Long-Term Effect of Curing Temperature on the Strength Behavior of Cement-Stabilized Clay
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 140, Issue 8
Abstract
The influence of curing temperature on the strength development of concrete, mortar, or cement-stabilized granular soils has been widely reported in the literature. However, there are fewer studies focusing on cement-stabilized clay. The key difference is the presence of pozzolanic reactions in cement-stabilized clay, which give rise to more complex strength-development behaviors than those of concrete, mortar, or cement-stabilized granular soils. This paper aims to clarify this difference using extensive data collected as part of a land reclamation project in Singapore. Five different mixes of cement-stabilized Singapore marine clay are cured under different temperatures. Their strength development with time is studied by testing the specimens under unconfined compression at various curing ages (up to 1 year). The experimental results show that a higher curing temperature gives rise to not only higher short-term strengths but also higher long-term/ultimate strengths. Based on the experimental results, a model is proposed that combines the maturity theory commonly used for concrete or mortar with a proposed temperature-enhanced strength factor, which takes into account the effect of curing temperature on pozzolanic reactions occurring in cement-stabilized clay. This proposed model is validated by another independent Singapore data set and data sets collected from the literature.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was supported by the Building and Construction Authority of Singapore under the MND Research Fund on “Enhancing the Use of Unwanted Soils for Land Reclamation Purpose—Solving an Environmental Problem and Developing a Viable Alternate Fill.” The authors also acknowledge the invaluable cooperation and assistance offered by the Housing and Development Board and Surbana International Consultants Pte Ltd.
References
ASTM. (1998). “Practice for estimating concrete strength by the maturity method.” C1074, West Conshohocken, PA.
Baghdadi, Z. A. (1982). “Accelerated strength testing of soil–cement.” Ph.D. thesis, Univ. of Arizona, Tucson, AZ.
Chew, S. H., Kamruzzaman, A. H. M., and Lee, F. H. (2004). “Physicochemical and engineering behavior of cement treated clays.” J. Geotech. Geoenviron. Eng., 696–706.
Chitambira, B. (2004). “Accelerated ageing of cement stabilised/solidified contaminated soils with elevated temperatures.” Ph.D. thesis, Univ. of Cambridge, Cambridge, U.K.
Chitambira, B., Al-Tabbaa, A., Perera, A. S. R., and Yu, X. D. (2007). “The activation energy of stabilised/solidified contaminated soils.” J. Hazard. Mater., 141(2), 422–429.
Chiu, C. I., Zhu, W., and Zhang, C. L. (2008). “Yielding and shear behaviour of cement-treated dredged materials.” Eng. Geol., 103(1), 1–12.
Clare, K. E., and Pollard, A. E. (1954). “The effect of curing temperature on the compressive strength of soil-cement mixtures.” Géotechnique, 4(3), 97–106.
Dermatas, D., Dutko, P., Balorda-Barone, J., and Moon, D. H. (2003). “Evaluation of engineering properties of cement treated Hudson River dredged sediments for reuse as fill materials.” J. Mar. Environ. Eng., 7(2), 101–123.
Hernandez-Martinez, F. (2006). “Ground improvement of organic soils using deep soil mixing.” Ph.D. thesis, Univ. of Cambridge, Cambridge, U.K.
Herzog, A., and Mitchell, J. K. (1963). “Reactions accompanying stabilization of clay with cement.” Highway Research Record 36, Transportation Research Board, Washington, DC, 146–171.
Horpibulsuk, S., Miura, N., and Nagaraj, T. S. (2003). “Assessment of strength development in cement-admixed high water content clays with Abrams’ law as a basis.” Géotechnique, 53(4), 439–444.
Horpibulsuk, S., Miura, N., and Nagaraj, T. S. (2005). “Clay–water/cement ratio identity for cement admixed soft clays.” J. Geotech. Geoenviron. Eng., 187–192.
Horpibulsuk, S., Rachan, R., and Suddeepong, A. (2011). “Assessment of strength development in blended cement admixed Bangkok clay.” Constr. Build. Mater., 25(4), 1521–1531.
Japanese Geotechnical Society. (2000). “Practice for making and curing stabilized soil specimens without compaction.” JGS 0821-2000, Tokyo (in Japanese).
Kamruzzaman, A. H., Chew, S. H., and Lee, F. H. (2009). “Structuration and destructuration behavior of cement-treated Singapore marine clay.” J. Geotech. Geoenviron. Eng., 573–589.
Karthikeyan, M. (2005). “Application of radioisotope cone penetrometer to characterize a lumpy fill.” Ph.D. thesis, National Univ. of Singapore, Singapore.
Kitazume, M., and Satoh, T. (2005). “Quality control in Central Japan International Airport construction.” Proc. Inst. Civ. Eng. Ground Improv., 9(2), 59–66.
Lee, F.-H., Lee, Y., Chew, S.-H., and Yong, K.-Y. (2005). “Strength and modulus of marine clay-cement mixes.” J. Geotech. Geoenviron. Eng., 178–186.
Lu, Y. T., Tan, T. S., Phoon, K. K. (2011). “Curing temperature effect on strength development of cement treated Singapore marine clay: A discussion on Arrhenius equation based maturity model and its application.” Proc., Advances in Ground Technology and Geo-Information, Research Publishing Services, Singapore, 261–269.
Marzano, I. P., Al-Tabbaa, A., and Grisolia, M. (2009). “Influence of curing temperature on the strength of cement-stabilised artificial clays.” Proc., 2nd Int. Workshop on Geotechnics of Soft Soils—Focus on Ground Improvement, M. Karstunen and M. Leoni, eds., Taylor & Francis, London, 257–262.
Mindess, S., Young, J. F., and Darwin, D. (1981). Concrete, 2nd Ed., Pearson Prentice Hall, Upper Saddle River, NJ.
Miura, N., Horpibulsuk, S., and Nagaraj, T. S. (2001). “Engineering behaviour of cement stabilized clay at high water content.” Soils Found., 41(5), 33–45.
Morohoshi, K., et al. (2010). “Design and long-term monitoring of Tokyo International Airport extension project constructed on super-soft ground.” Geotech. Geol. Eng., 28(3), 223–232.
Neville, A. M. (1996). Properties of concrete, 4th Ed., Wiley, New York.
Noble, D. F., and Plaster, R. W. (1970). “Final Report: Reaction in Portland cement–clay mixtures.” Rep. No. VHRC 70-R13, Virginia Highway Research Council, Charlottesville, VA.
Porbaha, A., Hanzawa, H., and Shima, H. (1999). “Technology of air-transported stabilized dredged fill. Part I: Pilot study.” Proc. Inst. Civ. Eng. Ground Improv., 3(2), 49–58.
Porbaha, A., Shibuya, S., and Kishida, T. (2000). “State of the art in deep mixing technology. Part III: Geomaterial characterization.” Proc. Inst. Civ. Eng. Ground Improv., 4(3), 91–110.
Rahman, M. M., Taiyab, M. A., Siddique, A., and Uddin, M. K. (2008). “A short-cut method for predicting strength of cement treated soft Bangladesh clays and the alteration of other engineering parameters.” Geotech. Eng., 39(3), 159–167.
Soroka, I. (1993). Concrete in hot environments, 1st Ed., E&FN Spon, London.
Tan, T. S., Goh, T.-L., and Yong, K.-Y. (2002). “Properties of Singapore marine clays improved by cement mixing.” Geotech Test. J., 25(4), 422–433.
Tan, T. S., Lu, Y. T., Phoon, K. K., and Karthikeyan, M. (2011). “Innovative approaches to land reclamation in Singapore.” Proc., Advances in Ground Technology and Geo-Information, Research Publishing Services, Singapore, 85–102.
Tang, Y. X., Miyazaki, Y., and Tsuchida, T. (2001). “Practice of reused dredgings by cement treatment.” Soils Found., 41(5), 129–143.
Van Impe, W. F., and Verástegui Flores, R. D. (2006). “Deep mixing in underwater conditions: A laboratory and field investigation.” Proc. Inst. Civ. Eng. Ground Improv., 10(1), 15–22.
Xiao, H. W. (2009). “Yielding and failure of cement treated soil.” Ph.D. thesis, National Univ. of Singapore, Singapore.
Yun, J.-M., Song, Y.-S., Lee, J.-H., and Kim, T.-H. (2006). “Strength characteristics of the cement-stabilized surface layer in dredged and reclaimed marine clay, Korea.” Mar. Georesour. Geotechnol., 24(1), 29–45.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Oct 17, 2013
Accepted: Apr 14, 2014
Published online: May 9, 2014
Published in print: Aug 1, 2014
Discussion open until: Oct 9, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.