Modeling Fractures and Barriers as Interfaces for Porous Flow with Extended Finite-Element Method
Publication: Journal of Hydrologic Engineering
Volume 23, Issue 7
Abstract
Fractures and barriers exist in hydrocarbon reservoirs. It is essential to evaluate the influence of fractures and barriers on porous flow in many research domains like petroleum engineering and disposal of nuclear waste. Fractures can play the role of highly conductive channels in the flow fields, while barriers can act as the walls blocking fluids. The extended finite-element method (XFEM) is effective in addressing the porous flow problems involving arbitrary geometries of fractures and barriers that do not need to conform to the mesh. This paper uses the XFEM to deal with the discontinuity problems of porous flow caused by highly permeable fractures, lowly permeable fractures, and impermeable barriers. The authors further improve the previous fracture-matrix transfer flow equations by differentiating the pressure at the fracture center from the average pressure in the fracture cross section, and finally combine the fracture-matrix transfer flow equations with a boundary layer theory to better model fluid flow in the case of anisotropically permeable fractures. Numerical results demonstrate that the XFEM is effective and applicable in solving the discontinuity problems of porous flow due to barriers and fractures. In addition, the introduction of the boundary layer can improve the accuracy in modeling anisotropically permeable fractures in which the tangential permeability is far larger than the normal permeability.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research is supported by the Major Program of the National Natural Science Foundation of China (Grant No. 51490653) and the National Basic Research Program of China (Grant No. 2013CB228004).
References
Cherubini, Y., Cacace, M., Blöcher, G., and Scheck-Wenderoth, M. (2013). “Impact of single inclined faults on the fluid flow and heat transport: Results from 3-D finite element simulations.” Environ. Earth Sci., 70(8), 3603–3618.
Chessa, J., and Belytschko, T. (2003). “An extended finite element method for two-phase fluids.” J. Appl. Mech., 70(1), 10–17.
Cipolla, C. L., Lolon, E. P., Erdle, J. C., and Rubin, B. (2010). “Reservoir modeling in shale-gas reservoirs.” SPE Reservoir Eval. Eng., 13(4), 848–854.
Gale, J. F., Reed, R. M., and Holder, J. (2007). “Natural fractures in the Barnett Shale and their importance for hydraulic fracture treatments.” AAPG Bull., 91(4), 603–622.
Guo, B., Yu, X., and Khoshgahdam, M. (2009). “A simple analytical model for predicting productivity of multifractured horizontal wells.” SPE Reservoir Eval. Eng., 12(6), 879–885.
Jiang, Y., Zhao, J., Li, Y., Jia, H., and Zhang, L. (2014). “Extended finite element method for predicting productivity of multifractured horizontal wells.” Math. Problems Eng., 2014(6), 1–9.
Karimi-Fard, M., Durlofsky, L. J., and Aziz, K. (2004). “An efficient discrete-fracture model applicable for general-purpose reservoir simulators.” SPE J., 9(2), 227–236.
Karimi-Fard, M., and Firoozabadi, A. (2001). “Numerical simulation of water injection in 2D fractured media using discrete-fracture model.” SPE Reservoir Eval. Eng., 4, 117126.
Lamb, A. R., Gorman, G., Gosselin, O. R., and Onaisi, A. (2010). “Coupled deformation and fluid flow in fractured porous media using dual permeability and explicitly defined fracture geometry.” SPE EUROPEC/EAGE Annual Conf. and Exhibition, Society of Petroleum Engineers, Barcelona, Spain.
Li, L., and Lee, S. H. (2008). “Efficient field-scale simulation of black oil in a naturally fractured reservoir through discrete fracture networks and homogenized media.” SPE Reservoir Eval. Eng., 11(4), 750–758.
Li, Y., Jiang, Y., Zhao, J., Liu, C., and Zhang, L. (2015). “Extended finite element method for analysis of multi-scale flow in fractured shale gas reservoirs.” Environ. Earth Sci., 73(10), 6035–6045.
Martin, V., Jaffré, J., and Roberts, J. E. (2005). “Modeling fractures and barriers as interfaces for flow in porous media.” SIAM J. Sci. Comput., 26(5), 1667–1691.
Medeiros, F., Jr. (2007). “Semi-analytical pressure-transient model for complex well-reservoir systems.” Ph.D. thesis, Colorado School of Mines, Golden, CO.
Moës, N., Cloirec, M., Cartraud, P., and Remacle, J. F. (2003). “A computational approach to handle complex microstructure geometries.” Comput. Methods Appl. Mech. Eng., 192(28–30), 3163–3177.
Moës, N., Dolbow, J., and Belytschko, T. (1999). “A finite element method for crack growth without remeshing.” Int. J. Numer. Methods Eng., 46(1), 131–150.
Mohammadnejad, T., and Khoei, A. R. (2013). “An extended finite element method for hydraulic fracture propagation in deformable porous media with the cohesive crack model.” Finite Elem. Anal. Des., 73(15), 77–95.
Ochoa-González, G. H., Carreón-Freyre, D., Cerca, M., and López-Martínez, M. (2015). “Assessment of groundwater flow in volcanic faulted areas. A study case in Queretaro, Mexico.” Geofísica Int., 54(3), 199–220.
Ozkan, E., Brown, M. L., Raghavan, R., and Kazemi, H. (2011). “Comparison of fractured-horizontal-well performance in tight sand and shale reservoirs.” SPE Reservoir Eval. Eng., 14(2), 248–259.
Réthoré, J., Borst, R. D., and Abellan, M. A. (2007). “A two-scale approach for fluid flow in fractured porous media.” Int. J. Numer. Methods Eng., 71(7), 780–800.
Réthoré, J., De Borst, R., and Abellan, M. A. (2008). “A two-scale model for fluid flow in an unsaturated porous medium with cohesive cracks.” Comput. Mech., 42(2), 227–238.
Schlichting, H., and Gersten, K. (1979). Boundary-layer theory, McGraw-Hill, New York.
Sheng, M., Li, G., Shah, S. N., and Jin, X. (2012). “Extended finite element modeling of multi-scale flow in fractured shale gas reservoirs.” SPE Annual Technical Conf. and Exhibition, Society of Petroleum Engineers, Richardson, TX.
Sukumar, N., Chopp, D. L., Moës, N., and Belytschko, T. (2001). “Modeling holes and inclusions by level sets in the extended finite-element method.” Comput. Methods Appl. Mechanics Eng., 190(46), 6183–6200.
Vilarrasa, V., Carrera, J., Jurado, A., Pujades, E., and Vázquez-Suné, E. (2011). “A methodology for characterizing the hydraulic effectiveness of an annular low-permeability barrier.” Eng. Geol., 120(1), 68–80.
Zhang, R., Zhang, L. H., Wang, R. H., Zhao, Y. L., and Huang, R. (2016a). “Simulation of a multistage fractured horizontal well with finite conductivity in composite shale gas reservoir through finite-element method.” Energy Fuels, 30(11), 9036–9049.
Zhang, R., Zhang, L. H., Wang, R. H., Zhao, Y. L., and Zhang, D. L. (2016b). “Research on transient flow theory of a multiple fractured horizontal well in a composite shale gas reservoir based on the finite-element method.” J. Nat. Gas Sci. Eng., 33, 587–598.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Nov 10, 2016
Accepted: Oct 17, 2017
Published online: Apr 20, 2018
Published in print: Jul 1, 2018
Discussion open until: Sep 20, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.