Failure and Remedy of Column-Supported Embankment: Case Study
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 144, Issue 3
Abstract
A new section of a freeway was constructed as part of the European route E372 in the eastern region of Poland. One portion of the project required construction of an embankment over organic clay of a thickness of up to approximately 9.5 m. Controlled modulus columns were chosen to transfer the load from the embankment to the deeper and stronger soil deposits. Excessive settlements were detected during embankment construction, and as a result one section of the embankment needed to be reconstructed before completion of the road structure. Excessive settlements continued after the road structure was completed, particularly at the locations of culverts; at one location displacement reached 20 cm within several months. The disruption of the load transfer from the embankment to the columns at culvert locations was the likely cause of this serviceability failure. Simulations of consolidation settlement of the soft soil between the columns at one location indicated that the soil carried as much as approximately 40% of the load, thus only 60% of the load was transferred to the columns. Large culverts placed above the columns interfered with arching formation, affecting the load transfer process. In addition, discontinuity in the load transfer platform may have contributed to reduced effectiveness of the column support system. Other factors are also discussed in the paper. Remedial design included replacement of some volume of the embankment with expanded polystyrene (EPS) block geofoam (lightweight fill). At one location, in addition to EPS, drilled shafts were used to transfer the load to deeper deposits. After completion of the remedial construction, the expressway was put into service. Within the following 8 months, pavement settlements of 6–14 mm were recorded, and no distress to the pavement was reported in the following 12 months ending in early 2016.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank the General Management Administration of National Roads and Expressways in Lublin for making the original design documentation available to the team.
References
Abusharar, S. W., Zheng, J. J., Chen, B. G., and Yin, J. H. (2009). “A simplified method for analysis of a piled embankment reinforced with geosynthetics.” Geotext. Geomembr., 27(1), 39–52.
ASIRI. (2013). ASIRI national project: Recommendations for the design, construction and control of rigid inclusion ground improvements, Presses des Ponts, Paris.
ASTM. (2007). “Standard test method for low strain impact integrity testing of deep foundations.” ASTM D5882-07, West Conshohocken, PA.
British Standards. (2010). “Code of practice for strengthened/reinforced soils and other fills.” BS 8006-1, London.
Brown, D. A. (2005). “Practical consideration in the selection and use of continuous flight auger and drilled displacement piles.” Advances in deep foundations, ASCE, Reston, VA, 251–261.
CEN (European Committee for Standardization). (2004). “Geotechnical design. I: General rules.” Eurocode 7, Brussels, Belgium.
Collin, J. G., Watson, C. H., and Han, J. (2005). “Column-supported embankment solves time constraint for new road construction.” Contemporary issues in foundation engineering, ASCE, Reston, VA, 1–10.
DGGT (Deutsche Gesellschaft fur Geotechnik). (2012). Recommendations for design and analysis of earth structures using Geosynthetic reinforcements-EBGEO, Ernst & Sohn, Germany.
Filz, G. M., Sloan, J., McGuire, M. P., Collin, J., and Smith, M. (2012). “Column-supported embankments: Settlement and load transfer.” Proc., Geotechnical Engineering State of the Art and Practice: Keynote Lectures from Geo-Congress 2012, ASCE, Reston, VA, 54–77.
Giroud, J. P., Bonapart, R., Beech, J. F., and Gross, B. A. (1990). “Design of soil layer-geosynthetic systems overlying voids.” Geotext. Geomembr., 9(1), 11–50.
Han, J., and Gabr, M. (2002). “Numerical analysis of geosynthetic-reinforced and pile-supported earth platforms over soft soil.” J. Geotech. Geoenviron. Eng., 44–53.
Hewlett, W. J., and Randolph, M. F. (1988). “Analysis of piled embankments.” Ground Eng., 21(3), 12–18.
Jones, B. M., Plaut, R. H., and Filz, G. M. (2010). “Analysis of geosynthetic reinforcement in pile-supported embankments. I: 3D plate model.” Geosynth. Int., 17(2), 59–67.
Koerner, R. M. (2005). Designing with geosynthetics, Prentice Hall, Upper Saddle River, NJ.
Low, B. K., Tang, S. K., and Choa, V. (1994). “Arching in piled embankments.” J. Geotech. Eng., 1917–1938.
Michalowski, R. L. (1987). “Flow of granular media through a plane parallel/converging bunker.” Chem. Eng. Sci., 42(11), 2587–2596.
Michalowski, R. L. (1997). “Stability of uniformly reinforced slopes.” J. Geotech. Geoenviron. Eng., 546–556.
Monnet, J. (2015). In situ tests in geotechnical engineering, Wiley, Hoboken, NJ.
Nadukuru, S. S., and Michalowski, R. L. (2012). “Arching in distribution of active load on retaining walls.” J. Geotech. Geoenviron. Eng., 575–584.
Plomteux, C., Porbaha, A., and Spaulding, C. (2004). “CMC foundation system for embankment support: A case history.” GeoSupport Conf. 2004, J. P. Turner and P. W. Mayne, eds., ASCE, Reston, VA, 980–992.
Poulos, H. G. (1998). “A method for analyzing piled embankments.” Proc., 13th South East Asian Geotechnical Conf., Vol. 1, Southeast Asian Geotechnical Society, Pathum Thani, Thailand, 551–556.
Poulos, H. G. (2007). “Design charts for piles supporting embankments on soft clay.” J. Geotech. Geoenviron. Eng., 493–501.
Prezzi, M., and Basu, P. (2005). “Overview of construction and design of auger cast-in-place and drilled displacement piles.” Proc., 30th Annual Conf. on Deep Foundations, Deep Foundations Institute, Hawthorne, NJ, 497–512.
Reid, W. M., and Buchanan, N. W. (1983). “Bridge approach support piling.” Proc., Conf. on Advances in Piling and Ground Treatment, ICE Publishing, London, 267–274.
Suleiman, M. T., Ni, L., Davis, C., Lin, H., and Xiao, S. (2016). “Installation effects of controlled modulus column ground improvement piles on surrounding soil.” J. Geotech. Geoenv. Eng., 04015059.
Vardoulakis, I., Graf, B., and Gudehus, G. (1981). “Trap-door problem with dry sand: A statistical approach based upon model test kinematics.” Int. J. Numer. Anal. Methods Geomech., 5(1), 57–78.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Aug 19, 2016
Accepted: Aug 29, 2017
Published online: Dec 22, 2017
Published in print: Mar 1, 2018
Discussion open until: May 22, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.