Analysis of Evaporation Data under Roughness-Induced Wind Flow
Publication: Journal of Hydrologic Engineering
Volume 18, Issue 6
Abstract
Roughness-induced wind flow is commonly encountered around water bodies. It is well known that wind velocity enhances evaporation. However, the way this enhancement takes place in roughness-induced flow has been less explored. In this paper, a set of 200 data of an experimental investigation of the evaporation rates of water under forced convection conditions created by roughness elements from a circular pan fitted in the bottom wall of a wind tunnel test section are analyzed. The range of parameters used in this work are as follows: pan water temperature 30–50°C, wind velocity , and relative roughness height 0.011–0.075. Evaporation rates are related as a function of the vapor pressure differential, wind velocity, and relative roughness height of the obstructions introduced in the upstream of the air flow. It is found that evaporation rates are a nonlinear function of the relative roughness height, and evaporation estimates can contain a large error if such roughness-induced effects are neglected.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Society of Heating Refrigeration, and Air Conditioning (ASHRAE). (1991). Handbook, HVAC applications, ASHRAE, Atlanta, 4–7.
Adams, E. E., Cosler, D. J., and Helfrich, K. R. (1990). “Evaporation from heated water bodies: Predicting combined forced plus free convection.” Water Resour. Res., 26(3), 425–435.
Adeloye, J. A., Rustum, R., and Kariyama, I. D. (2011). “Kohonen self-organizing map estimator for the reference crop evapotranspiration.” Water Resour. Res., 47(8), W08527.
Berger, F. P., and Hau, K. F. F. L. (1977). “Mass transfer in turbulent pipe flow measured by the electrochemical method.” Int. J. Heat Mass Transfer, 20(11), 1185–1194.
Boelter, L., Gordon, H., and Griffin, J. (1946). “Free evaporation into air of water from a free horizontal quiet surface.” Ind. Eng. Chem., 38(6), 596–600.
Carrier, W. H. (1918). “The temperature of evaporation.” Am. Soc. Heat. Ventilat. Eng. Trans., 24, 25–50.
Chuck, W., and Sparrow, E. M. (1987). “Evaporative mass transfer in turbulent forced convection duct flows.” Int. J. Heat Mass Transfer, 30(2), 215–222.
Food and Agricultural Organization of the United Nations (FAO). (1998). “Crop evapotranspiration: Guidelines for computing crop water requirements.” FAO Irrigation and Drainage Paper 56, Rome.
Hinchley, J. W., and Himus, G. W. (1924). “Evaporation in currents of air.” Trans. Inst. Chem. Eng., 7(34), 57–63.
Irmak, S., Haman, D. Z., and Jones, J. W. (2002). “Evaluation of class A pan coefficients for estimating reference evapotranspiration in humid location.” J. Irrig. Drain. Eng., 128(3), 153–159.
Iskra, C., and Simonson, C. (2006). “Effect of air humidity on the convective mass transfer coefficient in a rectangular duct.” IEA-International Energy Agency, ECBCS-Energy Conservation in Buildings and Community Systems, Annex, 41 〈http://www.ecbcs.org/〉.
Iskra, C. R., and Simonson, C. J. (2007). “Convective mass transfer coefficient for a hydrodynamically developed airflow in a short rectangular duct.” Int. J. Heat Mass Transfer, 50(11–12), 2376–2393.
Kothandaraman, C. P. (1997). Steam tables in SI units and gas tables for compressible flow, Dhanpat Rai and Sons, New Delhi, India.
Lyczkowski, R. W., Solbrig, C. W., and Gidaspow, D. (1982). “Forced convection heat transfer in rectangular ducts—general case of wall resistances and peripheral conduction for ventilation cooling of nuclear waste repositories.” Nuclear Eng. Des., 67(3), 357–378.
Ojha, C. S. P., Khobragade, S. D., and Adeloye, A. J. (2011a). “Estimating air vapour pressure in a semi-arid region using FAO-56.” J. Irrig. Drain. Eng., 137(8), 491–500.
Ojha, C. S. P., Mandal, S., and Bhargav, P. (2001). “Aspects of inlet boundary prescription for a turbulent flow field.” J. Hydraul. Eng., 127(8), 694–700.
Ojha, C. S. P., Yasuda, H., Rao, S., Abd Elbasit, M. A. M., and Kumar, M. (2011b). “Evaporation in relation to concentration: Analysis of mass transfer coefficient.” Atmos. Environ., 45(35), 2691–2698.
Pauken, M. T. (1998). “An experimental investigation of combined turbulent free and forced evaporation.” Exp. Therm. Fluid Sci., 18(4), 334–340.
Pauken, M. T., Farley, B., Jeter, S. M., and Abdel-Khalik, S. I. (1995). “An experimental investigation of water evaporation into low-velocity air currents.” Am. Soc. Heat. Refrig. Air Cond. Eng. Trans., 101(1), 90–96.
Pauken, M. T., Tang, T. D., and Jeter, S. M. (1993). “A novel method for measuring water evaporation into still air.” Am. Soc. Heat. Refrig. Air Cond. Eng. Trans., 99(1), 297–300.
Penman, H. L. (1956). “Estimating evaporation.” Trans. Am. Geophys. Union, 37(1), 43–50.
Prata, A. T., and Sparrow, E. M. (1986). “Evaporation of water from a partially filled, cylindrical container to a forced convection air flow.” Int. J. Heat Mass Transfer, 29(4), 539–547.
Rower, C. (1931). Evaporation from free water surfaces, Tech. Bull. 271, USDA, Washington, DC.
Sharpley, B., and Boelter, L. (1938). “Evaporation of water into quiet air from a one-foot diameter surface.” Ind. Eng. Chem., 30(10), 1125–1131.
Shnitnikov, A. V. (1974). “Current methods for the study of evaporation from water surfaces and evapotranspiration.” Hydrol. Sci. Bull., 19(1), 85–97.
Singh, V. P., and Xu, C. Y. (1997). “Sensitivity of mass transfer based evaporation equations to errors in daily and monthly input data.” Hydrol. Processes, 11(11), 1465–1473.
Smith, C. C., Lof, G., and Jones, R. (1994). “Measurement and analysis of evaporation from an inactive swimming pool.” Solar Energy, 53(1), 3–7.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 13, 2011
Accepted: May 22, 2012
Published online: May 25, 2012
Published in print: Jun 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.