Spillway Collapse of the Montedoglio Dam on the Tiber River, Central Italy: Data Collection and Event Analysis
Publication: Journal of Hydrologic Engineering
Volume 19, Issue 6
Abstract
A large number of dams were built in Italy in the first decades of the last century to supply the needs of industrial, electric power, agricultural, and drinking purposes. Among them, the Montedoglio dam, an important reservoir on the Tiber River located in central Italy, with a drainage area of and a maximum storage volume of about . The dam is an earth-fill structure with overfall spillway partly controlled by two sluice gates. On December 29, 2010, due to the partial sudden collapse of the spillway, a huge volume of water flooded the valley below the dam, severely damaging the territory, but luckily without causalities. Considering that scarce data are available for this type of event worldwide, this paper aims to illustrate the collected data of the studied event in terms of reservoir levels, using a discharge hydrograph observed at downstream gauged river sites and the flooded valley area. This study aims also to simulate the breach evolution and the downstream propagation of the outflow. Considering the Nash-Sutcliffe performance measure in simulation of the recorded reservoir levels, the time of breach formation and the corresponding discharge coefficient are obtained through an optimization procedure, yielding values of 0.02 h and 0.15, respectively. Finally, the Manning roughness coefficients for the downstream main channel and the floodplain areas are detected through a methodology based on one-dimensional hydraulic modeling by considering different flooding scenarios of valley.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors are thankful to the Water Agency for Umbria and Tuscany Region (EAUT) for providing the data.
References
Ackerman, C. T., Jensen, M. R., and Brunner, G. W. (2010). “Geospatial capabilities of HEC-RAS for model development and mapping.” Proc., 2nd Joint Federal Interagency Conf. (9th Federal Interagency Sedimentation Conf. and 4th Federal Interagency Hydrologic Modeling Conf.) (CD-ROM), Las Vegas, NV.
Aronica, G., Bates, P. D., and Horritt, M. S. (2002). “Assessing the uncertainty in distributed model predictions using observed binary pattern information within GLUE.” Hydrol. Processes, 16(10), 2001–2016.
Bani, B., et al. (2006). “Experimental release from the bottom outlets of the 460 Montedoglio dam.”, Irrigation Agency of Umbria and Tuscany (in Italian).
Berni, N., et al. (2009). “Coupling hydrological and hydraulic modeling for a reliable flood risk mitigation activities in the Upper-Medium Tiber River basin.” EGU2009 European Geosciences Union—General assembly 2009, Vienna, Austria, Vol. 11, EGU2009-9498-3.
Castorani, A., and Moramarco, T. (1995). “Selecting the optimal design flood.” Int. J. Hydropower Dams, 2(4), 74–80.
Charles, J. A., and Tedd, P. (2000). “Reservoir safety: Review of publications 1999–2000.” Dams and Reservoirs, 10(3), 38–44.
Fread, D. L. (1977). “The development and testing of a dam-break flood forecasting model.” Proc., Dam-Break Flood Routing Workshop, Water Research Council, 164–197.
Gebregiorgis, A. S., and Hossain, F. (2012). “Hydrological risk assessment of old dams: Case study on Wilson Dam of Tennessee River Basin.” J. Hydrol. Eng., 201–212.
Greenbaum, N. (2007). “Assessment of dam failure flood and a natural, high-magnitude flood in a hyperarid region using paleoflood hydrology, Nahal Ashalim catchment, Dead Sea, Israel.” Water Resour. Res., 43(2), W02401.
Jandora, J., and Ríha, J. (2008). The failure of embankment dams due to overtopping, Brno Univ. of Technology, Faculty of Civil Engineering, Institute of Water Structures, Vutium Press, Brno, Czech Republic.
MacDonald, T., and Langridge-Monopolis, J. (1984). “Breaching characteristics of dam failures.” J. Hydraul. Eng., 567–586.
MATLAB [Computer software]. Natick, MA, MathWorks.
Moramarco, T., Barbetta, S., Melone, F., and Singh, V. (2005). “Relating local stage and remote discharge with significant lateral inflow.” J. Hydrol. Eng., 58–69.
Morris, M. W., Hassan, M. A. A. M., and Vaskinn, K. A. (2007). “Breach formation: Field test and laboratory experiments.” J. Hydraul. Res., 45(Sup1), 9–17.
Moser, D. A. (1991). “Risk analysis applications for dam safety.” Proc., Int. Conf. on Hydropower, ASCE, Reston, VA, 1255–1264.
Nash, J. E., and Sutcliffe, J. V. (1970). “River flow forecasting through conceptual models, Part I: A discussion of principles.” J. Hydrol., 10(3), 282–290.
Newton, D. W. (1983). “Realistic assessment of maximum flood potentials.” J. Hydrol. Eng., 905–918.
Schmocker, L. (2009). “Book review: The failure of embankment dams due to overtopping.” J. Hydraul. Res., 47(2), 288.
Singh, K. P., and Snorrason, A. (1984). “Sensitivity of outflow peaks and flood stages to the selection of dam breach parameters and simulation models.” J. Hydrol., 68(1–4), 295–310.
Stevens, M., and Linard, J. (2002). “The safest dam.” J. Hydraul. Eng., 139–142.
Tarpanelli, A., Brocca, L., Melone, F., and Moramarco, T. (2013). “Hydraulic modelling calibration in small basins by using coarse resolution synthetic aperture radar imagery.” Hydrol. Process., 27(9), 1321–1330.
Tavares, L., and Serafim, J. (1983). “Probabilistic study on failure of large dams.” J. Geotech. Eng., 1483–1486.
U.S. Army Corps of Engineers (USACE). (2010). “HEC-RAS river analysis system.” Hydraulic reference manual, Hydrologic Engineering Center, Davis, California.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 22, 2012
Accepted: Aug 2, 2013
Published online: Aug 5, 2013
Discussion open until: Jan 5, 2014
Published in print: Jun 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.