Approach to Digital Elevation Model Correction by Improving Channel Conveyance
Publication: Journal of Hydrologic Engineering
Volume 20, Issue 5
Abstract
Digital elevation models (DEM) are important inputs for topography in modeling floods for remote and inaccessible regions. DEMs often lack in accuracy near water bodies and rivers. The objective of this research is to present a DEM correction technique to improve the accuracy of flood simulation and inundation mapping. The key feature of this method is the variability in thalweg (deepest point along a cross section) locations and depth based on the river meandering, width, and side slope. The DEM correction technique is demonstrated by adjusting a national elevation dataset (NED) DEM along the Cumberland River near Nashville in Tennessee. The original (base DEM) and modified DEMs are used as main input of the 1D Hydrologic Engineering Center River Analysis System (HEC-RAS) model and corresponding performances were analyzed. The model using surveyed topography was calibrated for a high flood event (May 2010) and later validated for an intermediate flood event (2003), a high flood event (May 2010), and a low flood event (May 2013) using the modified DEM. It was found that the model with base DEM is capable of simulating at a very high stage but fails during low and intermediate stages. The applicability of base DEM is also limited for any event above 127 m and with specific biases. The model using modified DEM could be used for simulating large arrays of flow events. The root mean square error (RMSE) for simulated stage using modified DEM for 2003, 2010, and 2013 with the observed stage were 0.86, 0.23 and 0.52 m respectively. Comparison of simulated flood map for the May 2010 flood event using modified and base DEMs with observed flood extent showed errors of 2.66% (overestimate) and 13.38% (overestimate), respectively. The preliminary application of the DEM correction technique thus showed significant improvements in the quality of DEM data with corresponding increase of the HEC-RAS model accuracy.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge Civil and Environmental Engineering and the Center for Utilization, Management and Protection of Water Resources at Tennessee Technological University for financial support and the U.S. Army Corps of Engineers for providing data and models.
References
Brandt, S. A., and Lim, N. J. (2012). “Importance of river bank and floodplain slopes on the accuracy of flood inundation mapping.” Proc., Int. Conf. on Fluvial Hydraulics, Vol. 2, R. E. Murillo Muñoz, ed., CRC Press/Balkema (Taylor and Francis), Leiden, Netherlands, 1015–1020.
Casas, A., Benito, G., Thorndycraft, V. R., and Rico, M. (2006). “The topographic data source of digital terrain models as a key element in the accuracy of hydraulic flood modeling.” Earth Surf. Process Landforms, 31(4), 444–456.
Gesch, D., Oimoen, M., Greenlee, S., Nelson, C., Steuck, M., and Tyler, D. (2002). “The national elevation dataset.” Photogramm. Eng. Remote Sens., 68(1), 5–11.
Gesch, D. B. (2007). “The national elevation dataset.” Digital elevation model technologies and applications: The DEM user’s manual, 2nd Ed., D. Maune, ed., American Society for Photogrammetry and Remote Sensing, Bethesda, MD, 99–118.
Gichamo, T. Z., Popescu, I., Jonoski, A., and Solomatine, D. (2011). “River cross-section extraction from the ASTER global DEM for flood modeling.” Environ. Modell. Softw., 31, 37–46.
Kalyanapu, A., Hossain, A. K. M. A., Kim, J., Yigzaw, W., Hossain, F., and Shum, C. K. (2013). “Investigating the downstream flood hazards on American River due to changes in probable maximum flood due to effects of artificial reservoir size and land use/land cover patterns.” Earth Interact., 17, 1–24.
Merwadeand, V. M., and Maidment, D. (2004). A GIS framework for describing river channel bathymetry, Texas Water Development Board, Austin, TX.
Monmonier, M. (1991). How to lie with maps, University of Chicago Press, Chicago.
Nardi, F., Biscarini, C., Di Francesco, S., Manciola, P., and Ubertini, L. (2013). “Comparing a large-scale dem-based floodplain delineation algorithm with standard flood maps: The Tiber river basin case study.” Irrig. Drain., 62(S2), 11–19.
Nardi, F., Grimaldi, S., Santini, M., Petroselli, A., and Ubertini, L. (2008). “Hydrogeomorphic properties of simulated drainage patterns using digital elevation models: The flat area issue.” Hydrol. Sci. J., 53(6), 1176–1193.
Nardi, F., Vivoni, E. R., and Grimaldi, S. (2006). “Investigating a floodplain scaling relation using a hydrogeomorphic delineation method.” Water Resour. Res., 42, W09409.
National Elevation Dataset. (2014). 〈http://ned.usgs.gov/〉 (Jul. 2014).
National Weather Service (NWS). (2014). Hydrologic information center—Flood loss data, 〈http://www.nws.noaa.gov/hic/〉 (Jul. 2014).
Price, R. (2009). “An optimized routing model for flood forecasting.” Water Resour. Res., 45(2), W02426.
U.S. Army Corps of Engineers (USACE). (2010a). HEC-RAS, river analysis system, user’s manual.
U.S. Army Corps of Engineers (USACE). (2010b). May 2010 Nashville flood event after-action draft report, Great Lakes and Ohio River Division, Cincinnati.
U.S. Army Corps of Engineers (USACE). (2012). HEC-GeoRAS GIS tools for support of HE-RAS using ArcGIS® 10, user’s manual.
U.S. Geological Survey (USGS). (1995). National mapping program, Technical instructions Part 2—Specifications, Standards for Digital Elevation Models, U.S. Dept. of the Interior.
U.S. Geological Survey (USGS). (2014). “National water information system: Web interface: USGS surface-water data for tennessee.” 〈http://waterdata.usgs.gov/tn/nwis/sw/〉 (Jul. 2014).
U.S. Geological Survey (USGS) National Map. (2014). “USGS TNM 2.0 viewer.” 〈http://viewer.nationalmap.gov/viewer/〉 (Jun. 21, 2014).
Wright, J. (1942). “Map makers are human: Comments on the subjective in maps.” Geograph. Rev., 32(4), 527–544.
Yamazaki, D., Baugh, C. A., Bates, P. D., Kanae, S., Alsdorf, D. E., and Oki, T. (2012). “Adjustment of a spaceborne DEM for use in floodplain hydrodynamic modeling.” J. Hydrol., 436–437(2012), 81–91.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Nov 14, 2013
Accepted: May 1, 2014
Published online: Aug 19, 2014
Discussion open until: Jan 19, 2015
Published in print: May 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.