Mechanical Behavior of Clean Sand at Low Confining Pressure: Verification with Element and Model Tests
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 141, Issue 8
Abstract
Confining pressure significantly influences the mechanical behavior of soil. Understanding geotechnical problems related to low confining pressures requires precise modeling of soil behavior at low confining stress. Yet laboratory tests, including element tests under low confining pressure, are so far quite limited. In this note, a series of element tests under low confining pressure (5–20 kPa) were carried out to investigate the effect of low confining pressure on the mechanical behavior of loose and medium dense Toyoura sand. Element tests include undrained cyclic loading tests, as well as drained and undrained strain-controlled monotonic loading tests. The results show that loose sand under low confining pressure behaves much like dense sand under higher pressure. Model tests of slope failure flow under microgravity, carried out to supplement the element test results, also confirmed the previously mentioned mechanical behavior. The results obtained in this paper provide a more fundamental understanding of geotechnical problems related to low confining stress.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported in this paper was supported by the National Natural Science Foundation of China (Grant Nos. 41372355 and 41072202) and the Program for New Century Excellent Talents in University (Grant No. NCET-11-0382).
References
Alshibli, K. A., Batiste, S. N., and Sture, S. (2003). “Strain localization in sand: Plane strain versus triaxial compression.” J. Geotech. Geoenviron. Eng., 483–494.
Baldi, G., and Nova, R. (1984). “Membrane penetration effects in triaxial testing.” J. Geotech. Eng., 403–420.
Chakraborty, T., and Salgado, R. (2010). “Dilatancy and shear strength of sand at low confining pressures.” J. Geotech. Geoenviron. Eng., 527–532.
Fannin, R. J., Eliadorani, A., and Wilkinson, J. M. T. (2005). “Shear strength of cohesionless soils at low stress.” Geotechnique, 55(6), 467–478.
Fukushima, S., and Tatsuoka, F. (1984). “Strength and deformation characteristics of saturated sand at extremely low pressures.” Soils Found., 24(4), 30–48.
Ghazavi, M., Hosseini, M., and Mollanouri, M. (2008). “A comparison between angle of repose and friction angle of sand.” Proc., 12th Int. Conf. of Int. Association for Computer Methods and Advances in Geomechanics, Curran Associates, New York, 1272–1275.
Hardin, B. O. (1989). “Low-stress dilation test.” J. Geotech. Eng., 769–787.
Huang, Y., and Mao, W. (2013). “First results derived from a drop-tower testing system for granular flow in a microgravity environment.” Landslides, 10(4), 493–501.
Jin, Y., Ye, B., and Zhang, F. (2010). “Numerical simulation of sand subjected to cyclic load under undrained conventional triaxial test.” Soils Found., 50(2), 177–194.
Kobayashi, T., Ochiai, H., Suyama, Y., Aoki, S., Yasufuku, N., and Omine, K. (2009). “Bearing capacity of shallow foundations in a low gravity environment.” Soils Found., 49(1), 115–134.
Kolymbas, D., and Wu, W. (1990). “Recent results of triaxial tests with granular materials.” Powder Technol., 60(2), 99–119.
Lancelot, L., Shahrour, I., and Mahmoud, M. A. (2006). “Failure and dilatancy properties of sand at relatively low stresses.” J. Eng. Mech., 1396–1399.
Ponce, V. M., and Bell, J. M. (1971). “Shear strength of sand at extremely low pressures.” J. Soil Mech. Found. Div., 97(4), 625–638.
Sture, S., Batiste, S. N., Lankton, M., and Parisi, J. (2004). “Properties of sand under low effective stresses.” Proc., NinthBiennial Conf. on Engineering, Construction, and Operations in Challenging Environments, ASCE, Reston, VA, 78–84.
Sture, S., Batiste, S. N., Lankton, M., and Parisi, J. (2005). “Cyclic behavior of sand under very low effective stresses.” Proc., Geomechanics: Testing, Modeling, and Simulation, ASCE, Reston, VA, 187–204.
Tatsuoka, F., Sakamoto, M., Kawamura, T., and Fukushima, S. (1986). “Strength and deformation characteristics of sand in plane strain compression at extremely low pressures.” Soils Found., 26(1), 65–84.
Verdugo, R., and Ishihara, K. (1996). “The steady state of sandy soils.” Soils Found., 36(2), 81–91.
Vrettos, C. (2012). “Shear strength investigations for a class of extraterrestrial analogue soils.” J. Geotech. Geoenviron. Eng., 508–515.
Yang, S., Sandven, R., and Grande, L. (2003). “Liquefaction of sand under low confining pressure.” J. Ocean Univ. Qingdao, 2(2), 207–210.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Mar 6, 2014
Accepted: Mar 5, 2015
Published online: Apr 8, 2015
Published in print: Aug 1, 2015
Discussion open until: Sep 8, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.