Uplift Load-Carrying Capacity of Single and Group Micropiles Installed with Inclined Conditions
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 143, Issue 8
Abstract
In this study, the uplift load-carrying capacity of micropiles was investigated, focusing on the effect of various installation conditions including installation angle (), spacing (), and group configuration. For this purpose, a series of uplift model load tests was conducted using single micropiles (SMP) and group micropiles (GMP). The uplift load capacity of both SMP and GMP increased with up to 30° but decreased for a higher installation angle of . Micropile spacing had less effect on the uplift load capacity for GMP. The uplift load-carrying mechanism of inclined micropiles is proposed based on decomposed axial and lateral loads and resistance components. Based on the proposed load-carrying mechanism, axial and lateral load capacity ratios were proposed and adopted to formulate the uplift load-capacity equation for inclined micropiles. For GMP, the group-effect factor was proposed based on the reduction effect of group micropiles on the overall uplift load capacity. Full-scale uplift load tests were conducted to check the validity of the proposed method. Both SMP and GMP were constructed and tested. It was observed that the estimated results using the proposed method were in good agreement with the measured results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korean government (MSIP) (No. 2011-0030040 and NRF-2016R1D1A1A09919098).
References
AASHTO. (2012). “ASSHTO LRFD bridge design specifications.”, Washington, DC.
Afram, A. (1984). “Uplift capacity of battered pile in sand.” M.A.Sc. thesis, Concordia Univ., Montreal.
Alnuaim, A. M., El Nagger, H., and El Naggar, M. H. (2015). “Performance of micropiled raft in sand subjected to vertical concentrated load: Centrifuge modeling.” Can. Geotech. J., 52(1), 33–45.
Al-Shakarchi, Y. J., Fattah, M. Y., and Kashat, I. K. (2004). “The behaviour of batter piles under uplift loads.” Int. Conf. on Geotechnical Engineering, Sharjah Univ., Sharjah, UAE, 105–114.
Awad, A., and Ayoub, A. (1976). “Ultimate uplift capacity of vertical and inclined piles in cohesion less soils.” Proc., 5th Int. Conf. on Soil Mechanics, and Foundation Engineering, Section of Technical Sciences of the Hungarian Academy of Sciences (MTA), Budapest, Hungary, 221–226.
Bruce, D. A., Di Millio, A. F., and Juran, I. (1995). “Introduction to micropiles: An international perspective.” Foundation upgrading and repair for infrastructure improvement, ASCE, Reston, VA, 1–26.
BSI (British Standards Institution). (1986). “British standard code of practice for foundations.” BS 8004, London.
Das, B. M., Seeley, G. R., and Smith, J. E. (1976). “Uplift capacity of group piles in sand.” J. Geotech. Eng., 102(3), 282–286.
Davisson, M. T. (1972). “High capacity piles.” Proc., Soil Mechanics Lecture Series on Innovations in Foundation Construction, ASCE, Reston, VA, 81–112.
DFI (Deep Foundation Institute). (2004). “Guide to drafting a specification for micropiles.”, International Association of Foundation Drilling, TX.
FHWA (Federal Highway Administration). (2005). “Micropile design and construction reference manual.” FHWA NHI-05-039, National Highway Institute, Federal Highway Administration, U.S. Dept. of Transportation, Washington, DC.
Fukui, J. (2006). “Performance of seismic retrofits with high capacity micropiles.” 7th Int. Workshop on Micropile, Lizzi Lecture 2006, International Society for Micropile, Eighty Four, PA, 1–14.
Gaaver, K. E. (2013). “Uplift capacity of single piles and pile groups embedded in cohesionless soil.” Alexandria Eng. J., 52(3), 365–372.
Han, J., and Ye, S.-L. (2006). “A field study on the behavior of micropiles in clay under compression or tension.” Can. Geotech. J., 43(1), 19–29.
Hanna, A. M., and Afram, A. (1986). “Pullout capacity of single batter piles in sand.” Can. Geotech. J., 23(3), 387–392.
Hong, W.-P., and Chim, N. (2015). “Prediction of uplift capacity of a micropile embedded in soil.” KSCE J. Civ. Eng., 19(1), 116–126.
Isam, S., Hassan, A., and Mhamed, S. (2012). “3D elastoplastic analysis of the seismic performance of inclined micropiles.” Comput. Geotech., 39, 1–7.
ISSMFE (International Society of Soil Mechanics and Foundation Engineering). (1985). “Axial pile loading test. Part I: Static loading.” Geotech. Test. J., 8(2), 79–89.
Madhav, M. R. (1987). “Efficiency of pile groups in tension.” Can. Geotech. J., 24(1), 149–153.
Meyerhof, G. G. (1973). “Uplift resistance of inclined anchors and piles.” Proc., 8th Int. Conf. on Soil Mechanics and Foundation Engineering, International Society for Soil Mechanics and Geotechnical Engineering, London, 167–172.
Misra, A., Roberts, L. A., Oberoi, R., and Chen, C.-H. (2007). “Uncertainty analysis of micropile pullout based upon load test results.” J. Geotech. Geoenviron. Eng., 1017–1025.
Nazir, A., and Nasr, A. (2013). “Pullout capacity of batter pile in sand.” J. Adv. Res., 4(2), 147–154.
Nusier, O. K., and Alawneh, A. S. (2004). “Micropile technique to control upward movement of lightweight structures over expansive soils.” Geotech. Geol. Eng., 22(1), 89–104.
O’Neill, M. W. (1983). “Group action in offshore piles.” Conf. on Geotechnical Practice in Offshore Engineering, ASCE, New York, 25–64.
Petrasovits, G., and Award, A. (1972). “Ultimate lateral resistance of a rigid pile in cohesionless soil.” Proc., 5th European Conf. on Soil Mechanics and Foundation Engineering, SEMSIG, Madrid, Spain, 407–412.
Reese, L. C., and O’Neill, M. W. (1988). “Drilled shafts: Construction procedures and design methods.”, Federal Highway Administration, McLean, VA.
Salisbury, N. G., and Davidow, S. A. (2014). “Current design and construction practices for micropile supported foundations of electrical transmission structures in North America.” 12th Int. Workshop on Micropiles, International Society for Micropile, Eighty Four, PA.
Shanker, K., Basudhar, P. K., and Patra, N. R. (2006). “Uplift capacity of pile groups embedded in sands: Predictions and performance.” Soils Found., 46(5), 605–612.
Sharma, B., and Buragohain, P. (2014). “Behaviour of micropile groups under oblique pull out loads in sand.” Indian Geotech. J., 44(4), 400–408.
Sharma, B., Zaheer, S., and Hussain, Z. (2014). “An experimental model for studying the performance of vertical and batter micropiles.” Geo-Congress 2014, Geo-Institute, ASCE, Reston, VA, 4252–4264.
Shelke, A., and Patra, N. R. (2008). “Effect of arching on uplift capacity of pile groups in sand.” J. Geomech., 347–354.
Tompson, F., Salisbury, N., Khattak, A., Hastings, A., and Foster, M. (2009). “Integration of optimum, high voltage transmission line foundation.” Proc., Electrical Transmission and Substation Structures Conf., Electrical Transmission Structures Committee of the Structural Engineering Institute, ASCE, Reston, VA.
Tsukada, Y., Miura, K., Tsubokawa, Y., Otani, Y., and You, G. L. (2006). “Mechanism of bearing capacity of spread footings reinforced with micropiles.” Soils Found., 46(3), 367–376.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: May 27, 2016
Accepted: Jan 5, 2017
Published ahead of print: Mar 19, 2017
Published online: Mar 20, 2017
Published in print: Aug 1, 2017
Discussion open until: Aug 20, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.