Wall Shear Stress in Transient Turbulent Pipe Flow by Local Velocity Measurement
Publication: Journal of Hydraulic Engineering
Volume 136, Issue 10
Abstract
The modeling of unsteady wall shear stress plays a crucial role in the analysis of fast transients in pressurized pipe systems, since it allows to evaluate transient energy dissipation properly. The main aim of this paper is to give a contribution to the understanding of transient pressurized flow dynamics in turbulent regime by measuring not only pressure but also the instantaneous axial velocity profile at two sections of the laboratory pipe. Specifically, by means of ultrasonic Doppler velocimetry—a completely nonintrusive technique—instantaneous velocity gradients at pipe wall are measured allowing to evaluate the time history of the actual wall shear stress by coupling velocity measurements to a two-zone stress model. As a result, the behavior of accelerating and decelerating flows with respect to the corresponding steady ones, i.e., with the same value of the discharge, is pointed out. Due to the characteristics of the laboratory pipe—a 352-m long high density polyethylene pipe—transients phenomena are investigated both at short and long time scales.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research has been jointly supported by the Italian Ministry of Education, University and Research (MIUR) under the Project of Relevant National Interest “Innovative criteria for the sustainable management of water resources in the water distribution systems,” and by Fondazione Cassa Risparmio Perugia.
References
Albar, A. (2000). “Effect of various terminal velocity equations on the result of friction loss calculation.” Terra et Aqua, 81, 13–21.
Berni, A. (2004). “Unsteady velocity profiles and energy dissipation in turbulent pipe flow.” Ph.D. thesis, Univ. of Perugia, Perugia, Italy.
Berni, A., Brunone, B., and Ferrante, M. (2003). “Turbulent velocity profiles in pressurized pipes by UDV.” Proc., Int. Conf. on Pumps, Electromechanical Devices and Systems Applied to Urban Water Management—PEDS 2003, E. Cabrera and E. Cabrera Jr., eds., Swets & Zeitlinger, Lisse, The Netherlands, Vol. I, 145–152.
Brunone, B. (1999). “Transient test-based technique for leak detection in outfall pipes.” J. Water Resour. Plann. Manage., 125, 302–306.
Brunone, B., Ferrante, M., and Cacciamani, M. (2004). “Decay of pressure and energy dissipation in laminar transient flow.” J. Fluids Eng., 126, 928–934.
Brunone, B., Golia, U. M., and Greco, M. (1991). “Some remarks on the momentum equation for fast transients.” Proc., Int. Meeting on Hydraulic Transients and Water Column Separation, E. Cabrera and M. A. Fanelli, eds., 201–209.
Brunone, B., Golia, U. M., and Greco, M. (1995). “Effects of two-dimensionality on pipe transients modelling.” J. Hydraul. Eng., 121(12), 906–912.
Brunone, B., Karney, B. W., Mecarelli, M., and Ferrante, M. (2000). “Velocity profiles and unsteady pipe friction in transient flow.” J. Water Resour. Plann. Manage., 126(4), 236–244.
Covas, D., Stoianov, I., Mano, J. F., Ramos, H., Graham, N., and Maksimovic, C. (2004). “The dynamic effect of pipe-wall viscoelasticity in hydraulic transients. Part I—Experimental analysis and creep characterization.” J. Hydraul. Res., 42, 516–530.
Covas, D., Stoianov, I., Mano, J. F., Ramos, H., Graham, N., and Maksimovic, C. (2005). “The dynamic effect of pipe-wall viscoelasticity in hydraulic transients. Part II—Model development, calibration and verification.” J. Hydraul. Res., 43, 56–70.
Daily, J. W., Hankey, W. L., Olive, R. W., and Jordan, J. M. (1956). “Resistance coefficients for accelerated and decelerated flows through smooth tubes and orifices.” Trans. of ASME, 78, 1071–1077.
Elgobashi, S. (1994). “On predicting particle-laden turbulent flows.” Appl. Sci. Res., 52, 309–329.
Ferrante, M., and Brunone, B. (2003). “Pipe system diagnosis and leak detection by unsteady-state tests. 1: Wavelet analysis.” Adv. Water Resour., 26, 107–116.
Ghidaoui, M. S., Mansour, S. G. S., and Zhao, M. (2002). “Applicability of quasi-steady and axisymmetric turbulence models in water hammer.” J. Hydraul. Eng., 128(10), 917–924.
Ghidaoui, M. S., Zhao, M., Mc Innis, D. A., and Axworthy, D. H. (2005). “A review of water hammer. Theory and practice.” Appl. Mech. Rev., 58, 49–76.
He, S., and Jackson, J. D. (2000). “A study of turbulence under conditions of transient flow in a pipe.” J. Fluid Mech., 408, 1–38.
Liggett, J. A., and Chen, L. -C. (1994). “Inverse transient analysis in pipe networks.” J. Hydraul. Eng., 120(8), 934–955.
Mohapatra, P. K., Chaudhry, M. H., Kassem, A. A., and Moloo, J. (2006). “Detection of a partial blockage in single pipelines.” J. Hydraul. Eng., 132(2), 200–206.
Nowak, M. (2002). “Wall shear stress measurement in a turbulent pipe flow using ultrasound doppler velocimetry.” Exp. Fluids, 33, 249–255.
Pezzinga, G. (1999). “Quasi-2D model for unsteady flow in pipe networks.” J. Hydraul. Eng., 125(7), 676–685.
Shuy, E. B. (1996). “Wall shear stress in accelerating and decelerating turbulent pipe flows.” J. Hydraul. Res., 34, 173–183.
Tanière, A., Oesterle, B., and Monnier, J. C. (1997). “On the behaviour of solid particles in a horizontal boundary layer with turbulence and saltation effects.” Exp. Fluids, 23, 463–471.
Vardy, A. E., and Brown, J. M. B. (1997). “Discussion to “Wall shear stress in accelerating and decelerating pipe flows”.” J. Hydraul. Res., 35, 137–139.
Vitkovsky, J., Bergant, A., Simpson, A. R., and Lambert, A. (2006). “Systematic evaluation of one-dimensional unsteady friction models in simple pipelines.” J. Hydraul. Eng., 132(7), 696–708.
Wang, X. -J., Lambert, M. F., Simpson, A. R., Liggett, J. A., and Vitkovsky, J. P. (2002). “Leak detection in pipelines using the damping of fluid transients.” J. Hydraul. Eng., 128(7), 697–711.
Willemetz, J. C. (2000). DOP1000 application notes, Signal Processing S.A., CH.
Wunderlich, T., and Brunn, P. O. (2000). “A wall layer correction for ultrasound measurement in tube flow: Comparison between theory and experiment.” Flow Meas. Instrum., 11, 63–69.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Mar 24, 2009
Accepted: Mar 27, 2010
Published online: Mar 30, 2010
Published in print: Oct 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.