Cone Penetration Resistance in Coarse-Grained Gravelly Soils
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 149, Issue 1
Abstract
Centrifuge testing data are presented to elucidate the influence of particle size and gradation on cone penetration resistance. The physical, index, and material properties of nine test soil mixtures, sharing a common geologic origin and ranging in from 0.18 to 2.58 mm and from 1.53 to 9.86, were quantified and compared to the range of values exhibited by clean sands in the literature. Each centrifuge model was subjected to dynamic loading and characterized by six cone penetration test (CPT) soundings performed at values ranging from 23% to 96%. The coarser soils exhibited higher cone penetration resistances than clean sands under comparable conditions due to the continuum failure mechanism becoming compromised (more likely as decreased) and the variation in mechanical properties with particle size (e.g., and ). This study provides insight into the multifaceted influence of soil gradation on penetration resistance, which can be leveraged in engineering practice to improve the in situ characterization of coarse-grained gravelly soils.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The authors appreciate the funding and support provided by the National Science Foundation (NSF) (No. CMMI-1300518) and the California Department of Water Resources, Division of Safety of Dams. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the author(s) and do not necessarily reflect those of the NSF or the Division of Safety of Dams. This work would not have been possible without the discussions with Professor Ross Boulanger and the support from the technical staff at the University of California, Davis CGM: Chad Justice, Anatoliy Ganchenko, Tom Kohnke, and Dan Wilson. The assistance, training, and advice provided by graduate students Brian Sawyer, Greg Shepard, Mohammad Khosravi, Trevor Carey, and Kate Darby are greatly appreciated. Undergraduate interns Diana Melendez, Evan Barnell, and Brian Morales are thanked for their assistance.
References
Balachowski, L. 2007. “Size effect in centrifuge cone penetration tests.” Arch. Hydroeng. Environ. Mech. 54 (3): 161–181.
Bolton, M. D., and M. W. Gui. 1993. “The study of relative density and boundary effects for cone penetration testing in centrifuge. Technical Rep. No. CUED/D-Soils/TR256. Cambridge, UK: Univ. of Cambridge.
Bolton, M. D., M. W. Gui, J. Garnier, J. F. Corte, G. Bagge, J. Laue, and R. Renzi. 1999. “Centrifuge cone penetration tests in sand.” Géotechnique 49 (4): 543–552. https://doi.org/10.1680/geot.1999.49.4.543.
Bolton, M. D., M. W. Gui, and R. Phillips. 1993. “Review of miniature soil probes for model tests.” In Proc., 11th Southeast Asian Geotechnical Conf., 85–90. Pathum Thani, Thailand: Southeast Asian Geotechnical Society.
Boulanger, R. W., and J. T. DeJong. 2018. “Inverse filtering procedure to correct cone penetration data for thin-layer and transition effects.” In Proc., 4th Int. Symp. on Cone Penetration Testing, 25–44. Oxfordshire, UK: Taylor & Francis.
Carey, T., et al. 2018. “A new shared miniature cone penetrometer for centrifuge testing.” In Proc., 9th Int. Conf. on Physical Modeling in Geotechnics (ICPMG 2018), 293–298. Boca Raton, FL: CRC Press.
Chow, F. 1996. “Investigations into the behaviour of displacement piles for offshore foundations.” Ph.D. dissertation, Imperial College of Science, Technology and Medicine, Univ. of London.
Cubrinovski, M., and K. Ishihara. 1999. “Empirical correlation between SPT N-value and relative density for sandy soils.” Soils Found. 39 (5): 61–71. https://doi.org/10.3208/sandf.39.5_61.
DeJong, J. T., M. Ghafghazi, A. P. Sturm, D. W. Wilson, J. den Dulk, R. J. Armstrong, A. Perez, and C. A. Davis. 2017. “Instrumented Becker penetration test I: Equipment, operation, and performance.” J. Geotech. Geoenviron. Eng. 143 (9): 04017062. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001717.
DeJong, J. T., and M. Randolph. 2012. “Influence of partial consolidation during cone penetration on estimated soil behavior type and pore pressure dissipation measurements.” J. Geotech. Geoenviron. Eng. 138 (7): 777–788. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000646.
De Lima, D. C., and M. T. Tumay. 1991. “Scale effects in cone penetration tests.” In Proc., Geotechnical Engineering Congress 1991, 38–51. Reston, VA: ASCE.
Fellenius, B. H., and A. A. Altaee. 1996. “Critical depth: How it came into being and why it does not exist.” Int. J. Rock Mech. Mining Sci. Geomech. Abstracts 1 (33): 107–111.
Garnier, J., C. Gaudin, S. M. Springman, P. J. Culligan, D. Goodings, D. Konig, B. Kutter, R. Phillips, M. F. Randolph, and L. Thorel. 2007. “Catalogue of scaling laws and similitude questions in geotechnical centrifuge modelling.” Int. J. Phys. Modell. Geotech. 7 (3): 1–23. https://doi.org/10.1680/ijpmg.2007.070301.
Ghafghazi, M., J. T. DeJong, A. P. Sturm, and C. E. Temple. 2017. “Instrumented Becker penetration test II: iBPT-SPT correlation for characterization and liquefaction assessment of gravelly soils.” J. Geotech. Geoenviron. Eng. 143 (9): 04017063. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001718.
Ghali, M., M. Chekired, and M. Karray. 2019. “A laboratory-based study correlating cone penetration test resistance to the physical parameters of uncemented sand mixtures and granular soils.” Eng. Geol. 255 (May): 11–25. https://doi.org/10.1016/j.enggeo.2019.04.015.
Gui, M. W., and M. D. Bolton. 1998. “Geometry and scale effects in CPT and pile design.” In Geotechnical site characterization 2, 1063–1068. Rotterdam, Netherlands: A.A. Balkema.
Hardin, B. O., and F. E. Richart Jr. 1963. “Elastic wave velocities in granular soils.” J. Soil Mech. Found. Div. 89 (1): 33–65. https://doi.org/10.1061/JSFEAQ.0000493.
Idriss, I. M., and R. W. Boulanger. 2008. Soil liquefaction during earthquakes. Oakland, CA: Earthquake Engineering Research Institute.
Jamiolkowski, M., D. Presti, and M. Manassero. 2001. “Evaluation of relative density and shear strength of sands from CPT and DMT.” Soil Behav. Soft Ground Constr. 7 (119): 201–238.
Kim, J. H., Y. W. Choo, D. J. Kim, and D. S. Kim. 2016. “Miniature cone tip resistance on sand in a centrifuge.” J. Geotech. Geoenviron. Eng. 142 (3): 04015090. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001425.
Kulhawy, F. H., and P. W. Mayne. 1990. Manual on estimating soil properties for foundation design. EPRI EL-6800. Palo Alto, CA: Electric Power Research Institute.
Lee, S. Y. 1990. “Centrifuge modelling of cone penetration testing in cohesionless soils.” Ph.D. dissertation, Dept. of Engineering, Cambridge Univ.
Liao, S. S. C., and R. V. Whitman. 1986. “Overburden correction factors for SPT in sand.” J. Geotech. Eng. 112 (3): 373–377. https://doi.org/10.1061/(ASCE)0733-9410(1986)112:3(373).
Maki, I. P., R. W. Boulanger, J. T. DeJong, and R. A. Jaeger. 2014. “State-based overburden normalization of cone penetration resistance in clean sand.” J. Geotech. Geoenviron. Eng. 140 (2): 04013006. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001020.
Mayne, P. W. 2007. Cone penetration testing state-of-practice. NCHRP Project 20-05. Washington, DC: National Cooperative Highway Research Program.
Meyerhof, G. G. 1983. “Scale effects of ultimate pile capacity.” J. Geotech. Eng. 109 (6): 797–806. https://doi.org/10.1061/(ASCE)0733-9410(1983)109:6(797).
Nichols, G. 2009. Sedimentology and stratigraphy. New York: Wiley.
Owens, J. P., P. J. Sugarman, N. F. Sohl, R. A. Parker, H. F. Houghton, R. A. Volkert, A. A. Drake, and R. C. Orndorff. 1998. Bedrock geologic map of central and southern New Jersey. Washington, DC: USGS.
Pestana, J. M., and A. J. Whittle. 1995. “Compression model for cohesionless soils.” Géotechnique 45 (4): 611–631. https://doi.org/10.1680/geot.1995.45.4.611.
Price, A. B., R. W. Boulanger, and J. T. DeJong. 2019. “Centrifuge modeling of variable-rate cone penetration in low-plasticity silts.” J. Geotech. Geoenviron. Eng. 145 (11): 04019098. https://doi.org/10.1061/(ASCE)GT.1943-5606.0002145.
Sturm, A. P. 2019. “On the liquefaction potential of gravelly soils: Characterization, triggering and performance.” Ph.D. dissertation, Dept. of Civil and Environmental Engineering, Univ. of California.
Toledo, T. 2018. “Effect of particle size and gradation on one-dimensional compressibility of sand and gravels.” Master’s thesis, Dept. of Civil and Environmental Engineering, Univ. of California.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Jul 8, 2020
Accepted: Aug 22, 2022
Published online: Oct 31, 2022
Published in print: Jan 1, 2023
Discussion open until: Mar 31, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.