, and scour below dams.”, Appendix 16, International Association on Hydraulic Structures, Stockholm, Sweden, 287–307.
Horton, J. K. (2001). “Flow and bedform dynamics of a bimodal sand-gravel mixture.” Ph.D. thesis, School of Earth Science, Univ. of Leeds, Leeds, UK.
Hsieh, W. W. (2009). Machine learning methods in the environmental sciences: Neural networks and kernels, Cambridge Univ. Press, Cambridge, UK.
Iseya, F., and Ikeda, H. (1987). “Pulsations in bedload transport rates induced by a longitudinal sediment sorting: A flume study using sand and gravel mixtures.” Geografiska Annaler, 69A(1), 15–27.
Kleinhans, M. G. (2002). “Sorting out sand and gravel: Sediment transport and deposition in sand-gravel bed rivers.” NGS 293, Netherlands Geographical Studies, Utrecht University, Utrecht, Netherlands.
Kuhnle, R. A. (1992). “Fractional transport rates of bed load on goodwin creek.” Dynamics of gravel bed rivers, P. Billi, R. D. Hey, C. R. Thorne, and P. Tacconi, eds., Wiley, Chichester, UK, 141–155.
Kuhnle, R. A. (1993). “Fluvial transport of sand and gravel mixtures with bimodal size distributions.” Sediment. Geol., 85(1–4), 17–24.
Kuhnle, R. A., Horton, J. K., Bennett, S. J., and Best, J. L. (2006). “Bed forms in bimodal sand-gravel sediments: Laboratory and field analysis.” Sedimentology, 53(3), 631–654.
Lane, S. N., James, T. D., and Crowell, M. D. (2000). “Application of digital photogrammetry to complex topography for geomorphological research.” Photogramm. Rec., 16(95), 793–821.
Leica Geosystems. (2002). IMAGINE OrthoBASE user’s guide, GIS and Mapping Division, Atlanta.
Lisle, T. E., and Lewis, J. (1992). “Effects of sediment transport on survival of salmonid embryos in a natural stream: A simulation approach.” Can. J. Fish. Aquat. Sci., 49(11), 2337–2344.
McLean, S. R., and Nikora, V. I. (2006). “Characteristics of turbulent uni-directional flow over rough beds: Double-averaging perspective with particular focus on sand dunes and gravel beds.” Water Resour. Res., 42(10), W10409.
Mignot, E., Barthelemy, E., and Hurther, D. (2009). “Double-averaging analysis and local flow characterization of near-bed turbulence in gravel-bed channel flows.” J. Fluid Mech., 618(1), 279–303.
Miller, M. C., McCave, I. N., and Komar, P. D. (1977). “Threshold of sediment motion under unidirectional currents.” Sedimentology, 24(4), 507–527.
Nikora, V., Goring, D., McEwan, I., and Griffiths, G. (2001). “Spatially averaged open-channel flow over rough bed.” J. Hydraul. Eng., 127(2), 123–133.
Nikora, V., McEwan, I., McLean, S., Coleman, S., Pokrajec, D., and Walters, R. (2007a). “Double-averaging concept for rough-bed open-channel and over-land flows: Theoretical background.” J. Hydraul. Eng., 133(8), 873–883.
Nikora, V., et al. (2007b). “Double-averaging concept for rough-bed open-channel and over-land flows: Applications.” J. Hydraul. Eng., 133(8), 884–895.
Papanicolaou, A. N., Dermisis, D. C., and Elhakeem, M. (2011). “Investigating the role of clasts on the movement of sand in gravel bed rivers.” J. Hydraul. Eng., 137(9), 871–883.
Parker, G. (2008). “Transport of gravel and sediment mixtures.” Chapter 3, Sedimentation engineering, processes, measurements, modeling, and practice, M. H. Garcia, ed., American Society of Civil Engineering, Reston, VA, 165–251.
Parker, G., Klingemen, P. C., and McLean, P. G. (1982). “Bedload and size distribution in paved gravel-bed streams.” J. Hydraul. Div., 108(4), 544–571.
Pellachini, C. (2011). “Modelling fine sediment transport over an immobile gravel bed.” Ph.D. thesis, Univ. of Trento, Trento, Italy.
Raupach, M. R., Antonia, R. A., and Rajagopalan, S. (1991). Rough-wall turbulent boundary layers.” Appl. Mech. Rev., 44(1), 1–25.
Sambrook Smith, G. H. (1996). “Bimodal fluvial bed sediments: Origin, spatial extent and processes.” Prog. Phys. Geog., 20(4), 402–417.
Stoesser, T. (2010). “A physically realistic roughness closure scheme to simulate turbulent channel flow over rough beds within the framework of LES.” J. Hydraul. Eng., 136(10), 812–819.
Topping, D. J., Rubin, D. M., and Vierra, L. E. Jr. (2000). “Colorado River sediment transport 1. Natural sediment supply limitation and the influence of Glen Canyon Dam.” Water Resour. Res., 36(2), 515–542.
Tuijnder, A. P. (2010). “Sand in short supply, modelling of bedforms, roughness, and sediment transport in rivers under supply-limited conditions.” Ph.D. thesis, Univ. of Twente, Enschede, Netherlands.
Vanoni, V. A. (1975). “Sedimentation engineering.” ASCE manuals and reports on engineering practice—No. 54, American Society of Civil Engineers, Reston, VA.
Vanoni, V. A., and Brooks, N. H. (1957). “Laboratory studies of the roughness and suspended load of alluvial streams.” M.R.D. sediment series, No.11, California Institute of Technology Sedimentation Laboratory, U.S. Army Engineers Division, Pasadena, CA.
Wilcock, P. R., and Crowe, J. C. (2003). “A surface-based transport model for sand and gravel.” J. Hydraul. Eng., 129(2), 120–128.
Wilcock, P. R., and Kenworthy, S. T. (2002). “A two-fraction model for the transport of sand/gravel mixtures.” Water Resour. Res., 38(10), 12-1–12-12.
Wren, D. G., Langendoen, E. J., and Kuhnle, R. A. (2011). “Effect of sand addition on turbulent flow over an immobile gravel bed.” J. Geophys. Res., 116, F01018.
Wu, W., and Wang, S. S. Y. (2006). “Formulas for sediment porosity and settling velocity.” J. Hydraul. Eng., 132(8), 858–862.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Dec 13, 2011
Accepted: Jul 10, 2012
Published online: Jul 23, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.