Framework for the Development of Strain-Based Ultimate Performance Limit State Criterion for the Stability of Earthen Embankments
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 148, Issue 4
Abstract
Repeated rapid drawdown (RDD) and rapid rise in water level during extreme events lead to the progressive development of plastic strain zones within the earth embankments with subtle, rather than obvious, visible signs of distress. The traditional approach within the framework of limit equilibrium does not account for accumulated permanent deformation with repeated hydraulic loading. Work presented herein is focused on quantifying the level of deviatoric strain, in terms of key surface deformation and distress level of earth embankment slopes, with repeated hydraulic loading. A simple linear relationship between the deviatoric strain and surface deformation at the toe of the slip surface is proposed as a function of the geometry of the slope for rotational sliding. This relationship is applied using the stress-strain data obtained from conventional triaxial testing and provides a simple means to estimate the ultimate performance limit state that corresponds to the onset of embankment slope instability. Results from a parametric study show good agreement between the numerical results and proposed analytical criterion. The proposed criterion is also compared with data from field cases reported in literature by others, and reasonably good agreement with onset of failure is obtained. Results from applying the proposed model to the case studies indicate the applicability of the proposed approach as a framework for various loading conditions, slope geometries, and material properties.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
Acknowledgments
This material is based upon work supported by the US Department of Homeland Security under Grant Award No. 2015-ST-061-ND0001-01. The views and conclusions contained in this document are those of the authors and should not be interpreted as necessarily representing the official policies, either expressed or implied, of the US Department of Homeland Security.
References
Abdoun, T., V. Bennett, T. Desrosiers, J. Simm, and M. Barendse. 2013. “Asset management and safety assessment of levees and earthen dams through comprehensive real-time field monitoring.” Geotech. Geol. Eng. 31 (3): 833–843. https://doi.org/10.1007/s10706-012-9569-3.
Balasubramaniam, A. S., Z. M. Hwang, U. Waheed, A. R. Chaudhry, and Y. G. Li. 1978. “Critical state parameters and peak stress envelopes for Bangkok clays.” Q. J. Eng. Geol. 11 (3): 219–232. https://doi.org/10.1144/GSL.QJEG.1978.011.03.02.
Balasubramaniam, A. S., and W. Uddin. 1977. “Deformation characteristics of weathered Bangkok clay in triaxial extension.” Géotechnique 27 (1): 75–92. https://doi.org/10.1680/geot.1977.27.1.75.
Barrett, J. R., and P. J. Moore. 1975. “Design criteria for rapid drawdown in earth-rock dams.” In Criteria and assumptions for numerical analysis of dams, 809–828. Swansea, UK: Univ. College.
Bennett, V., C. Jones, D. Bekaert, J. Bond, A. Helal, J. Dudas, M. Gabr, and T. Abdoun. 2017. “Deformation monitoring for the assessment of Sacramento Delta Levee performance.” In Geo-Risk 2017, 22–31. Reston, VA: ASCE.
Bhandari, R. K. 1988. “Special lecture: Some practical lessons in the investigation and field monitoring of landslides.” In Proc., 5th Int. Symp. on Landslides, 1435–1457. Boca Raton, FL: CRC Press.
Bishop, A. W. 1954. “The use of pore-pressure coefficients in practice.” Géotechnique 4 (4): 148–152. https://doi.org/10.1680/geot.1954.4.4.148.
Brinkgreve, R. B. J. 2005. “Selection of soil models and parameters for geotechnical engineering application.” In Geo-Frontiers Congress, 69–98. Reston, VA: ASCE.
BSI (British Standards Institution). 2015. Code of practice for earth retaining structures. BS 8002-2015. London: BSI.
Budhu, M. 2010. Soil mechanics and foundations. 3rd ed. New York: Wiley.
Crosta, G. B., and F. Agliardi. 2003. “Failure forecast for large rock slides by surface displacement measurements.” Can. Geotech. J. 40 (1): 176–191. https://doi.org/10.1139/t02-085.
Deliveris, A. V., I. E. Zevgolis, and N. C. Koukouzas. 2018. “A coupled probabilistic-numerical model for the reliability-based design of slopes.” In Proc., 14th Congreso Internacional de Energía y Recursos Minerales/Sevilla del 10 al 13 de abril de 2018. Seville, Spain.
Duncan, J. M. 2000. “Factors of safety and reliability in geotechnical engineering.” J. Geotech. Geoenviron. Eng. 126 (4): 307–316. https://doi.org/10.1061/(ASCE)1090-0241(2000)126:4(307).
Duncan, J. M., and C. Y. Chang. 1970. “Nonlinear analysis of stress and strain in soil.” J. Soil Mech. Found. Div. 96 (5): 1629–1653. https://doi.org/10.1061/JSFEAQ.0001458.
Duncan, J. M., S. G. Wright, and T. L. Brandon. 2014. Soil strength and slope stability. 2nd ed. Hoboken, NJ: Wiley.
Federico, A., C. Fidelibus, and G. Interno. 2002. “The prediction of landslide time to failure—A state of the art.” In Proc., 3rd Int. Conf. on Landslides, Slope Stability and the Safety of Infra-Structures, 167–180. Singapore: Ci-Premier.
Fukuzono, T. 1990. “Recent studies on time prediction of slope failure.” Landslide News 4: 9–12.
Gruner, U. 2001. Felssturzgefahr Chapf—Üssri Urweid (Gemeinde Innertkirchen): Angaben zur Geologie und zu den Bewegungen. Bern, Switzerland: Kellerhaus + Haefeli AG.
Holtz, R. D., W. D. Kovacs, and T. C. Sheahan. 2011. An introduction to geotechnical engineering. 2nd ed. London: Pearson.
Horpibulsuk, S., S. Shibuya, K. Fuenkajorn, and W. Katkan. 2007. “Assessment of engineering properties of Bangkok clay.” Can. Geotech. J. 44 (2): 173–187. https://doi.org/10.1139/t06-101.
Hungr, O., J. Corominas, and E. Eberhardt. 2005. “Estimating landslide motion mechanism, travel distance and velocity.” In Landslide risk management, edited by O. Hungr, R. Fell, R. Couture, and E. Eberhardt, 99–128. London: Taylor & Francis.
Jadid, R., B. M. Montoya, V. Bennett, and M. A. Gabr. 2020. “Effect of repeated rise and fall of water level on seepage-induced deformation and related stability analysis of Princeville levee.” Eng. Geol. 266 (Mar): 105458. https://doi.org/10.1016/j.enggeo.2019.105458.
Khalilzad, M., and M. A. Gabr. 2011. “Deformation-based limit states for earth embankments.” In Geo-Frontiers Congress, 3639–3648. Reston, VA: ASCE.
Khalilzad, M., M. A. Gabr, and M. E. Hynes. 2014. “Effects of woody vegetation on seepage-induced deformation and related limit state analysis of levees.” Int. J. Geomech. 14 (2): 302–312. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000304.
Khalilzad, M., M. A. Gabr, and M. E. Hynes. 2015. “Deformation-based limit state analysis of Embankment dams including geometry and water level effects.” Int. J. Geomech. 15 (5): 04014086. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000435.
Koelewijn, A. R., G. de Vries, H. van Lottum, U. Förster, V. M. van Beek, and A. Bezuijen. 2014. “Full-scale testing of piping prevention measures: Three tests at the IJkdijk.” In Proc., Physical Modelling in Geotechnics, 891–897. London: Taylor & Francis Group.
Kondner, R. L., and J. S. Zelasko. 1963. “A hyperbolic stress-strain formulation of sands.” In Proc., 2nd Pan-American Conf. on Soil Mechanics and Foundation Engineering (ICOSFE), 289–324. São Paulo, Brazil: Associação Brasileira de Mecânica dos Solos.
Melnikova, N. B., D. Jordan, and V. V. Krzhizhanovskaya. 2015a. “Experience of using FEM for real-time flood early warning systems: Monitoring and modeling Boston levee instability.” J. Comput. Sci. 10: 13–25. https://doi.org/10.1016/j.jocs.2015.04.033.
Melnikova, N. B., D. Jordan, V. V. Krzhizhanovskaya, and P. M. A. Sloot. 2015b. “Numerical prediction of the IJkDijk trial embankment failure.” Inst. Civ. Eng. Geotech. Eng. 168 (2): 158–171. https://doi.org/10.1680/geng.14.00040.
Moh, Z. C., J. D. Nelson, and E. W. Brand. 1969. “Strength and deformation behaviour of Bangkok Clay.” In Proc., 7th Int. Conf. Soil Mechanics and Foundation Engineering, 287–295. Mexico City, Mexico: Sociedad Mexicana de Mecanica de Suelos.
Pinyol, N. M., E. E. Alonso, J. Corominas, and J. Moya. 2012. “Canelles landslide: Modelling rapid drawdown and fast potential sliding.” Landslides 9 (1): 33–51. https://doi.org/10.1007/s10346-011-0264-x.
Pinyol, N. M., E. E. Alonso, and S. Olivella. 2008. “Rapid drawdown in slopes and embankments.” Water Resour. Res. 44 (5): 1–22. https://doi.org/10.1029/2007WR006525.
Plaxis. 2016. Plaxis 2D reference manual. Delft, Netherlands: Plaxis.
Saito, M. 1965. “Forecasting the time of occurrence of a slope failure.” In Proc., 6th Int. Conf. on Soil Mechanics and Foundation Engineering, Montreal, 537–541. Toronto: Univ. of Toronto Press.
Salt, G. 1988. “Landslide mobility and remedial measures.” In Proc., 5th Int. Symp. on Landslides, Lausanne, 757–762. Boca Raton, FL: CRC Press.
Stark, T. D. 1987. “Mechanism of strength loss in stiff clays.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Virginia Polytechnic Institute and State Univ.
Stark, T. D., N. H. Jafari, J. S. L. Zhindon, and A. Baghdady. 2017. “Unsaturated and transient seepage analysis of San Luis dam.” J. Geotech. Geoenviron. Eng. 143 (2): 04016093. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001602.
Stianson, J. R., D. G. Fredlund, and D. Chan. 2011. “Three-dimensional slope stability based on stresses from a stress-deformation analysis.” Can. Geotech. J. 48 (6): 891–904. https://doi.org/10.1139/t11-006.
Surarak, C., S. Likitlersuang, D. Wanatowski, A. Balasubramaniam, E. Oh, and H. Guan. 2012. “Stiffness and strength parameters for hardening soil model of soft and stiff Bangkok clays.” Soils Found. 52 (4): 682–697. https://doi.org/10.1016/j.sandf.2012.07.009.
Vaid, Y. P., and R. G. Campanella. 1974. “Triaxial and plane strain behavior of natural clay.” J. Geotech. Eng. Div. 100 (3): 207–224. https://doi.org/10.1061/AJGEB6.0000019.
VandenBerge, D. R., J. M. Duncan, and T. L. Brandon. 2015. “Limitations of transient seepage analyses for calculating pore pressures during external water level changes.” J. Geotech. Geoenviron. Eng. 141 (5): 04015005. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001283.
Voight, B. 1989. “A relation to describe rate-dependent material failure.” Science 243 (4888): 200–203. https://doi.org/10.1126/science.243.4888.200.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 148 • Issue 4 • April 2022
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Feb 19, 2021
Accepted: Nov 5, 2021
Published online: Jan 31, 2022
Published in print: Apr 1, 2022
Discussion open until: Jun 30, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.