Transient Friction in Pressurized Pipes. II: Two-Coefficient Instantaneous Acceleration–Based Model
This article is a reply.
VIEW THE ORIGINAL ARTICLEThis article has a reply.
VIEW THE REPLYPublication: Journal of Hydraulic Engineering
Volume 137, Issue 6
Abstract
The goal in the field of modeling of hydraulic transients is a comprehensive model for pipe networks that is computationally fast and accurate. The fastest models are the one-dimensional (1D) models that use instantaneous acceleration–based (IAB) properties, but unfortunately these models are not as accurate as the more demanding 1D convolution-based (CB) models or quasi two-dimensional models. Focusing on a single pipe, this paper investigates the fundamental behavior of the much more accurate 1D CB model to find two coefficients for use with the two-coefficient formulation of the much-used modified IAB (MIAB) model for complete closing of a downstream valve. Two coefficients are found based on the weighting function used in the CB model, and these coefficients vary along the pipe length. Simulations are compared with two experimental results from tests performed at University of Adelaide in Australia in 1995. The experimental results are for different initial Reynolds numbers of approximately 2,000 and 5,800. The results show very good agreement between simulations and experiments. The improvement of the MIAB model is not general, and for the time being, only complete closure of a downstream valve in a single pipeline at low Reynolds numbers has been investigated.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank Dr. Anton Bergant for granting access and permission to use the results from the experiments obtained from the transient test rig at University of Adelaide, Australia. All experimental results shown in this paper are printed with Dr. Bergant’s approval.
References
Bergant, A., and Simpson, A. R. (1995). “Water hammer and column separation measurements in an experimental apparatus.” Dept. of Civil and Environmental Engineering, Univ. of Adelaide, 51.
Bergant, A., Simpson, A. R., and Vitkovsky, J. (2001). “Developments in unsteady pipe flow friction modelling.” J. Hydraul. Res., 39(3), 249–257.
Bouazza, Z., and Brunelle, P. E. (2004). “A new friction model for transient pipe flows.” 9th Int. Conf. on Pressure Surges, BHR Group, Chester, UK.
Brunone, B., Ferrante, M., and Cacciamani, M. (2004). “Decay of pressure and energy dissipation in laminar transient flow.” J. Fluids Eng., 126, 928–934.
Brunone, B., and Golia, U. M. (2008). “Discussion of ‘Systematic evaluation of one-dimensional unsteady friction models in simple pipelines,’ by J. P. Vitkovsky, A. Bergant, A. R. Simpson, and M. F. Lambert.” J. Hydraul. Eng., 134(2), 282–284.
Brunone, B., Golia, U. M., and Greco, M. (1995). “Effects of two-dimensionality on pipe transients modeling.” J. Hydraul. Eng., 121(12), 906–912.
Brunone, B., Karney, B. W., Mecarelli, M., and Ferrante, M. (2000). “Velocity profiles and unsteady pipe friction in transient flow.” J. Water Resour. Plng. and Mgmt., 126(4), 236–244.
Ghidaoui, M. S., Axworthy, D. H., Zhao, M., and McInnis, D. A. (2001). “Closure to ‘Extended thermodynamics derivation of energy dissipation in unsteady pipe flow.’” J. Hydraul. Eng., 127(10), 888–890.
Ghidaoui, M. S., Mansour, S. G. S., and Zhao, M. (2002). “Applicability of quasi-steady and axisymmetric turbulence models in water hammer.” J. Hydraul. Eng., 128(10), 917–924.
Ghidaoui, M. S., Zhao, M., McInnis, D. A., and Axworthy, D. H. (2005). “A review of water hammer theory and practice.” Appl. Mech. Rev., 58(1-6), 49–75.
Grimshaw, R., Pelinovsky, D., and Pelinovsky, E. (2010). “Homogenization of the variable-speed wave equation.” Wave Motion, 47(8), 496–507.
Loureiro, D., and Ramos, H. (2003). “A modified formulation for estimating the dissipative effect of 1-D transient pipe flow.” Proc., Int. Conf. on Pumps, Electromechanical Devices and Systems, Cabrera and Cabrera, Jr., eds., Swets and Zeitlinger, Lisse, Netherlands.
Pezzinga, G. (2000). “Evaluation of unsteady flow resistances by quasi-2D or 1D models.” J. Hydraul. Eng., 126(10), 778–785.
Schohl, G. A. (1993). “Improved approximate method for simulating frequency-dependent friction in transient laminar flow.” J. Fluids Eng., 115(3).
Silva-Araya, W. F., and Chaudhry, M. H. (1997). “Computation of energy dissipation in transient flow.” J. Hydraul. Eng., 123(2), 108–115.
Storli, P.-T., and Nielsen, T. K. (2011). “Transient friction in pressurized pipes. I: Investigation of Zielke’s model.” J. Hydraul. Eng., 137(5), 577–584.
Suzuki, K., Taketomi, T., and Sato, S. (1991). “Improving Zielke’s method of simulating frequency-dependent friction in laminar liquid pipe flow.” J. Fluids Eng., 113, 569–573.
Trikha, A. K. (1975). “Efficient method for simulating frequency-dependent friction in transient liquid flow.” J. Fluids Eng., 97(1), 97–105.
Vardy, A. E., and Brown, J. M. B. (2003). “Transient turbulent friction in smooth pipe flows.” J. Sound Vib., 259(5), 1011–1036.
Vardy, A. E., and Hwang, K.-L. (1991). “Characteristics model of transient friction in pipes.” J. Hydraul. Res., 29(5), 669–684.
Vitkovsky, J. P. (2006). “Numerical error in weighting function-based unsteady friction models for pipe transients.” J. Hydraul. Eng., 132(7), 709–721.
Vitkovsky, J. P. (2008). “Closure to ‘Systematic evaluation of one-dimensional unsteady friction models in simple pipelines,’ by J. P. Vitkovsky, A. Bergant, A. R. Simpson, and, M. F. Lambert.” J. Hydraul. Eng., 134(2), 284–284.
Vitkovsky, J. P., Bergant, A., Simpson, A. R., and Lambert, M. F. (2006). “Systematic evaluation of one-dimensional unsteady friction models in simple pipelines.” J. Hydraul. Eng., 132(7), 696–708.
Vitkovsky, J. P., Stephens, M., Bergant, A., Lambert, M. F., and Simpson, A. R. (2004). “Efficient and accurate calculations of Zielke and Vardy-Brown unsteady friction in pipe transients.” 9th Int. Conf. on Pressure Surges, BHR Group, Chester, UK.
Wang, X.-J., Simpson, A. R., Lambert, M. F., Vitkovsky, J. P., and Liggett, J. A. (2003). “Simulation of transients in a looped laboratory pipe network,” Proc., Int. Conf. on Pumps, Electromechanical Devices and Systems. Cabrera and Cabrera, Jr., eds., Swets and Zeitlinger, Lisse, Netherlands.
Wylie, E. B., Streeter, V. L., and Suo, L. (1993). Fluid transients in systems, Prentice Hall, Englewood Cliffs, NJ.
Zielke, W. (1968). “Frequency-dependent friction in transient pipe flow.” J. Basic Eng., 90(1), 109–115.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Aug 26, 2009
Accepted: Nov 4, 2010
Published online: Nov 8, 2010
Published in print: Jun 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.