Modified Green-Ampt Infiltration Model for Steady Rainfall
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Hydrologic Engineering
Volume 19, Issue 9
Abstract
The Green-Ampt equation describing the infiltration of water into soil requires that the rainfall intensity is greater than the infiltration capacity of the soil at all times. The well-known Mein-Larson model modifies the Green-Ampt equation and attempts to avoid this restriction for infiltration of water into a homogeneous soil under rainfall of constant intensity. The rainfall intensity is considered to be less than the infiltration capacity of the soil in the initial phases of a storm. The Mein-Larson model assumes that until the time to ponding of water over the soil surface, the infiltration rate is constant and equals the rainfall intensity. This study shows that the Mein-Larson model underestimates the ponding time and that the cumulative infiltration predicted by the model is always less than the cumulative infiltration potential of the soil. To avoid these drawbacks, an alternative modification of the Green-Ampt equation is presented. In the proposed modification, the ponding time is considered to occur when the cumulative infiltration potential of the soil is fully satisfied. Beyond the ponding time, both the infiltration rate and cumulative infiltration follow the classical Green-Ampt equations. The modification is achieved by using asymptotic matching technique to render the model applicable within a wide range of rainfall rates greater or less than the soil infiltration capacities. This modification will help extend the ability to analyze hydrologic problems related to water infiltration into soil in different environments of high or low rainfall intensities. Case studies are provided to demonstrate the behavior of the proposed model and compare it with the Mein-Larson modification.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ahuja, L. R., and Ross, J. O. (1983). “A new Green-Ampt model for infiltration through a surface seal permitting transient parameters below the seal.” Proc., National Conf. on Advances in Infiltration, Vol. 11–83, American Society of Agricultural Engineers, 147–162.
Almedeij, J. (2010). “Modeling shields diagram by asymptotic matching.” Kuwait J. Sci., 37(2B), 43–58.
Bouwer, H. (1978). Groundwater hydrology, McGraw-Hill, New York.
Brakensiek, D. L., and Onstad, C. L. (1977). “Parameter estimation of the Green and Ampt infiltration equation.” Water Resour. Res., 13(6), 1009–1012.
Broadbridge, P., and White, I. (1987). “Time to ponding: Comparison of analytic, quasi-analytic, and approximate predictions.” Water Resour. Res., 23(12), 2302–2310.
Chow, V. T., Maidment, D. R., and Mays, L. W. (1988). Applied hydrology, McGraw Hill, New York.
Chu, S. T. (1978). “Infiltration during an unsteady rain.” Water Resour. Res., 14(3), 461–466.
Chu, S. T. (1987). “Generalized Mein-Larson infiltration model.” J. Irrig. Drain. Eng., 155–162.
Esen, I. I. (1989). “Estimation of Green-Ampt parameters from infiltrometer data.” Soil Sci., 147(4), 231–237.
Fok, Y. S. (1975). “A comparison of the Green-Ampt and Philip two-term infiltration equations.” Trans. Am. Soc. Agric. Biol. Eng., 18(6), 1073–1075.
Gowdish, L., and Munoz-Carpena, R. (2009). “An improved Green-Ampt infiltration and redistribution method for uneven multistorm series.” Vadose Zone J., 8(2), 470–479.
Green, W. H., and Ampt, C. A. (1911). “Studies on soil physics—1. The flow of air and water through soils.” J. Agric. Sci., 4(1), 1–24.
Kale, R. V., and Sahoo, B. (2011). “Green-Ampt infiltration models for varied field conditions: A revisit.” Water Resour. Manage., 25(14), 3505–3536.
Langhans, C., Engels, L., Tegenbos, L., Govers, G., and Diels, J. (2010). “How useful are Green-Ampt parameters derived from small rainfall simulation plots for modeling runoff at different plot lengths?” EGU General Assembly, Geophysical Research Abstracts.
Li, R. M., Simons, D. B., and Stevens, M. A. (1976). “Solutions to Green-Ampt infiltration equation.” J. Irrig. Drain. Div., 102(2), 239–248.
Malik, R. S., Sharma, S. K., and Dhankar, J. S. (1985). “Design of a sensitive and practical closed-top infiltrometer.” Soil Sci., 139(5), 452–457.
Mein, R. G., and Larson, C. L. (1973). “Modeling infiltration during steady rain.” Water Resour. Res., 9(2), 384–394.
Rawls, W. J., Brakensiek, D. L., and Miller, N. (1983). “Green-Ampt parameters from soils data,” J. Hydraul. Div. Am. Soc. Civil Eng., 62–70.
Rawls, W. J., Stone, J. J., and Brakensiek, D. L. (1989). “Infiltration.” USDA-Water Erosion Prediction Project: Hillslope Profile Model Documentation, NSERL Rep. No. 2, L. J. Lane and M. A. Nearing, eds., National Soil Erosion Research Laboratory, USDA-ARS, West Lafayette, IN.
Rossman, L. A. (2010). “Stormwater management model, user’s manual, version 5.0,”, U.S. Environmental Protection Agency, Washington, DC.
Stone, J. J., Hawkins, R. H., and Shirley, E. D. (1994). “Approximate form of Green-Ampt infiltration equation.” J. Irrig. Drain. Eng., 128–137.
United States Environmental Protection Agency (USEPA). (1995). SWMM windows interface user’s manual, Washington, DC.
Viessman, W., and Lewis, G. L. (2011). Introduction to hydrology, 5th Ed., Pearson Education, Upper Saddle River, NJ.
Voller, V. R. (2011). “On a fractional derivative form of the Green-Ampt infiltration model.” Adv. Water Resour., 34(2), 257–262.
Information & Authors
Information
Published In
Journal of Hydrologic Engineering
Volume 19 • Issue 9 • September 2014
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 19, 2012
Accepted: Nov 26, 2013
Published online: Nov 28, 2013
Published in print: Sep 1, 2014
Discussion open until: Nov 4, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.