Centrifuge Modeling Studies of Site Response in Soft Clay over Wide Strain Range
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 140, Issue 2
Abstract
Centrifuge models of soft-clay deposits were shaken with suites of earthquake ground motions to study site response over a wide strain range. The models were constructed in an innovative hinged-plate container to effectively reproduce one-dimensional ground-response boundary conditions. Dense sensor arrays facilitate back-calculation of modulus-reduction and damping values that show modest misfits from empirical models. Low-amplitude base motions produced nearly elastic response in which ground motions were amplified through the soil column, and the fundamental site period was approximately 1.0 s. High-intensity base motions produced shear strains higher than 10%, mobilizing shear failure in clay at stresses larger than the undrained monotonic shear strength. The authors attribute these high mobilized stresses to rate effects, which should be considered in strength-parameter selection for nonlinear analysis. This nonlinear response deamplified short-period spectral accelerations and lengthened the site period to 3.0 s. The nonlinearity in spectral amplification is parameterized in a form used for site terms in ground-motion prediction equations to provide empirical constraint unavailable from ground-motion databases.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank Alek Harounian, DongSoon Park, and Lijun Deng for assistance constructing and testing the centrifuge models and NEES @ UCDavis personnel, including Dan Wilson, Ross Boulanger, Bruce Kutter, Chad Justice, Ray Gerhard, Peter Rojas, Lars Pederson, Anatoliy Ganchenko, and Jenny Chen, for their assistance during this sometimes difficult project. Funding for this work was provided by the United States Geological Survey under Contract No. 08HQGR0037. The contents of this paper reflect the views of the authors, who are responsible for the facts and accuracy of the data presented herein. The contents do not necessarily reflect the official views or policies of the United States federal government. This paper does not constitute a standard, specification, or regulation. This material is based on research performed in a renovated collaboratory by the National Science Foundation under Grant No. 0963183, which is an award funded under the American Recovery and Reinvestment Act of 2009 (ARRA).
References
Afacan, K. B., Harounian, A., Brandenberg, S. J., and Stewart, J. P. (2011). “Evaluation of non-linear site response of soft clay using centrifuge models: Centrifuge data report for AHA02.” UCLA-SGEL Rep., Univ. of California, Los Angeles.
ASTM. (2007). “Standard practice for classification of soils for engineering purposes (unified soil system).” D2487, West Conshohocken, PA.
Baturay, M. B., and Stewart, J. P. (2003). “Uncertainty and bias in ground-motion estimates from ground response analyses.” Bull. Seismol. Soc. Am., 93(5), 2025–2042.
Boore, D. M., and Atkinson, G. M. (2008). “Ground-motion prediction equations for the average horizontal component of PGA, PGV, and 5%-damped PSA at spectral periods between 0.01 s and 10.0 s.” Earthq. Spectra, 24(1), 99–138.
Boore, D. M., and Bommer, J. J. (2005). “Processing of strong-motion accelerograms: Needs, options and consequences.” Soil. Dyn. Earthq. Eng., 25(2), 93–115.
Borcherdt, R. D. (1994). “Estimates of site-dependent response spectra for design (methodology and justification).” Earthq. Spectra, 10(4), 617–653.
Brandenberg, S. J., Kutter, B. L., and Wilson, D. W. (2008). “Fast stacking and phase corrections of shear wave signals in a noisy environment.” J. Geotech. Geoenviron. Eng., 1154–1165.
Chiou, B. S. J., Darragh, R., Dregor, D., and Silva, W. J. (2008). “NGA project strong-motion database.” Earthq. Spectra, 24(1), 23–44.
Choi, Y., and Stewart, J. P. (2005). “Nonlinear site amplification as function of 30 m shear wave velocity.” Earthq. Spectra, 21(1), 1–30.
Darendeli, M. B. (2001). “Development of a new family of normalized modulus reduction and material damping curves.” Ph.D. thesis, Univ. of Texas, Austin, TX.
Elgamal, A., Lai, T., Yang, Z., and He, L. (2001). “Dynamic soil properties, seismic downhole arrays and applications in practice.” Proc., 4th Int. Conf. on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics, International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE), London.
Elgamal, A., Yang, Z., Lai, T., Kutter, B. L., and Wilson, D. W. (2005). “Dynamic response of saturated dense sand in laminated centrifuge container.” J. Geotech. Geoenviron. Eng., 598–609.
Fiegel, G. L. (1995). “Centrifugal and analytical modeling of soft soil sites subjected to seismic shaking.” Ph.D. thesis, Univ. of California, Davis, CA.
Hardin, B. O., and Drnevich, V. P. (1972). “Shear modulus and damping in soils: Design equations and curves.” J. Soil Mech. and Found. Div., 98(7), 667–692.
Harounian, A. (2010). “Evaluation of non-linear site response of soft clay using centrifuge models: Centrifuge data report for AHA01.” M.S. thesis, Univ. of California, Los Angeles.
Harounian, A., Afacan, K. B., Stewart, J. P., and Brandenberg, S. J. (2013a). “AHA01: Evaluation of nonlinear site response of soft clay using centrifuge models.” Network for Earthquake Engineering Simulation Database (NEES),.
Harounian, A., Afacan, K. B., Stewart, J. P., and Brandenberg, S. J. (2013b). “AHA02: Evaluation of nonlinear site response of soft clay using centrifuge models.” Network for Earthquake Engineering Simulation Database (NEES),.
Hashash, Y. M., Philips, C., and Groholski, D. R. (2010). “Recent advances in non-linear site response analysis.” Proc., 5th Int. Conf. on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics, International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE), London, 1–22.
Jaky, J. (1944). “The coefficient of Earth pressure at rest.” J. Soc. Hung. Arch. Eng., 7(22), 355–358.
Kramer, S. L., and Paulsen, S. B. (2004). “Practical use of geotechnical site response models.” Proc., Int. Workshop on Uncertainties in Nonlinear Soil Properties and Their Impact on Modeling Dynamic Soil Response, Pacific Earthquake Engineering Research Center (PEER), Berkeley, CA.
Kwok, A. O., et al. (2007). “Use of exact solutions of wave propagation problems to guide implementation of nonlinear seismic ground response analysis procedures.” J. Geotech. Geoenviron. Eng., 1385–1398.
Ladd, C. C. (1991). “Stability evaluation during staged construction.” J. Geotech. Engrg., 540–615.
Lai, T., Elgamal, A., Wilson, D. W., and Kutter, B. L. (2001). “Numerical modeling for site seismic response in laminated centrifuge container.” Proc., 1st Albert CAQUOT Int. Conf., Paris.
Lee, J. S., and Santamarina, J. C. (2005). “Bender elements: Performance and signal interpretation.” J. Geotech. Geoenviron. Eng., 1063–1070.
Mason, H. B., Kutter, B. L., Bray, J. D., Wilson, D. W., and Choy, B. Y. (2010). “Earthquake motion selection and calibration for use in a geotechnical centrifuge.” Proc., 7th Int. Conf. on Physical Modeling in Geotechnics, CRC Press, Zurich, Switzerand, 361–366.
Park, D. S. (2011). “Strength loss and softening of sensitive clay slopes.” Ph.D. thesis, Univ. of California, Davis, CA.
Phillips, C., and Hashash, Y. M. A. (2009). “Damping formulation for nonlinear 1D site response analyses.” Soil. Dyn. Earthq. Eng., 29(7), 1143–1158.
Santamarina, J. C., Klein, K. A., and Fam, M. A. (2001). Soils and waves, Wiley, Chicester, U.K.
Schmidt, B. (1966). “Discussion of Earth pressures at rest related to stress history.” Can. Geotech. J., 3(4), 239–242.
Sheahan, T., Ladd, C., and Germaine, J. (1996). “Rate-dependent undrained shear behavior of saturated clay.” J. Geotech. Engrg., 99–108.
Sheather, S. J. (2009). A modern approach to regression with R, Springer Science Business Media, New York.
Stewart, J. P., and Kwok, A. O. (2008). “Nonlinear seismic ground response analysis: Code usage protocols and verification against vertical array data.” Proc., Geotechnical Engineering and Soil Dynamics IV, D. Zeng, M. T. Manzari, and D. R. Hiltunen, eds., ASCE Geotechnical Special Publication No. 181, ASCE, Reston, VA, 1–24.
Tsai, C. C., and Hashash, Y. M. (2009). “Learning of dynamic soil behavior from downhole arrays.” J. Geotech. Geoenviron. Eng., 745–757.
Vucetic, M., and Dobry, R. (1991). “Effect of soil plasticity on cyclic response.” J. Geotech. Engrg., 89–107.
Walling, M., Silva, W. J., and Abrahamson, N. A. (2008). “Nonlinear site amplification factors for constraining the NGA models.” Earthq. Spectra, 24(1), 243–255.
Wilson, D. W., Boulanger, R. W., and Kutter, B. L. (1997). “Soil-pile-superstructure interaction at soft or liquefiable soil sites: Centrifuge data report for Csp5.” Report UCD/CGMDR-97/06, Center for Geotechnical Modeling, Dept. of Civil and Environmental Engineering, Univ. of California, Davis, CA.
Yamada, S., Hyodo, M., Orense, R. P., Dinesh, S. V., and Hyodo, T. (2008). “Strain-dependent dynamic properties of remolded sand-clay mixtures.” J. Geotech. Geoenviron. Eng., 972–981.
Yee, E., Stewart, J. P., and Tokimatsu, K. (2013). “Elastic and large-strain nonlinear seismic site response from analysis of vertical array recordings.” J. Geotech. Geoenviron. Eng., 1789–1801.
Zeghal, M., and Elgamal, A. W. (1994). “Analysis of site liquefaction using earthquake records.” J. Geotech. Engrg., 996–1017.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Dec 14, 2012
Accepted: Jul 24, 2013
Published online: Jul 26, 2013
Published in print: Feb 1, 2014
Discussion open until: Apr 12, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.