Centrifuge Modeling of Soil-Structure Interaction in Energy Foundations
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 140, Issue 4
Abstract
This study presents a centrifuge modeling approach to characterize the transient thermomechanical response of energy foundations during heating-cooling cycles to provide data for calibration and validation of soil-structure interaction models. This study focuses on the response of a scale-model energy foundation installed in an unsaturated silt layer with end-bearing boundary conditions. The foundation response was assessed using embedded strain gauges and thermocouples. Other variables monitored include foundation head displacements, soil surface displacements, and changes in temperature and volumetric water content in the unsaturated silt at different depths and radial locations. Measurements during the initial heating process indicate that the thermal axial stress is greater near the toe of the foundation as a result of the restraint associated with mobilization of side shear resistance along the length of the foundation. The thermal axial strains were close to the free-expansion thermal strain near the soil surface and decreased with depth. The thermal axial displacements calculated by integrating the thermal axial strains correspond well with the independently measured head displacements. The mobilized side stresses calculated from the thermal axial stresses increased with height and were consistent with the shear strength of unsaturated silt. During successive heating-cooling cycles, slight decreases in upward thermal head displacement were observed because of changes in the stiffness of the unsaturated soil from thermally induced water flow away from the foundation and potential downdrag effects. However, little change in the thermal axial stress was observed during the heating-cooling cycles.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank undergraduate students Joseph Goode III and Michael Fend, as well as centrifuge engineers Nathaniel Bailey and Kent Polkinghorne, for their help with centrifuge testing. Discussions with Kyle Murphy are greatly appreciated. Financial support from the National Science Foundation (Grant No. CMMI-0928159) is gratefully acknowledged. The contents of this paper reflect the views of the authors and do not necessarily reflect the views of the sponsor.
References
Amatya, B. L., Soga, K., Bourne-Webb, P. J., Amis, T., and Laloui, L. (2012). “Thermo-mechanical behaviour of energy piles.” Geotechnique, 62(6), 503–519.
Bouazza, A., et al. (2011). “Harnessing on site renewable energy through pile foundations.” Aust. Geomech. J., 46(4), 79–90.
Bourne-Webb, P. J., Amatya, B., Soga, K., Amis, T., Davidson, C., and Payne, P. (2009). “Energy pile test at Lambeth College, London: Geotechnical and thermodynamic aspects of pile response to heat cycles.” Geotechnique, 59(3), 237–248.
Brandl, H. (1998). “Energy piles and diaphragm walls for heat transfer from and into the ground.” Proc., 3rd Int. Geotechnical Seminar on Deep Foundations on Bored and Auger Piles (BAP III), Balkema, Rotterdam, Netherlands, 37–60.
Brandl, H. (2006). “Energy foundations and other thermo-active ground structures.” Geotechnique, 56(2), 81–122.
Ennigkeit, A., and Katzenbach, R. (2001). “The double use of piles as foundation and heat exchanging elements.” Proc., 15th Int. Conf. on Soil Mechanics and Geotechnical Engineering, Taylor and Francis, Oxford, U.K., 893–896.
Goode, J. C., III. (2013). “Centrifuge modeling of the thermo-mechanical response of energy foundations.” M.S. thesis, Univ. of Colorado, Boulder, CO.
Hughes, P. J. (2008). “Geothermal (ground-source) heat pumps: Market status, barriers to adoption, and actions to overcome barriers.” Rep. ONRL-2008/232, Oak Ridge National Laboratory, Oak Ridge, TN.
Knellwolf, C., Peron, H., and Laloui, L. (2011). “Geotechnical analysis of heat exchanger piles.” J. Geotech. Geoenviron. Eng., 890–902.
Ko, H.-Y. (1988). “Summary of the state-of-the-art in centrifuge model testing.” Centrifuges in soil mechanics, W. H. Craig, R. G. James, and A. N. Schofield, eds., Balkema, Rotterdam, Netherlands, 11–28.
Krishnaiah, S., and Singh, D. N. (2004). “Centrifuge modelling of heat migration in soils.” Int. J. Phys. Model. Geotech., 4(3), 39–47.
Laloui, L. (2011). “In-situ testing of heat exchanger pile.” Proc., Geo-Frontiers 2011, J. Han and D. E. Alzamora, eds., ASCE, Reston, VA, 410–419.
Laloui, L., Moreni, M., and Vulliet, L. (2003). “Comportement d’un pieu bi-fonction, foundation et échangeur de chaleur.” Can. Geotech. J., 40(2), 388–402.
Laloui, L., and Nuth, M. (2006). “Numerical modeling of some features of heat exchanger pile.” Foundation analysis and design: Innovative methods (GSP 153), R. L. Parsons, L. Zhang, W. D. Guo, K. K. Phoon, and M. Yang, eds., ASCE, Reston, VA, 189–195.
Laloui, L., Nuth, M., and Vulliet, L. (2006). “Experimental and numerical investigations of the behaviour of a heat exchanger pile.” Int. J. Numer. Anal. Methods Geomech., 30(8), 763–781.
McCartney, J. S., and Murphy, K. D. (2012). “Strain distributions in full-scale energy foundations.” DFI J., 6(2), 28–36.
McCartney, J. S., and Rosenberg, J. E. (2011). “Impact of heat exchange on side shear in thermoactive foundations.” Proc., Geo-Frontiers 2011 (GSP 211), J. Han and D. E. Alzamora, eds., ASCE, Reston, VA, 488–498.
Regueiro, R., Wang, W., Stewart, M. A., and McCartney, J. S. (2012). “Coupled thermo-poro-mechanical finite element analysis of a heated single pile centrifuge experiment in saturated silt.” Proc., GeoCongress 2012 (GSP 225), R. D. Hryciw, A. Athanasopoulos-Zekkos, and N. Yesiller, eds., ASCE, Reston, VA, 4406–4415.
Rosenberg, J. E. (2010). “Centrifuge modeling of soil structure interaction in thermo-active foundation.” M.S. thesis, Univ. of Colorado, Boulder, CO.
Savvidou, C. (1988). “Centrifuge modelling of heat transfer in soil.” Proc., Centrifuge 88, J.-P. Corté, ed., Balkema, Rotterdam, Netherlands, 583–591.
Stewart, M. (2012). “Centrifuge modeling of strain distributions in energy foundations.” M.S. thesis, Univ. of Colorado, Boulder, CO.
Taylor, R. (1995). Geotechnical centrifuge technology, Blackie, London.
Uchaipichat, A., and Khalili, N. (2009). “Experimental investigation of thermo-hydro-mechanical behaviour of an unsaturated silt.” Geotechnique, 59(4), 339–353.
van Genuchten, M. T. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
Wang, B., et al. (2012). “Field and laboratory investigation of a heat exchanger pile.” Proc., GeoCongress 2012 (GSP 225), R. D. Hryciw, A. Athanasopoulos-Zekkos, and N. Yesiller, eds., ASCE, Reston, VA, 4396–4405.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 140 • Issue 4 • April 2014
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jul 27, 2012
Accepted: Oct 21, 2013
Published online: Dec 4, 2013
Published in print: Apr 1, 2014
Discussion open until: May 4, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.