Riprap Stability: Transverse and Longitudinal versus Continuous Protections
Publication: Journal of Hydraulic Engineering
Volume 135, Issue 6
Abstract
An experimental study was conducted to determine the influence of length, width, and protrusion of noncontinuous riprap protections on shear failure conditions. The incipient motion of particles as a failure criterion and the reference transport method as the threshold of motion were used. In each test, riprap transport rates were measured at different time intervals using a sediment trap placed immediately downstream from the test reach so that time dependence could be well described. Results reveal that incipient motion conditions of transverse (cross-sectional) protections are strongly influenced by both the protrusion and length of bed protection, which indicates that stability significantly increases as protection length increases and decreases as protrusion increases. In the case of longitudinal protections, almost the same failure conditions were found as in the case of continuous protection. Furthermore, these conditions are unrelated to the width of the protection. A coefficient to correct design formulas obtained by other authors is proposed to take into account the effect of the geometry of transverse protections on their stability.
Get full access to this article
View all available purchase options and get full access to this article.
References
Almeida, G. A. M. (2007). “Influence of geometry on the shear failure of a fluvial riprap protection. Experimental study.” Ph.D. thesis, Technical Univ. of Catalonia, Barcelona, Spain.
Buffington, J. M., and Montgomery, D. R. (1997). “A systematic analysis of eight decades of incipient motion studies, with special reference to gravel-bedded rivers.” Water Resour. Res., 33, 1993–2029.
Chen, X., and Chiew, Y.-M. (2003). “Response of velocity and turbulence to sudden change of bed roughness in open-channel flow.” J. Hydraul. Eng., 129, 35–43.
Coleman, S. E., Melville, B. W., and Gore, L. (2003) “Fluvial entrainment of protuding fractured rock.” J. Hydraul. Eng., 129, 872–884.
Einstein, H. A. (1942). “Formulae for the transportation of bedload.” Trans. Am. Soc. Civ. Eng., 107, Paper No. 2140, 561–573.
Einstein, H. A. (1950). “The bed-load function for sediment transport in open channel flows.” Technical Rep., U.S. Dept. of Agriculture, Soil Conservation Service, Washington, D.C.
Escarameia, M., and May, R. W. P. (1995). “Stability of riprap and concrete blocks in highly turbulent flows.” Proc. Inst. Civ. Eng., Waters. Maritime Energ., 112, 227–237.
Fenton, J. D., and Abbott, J. E. (1977). “Initial movement of grains on a stream bed: The effect of relative protrusion.” Proc. Roy. Soc. Lond. A Math. Phys. Eng. Sci., 352, 523–537.
Fredsoe, J., Summer, B. M., Laursen, T. S., and Pedersen, C. (1993). “Experimental investigation of wave boundary layers with a sudden change in roughness.” J. Fluid Mech., 252, 117–145.
Froehlich, D. C., and Benson, C. A. (1996). “Sizing dumped rock riprap.” J. Hydraul. Eng., 122, 389–396.
Izbash, S. V. (1935). Construction of dams by dumping stones in flowing water, I z v. N I I G, Moscow-Leningrad.
James, C. S. (1989). “Prediction of entrainment conditions for nonuniform noncohesive sediments.” J. Hydraul. Res., 28, 25–41.
Martín-Vide, J. P., and Andreatta, A. (2006). “Disturbance caused by bed sills on the slopes of steep streams.” J. Hydraul. Eng., 132, 1186–1194.
Maynord, S. T., Ruff, J. F., and Abt, S. R. (1987). “Riprap design.” J. Hydraul. Eng., 115, 937–949.
Nezu, I., and Tominaga, A. (1994). “Response of velocity and turbulence to abrupt changes from smooth to rough beds in open-channel flow.” Proc. Symp. of Fundamentals and Advances in Hydraulic Measurements and Experimentation, 195–204.
Parker, G., Klingeman, P. C., and McLean, D. G. (1982). “Bedload and size distribution in paved gravel-bed streams.” J. Hydr. Div., 108, 544–571.
Pilarczyk, K. W. (1998). Dikes and revetments: Design, maintenance and safety assessment, Balkema, Rotterdam, The Netherlands.
Schiereck, G. J. (2000). Introduction to bed, bank and shore protection, VSSD, Delft, The Netherlands.
Shvidchenko, A. B., and Pender, G. (2000). “Flume study of the effect of relative depth on the incipient motion of coarse uniform sediments.” Water Resour. Res., 36, 619–628.
Stevens, M. A., Simons, D. B., and Lewis, G. L. (1976). “Safety factors for riprap protections.” J. Hydr. Div., 102, 637–655.
Wilcock, P. R. (1988). “Methods for estimating the critical shear stress of individual fractions in mixed-size sediment.” Water Resour. Res., 24, 1127–1135.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 135 • Issue 6 • June 2009
Pages: 447 - 456
Copyright
© 2009 ASCE.
History
Received: May 25, 2007
Accepted: Nov 10, 2008
Published online: Feb 6, 2009
Published in print: Jun 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.