Behavior of Coarse Widely Graded Soils under Low Confining Pressures
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 139, Issue 1
Abstract
Colluvial soils are usually coarse and widely graded. Shallow-seated failures occur frequently in colluvial soil deposits during rainfall infiltration. This paper investigates the behavior of coarse, widely graded soils under very low confining pressures of 5–25 kPa encountered in shallow-seated failures. Isotropic consolidation tests, drained triaxial tests, and undrained triaxial tests were conducted on several widely graded soils with different coarse contents but with the same void ratio of 0.62. With increasing coarse content, the soil microstructure changes from a fines-controlled structure to a coarse-controlled structure after a critical coarse content of approximately 70%. Silty sand with gravel with a coarse content close to the critical value exhibits the highest compressibility because of the presence of large interaggregate pores. Even under very low confining pressures, such soil still shows strong contractive behavior during drained loading, and generates large positive pore-water pressures during undrained loading. This explains why shallow-seated failures occur frequently in colluvial soil deposits caused by rainfall infiltration. Soils with lower or higher coarse contents than the critical value may show dilative behavior under the same low confining pressures. The critical state friction angle increases with the coarse content.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge support from the Research Grants Council of the Hong Kong SAR (Grant No. 622210).
References
ASTM. (2002a). “Standard practice for classification of soils for engineering purposes (unified soil classification system).” D2487, West Conshohocken, PA.
ASTM. (2002b). “Standard test method for consolidated undrained triaxial compression test for cohesive soils.” D4767-04, West Conshohocken, PA.
ASTM. (2000c). “Standard test method for laboratory compaction characteristics of soil using standard effort.” D698-07e1, West Conshohocken, PA.
Au, S. W. C. (1998). “Rain-induced slope instability in Hong Kong.” Eng. Geol., 51(1), 1–36.
Bandini, V., and Coop, M. R. (2011). “The influence of particle breakage of the location of the critical state line of sands.” Soil Found., 51(4), 591–600.
Been, K., and Jefferies, M. G. (1985). “A state parameter for sands.” Geotechnique, 35(2), 99–112.
Bolton, M. D. (1986). “The shear strength and dilatancy of sands.” Geotechnique, 36(1), 65–78.
Casagrande, A. (1936). “The determination of the preconsolidation load and its practical significance.” Proc., 1st Int. Conf. Soil Mech. Found. Eng., Vol. 3, Harvard Univ., Cambridge, MA., 60–64.
Cascini, L., Cuomo, S., Pastor, M., and Sorbino, G. (2010). “Modeling of rainfall-induced shallow landslides of the flow-type.” J. Geotech. Geoenviron. Eng., 136(1), 85–98.
Chakraborty, T., and Salgado, R. (2010). “Dilatancy and shear strength of sand at low confining pressures.” J. Geotech. Geoenviron. Eng., 136(3), 527–532.
Chang, D. S., Zhang, L. M., Xu, Y., and Huang, R. Q. (2011). “Field testing of erodibility of two landslide dams triggered by the 12 May Wenchuan earthquake.” Landslides, 8(3), 321–332.
Chiu, C. F. (1991). “Mechanical behavior of compacted decomposed granite soil.” Ph.D. thesis, The Hong Kong Univ. of Science and Technology, Hong Kong.
Dai, F. C., Lee, C. F., and Wang, S. J. (2003). “Characterization of rainfall-induced landslides.” Int. J. Remote Sens., 24(23), 4817–4834.
Dash, H. K., and Sitharam, T. G. (2011). “Undrained montonic response of the sand-silt mixtures: effect of nonplastic fines.” Geomech. Geoeng., 6(1), 47–58.
Fannin, R. J., Eliadorani, A., and Wilkinson, J. M. T. (2005). “Shear strength of cohesionless soils at low stress.” Geotechnique, 55(6), 467–478.
Fukushima, S., and Tatsuoka, F. (1984). “Strength and deformation characteristics of saturated sand at extremely low pressure.” Soil Found., 24(4), 30–48.
Fung, W. T. (2001). “Experimental study and centrifuge modeling of loose fill slope.” M.Phil. thesis, The Hong Kong Univ. of Science and Technology, Hong Kong.
Head, K. H. (1980). Manual of soil laboratory testing, 2nd Ed., Pentech, London.
Irfan, T. Y., and Tang, K. Y. (1993). “Effect of coarse fractions on the shear strength of colluviums.” GEO Report No. 23. Geotechnical Engineering Office, Hong Kong.
Jefferies, M., and Been, K. (2006). Soil liquefaction–A critical state approach, Taylor & Francis, London.
Kwag, J. M., Ochiai, H., and Yasufuku, N. (1999). “Yielding stress characteristics of carbonate sand in relation to individual particle fragmentation strength.” Engineering for Calcareous Sediments, K. A. AI-Shafei, ed., Balkema, Rotterdam, Netherlands, Vol. 1, 79–86.
Lade, P. V., Liggio, C. D., Jr., and Yamamuro, J. A. (1998). “Effects of non-plastic fines on minimum and maximum void ratios of sand.” Geotech. Test. J., 21(4), 336–347.
Lee, I. K., and Coop, M. R. (1995). “The intrinsic behavior of a decomposed granite soil.” Geotechnique, 45(1), 117–130.
Lee, K. L., and Seed, H. B. (1967). “Drained strength characteristics of sands.” J. Soil Mech. Found. Div., 9(6), 117–141.
Li, X., and Zhang, L. M. (2009). “Characterization of dual-structure pore-size distribution of soil.” Can. Geotech. J., 46(2), 129–141.
Ng, C. W. W., and Chiu, C. F. (2003). “Laboratory study of loose saturated and unsaturated decomposed granitic soil.” J. Geotech. Geoenviron. Eng., 129(6), 550–559.
Pitman, T. D., Robertson, P. K., and Sego, D. C. (1994). “Influence of fines on the collapse of loose sands.” Can. Geotech. J., 31(5), 728–739.
Tang, W. H., and Zhang, L. M. (2011). “Development of a risk-based landslide warning system.” ASCE Geotechnical Specialty Conf. Georisk-2011, Atlanta, GA. Geotechnical Special Publication No. 224, C. H. Juang, K. K. Phoon, A. J. Puppala, R. A. Green, and G. A. Fenton, eds., ASCE, Reston, VA, 25–49.
Thevanayagam, S. (1998). “Effect of fines and confining stress on undrained shear strength of silty sands.” J. Geotech. Geoenviron. Eng., 124(6), 479–491.
Vallejo, L. E., and Mawby, R. (2000). “Porosity influence on the shear strength of granular material-clay mixtures.” Eng. Geol., 58(2), 125–136.
Wood, D. M., and Maeda, K. (2008). “Changing grading of soil: Effect on critical states.” Acta Geotech., 3(1), 3–14.
Yamamuro, J. A., and Lade, P. V. (1998). “Steady-state concepts and static liquefaction of silty sands.” J. Geotech. Geoenviron. Eng., 124(9), 868–877.
Yamamuro, J. A., Wood, F. M., and Lade, P. V. (2008). “Effect of depositional method on the microstructure of silty sand.” Can. Geotech. J., 45(11), 1538–1555.
Yan, W. M. (2003). “Experimental study and constitutive modeling of recompacted completely decomposed granite.” Ph.D. thesis, The Hong Kong Univ. of Science and Technology, Hong Kong.
Yang, S. L., Lacasse, S., and Sandven, R. F. (2006). “Determination of the transitional fines content of mixtures of sand and non-plastic fines.” Geotech. Test. J., 29(2), 102–107.
Zhang, L. L., Zhang, J., Zhang, L. M., and Tang, W. H. (2011a). “Stability analysis of rainfall-induced slope failures: A review.” Geotech. Eng. Proc.- Inst. Civ. Eng., 164(5), 299–316.
Zhang, L. M., and Chen, Q. (2005). “Predicting bimodal soil-water characteristic curves.” J. Geotech. Geoenviron. Eng., 131(5), 666–670.
Zhang, L. M., and Li, X. (2010). “Microporosity structure of coarse granular soils.” J. Geotech. Geoenviron. Eng., 136(10), 1425–1436.
Zhang, L. M., Xu, Y., Huang, R. Q., and Chang, D. S. (2011b). “Particle flow and segregation in a giant landslide event triggered by the 2008 Wenchuan earthquake, Sichuan, China.” Nat. Hazards Earth Syst. Sci., 11, 1153–1162.
Zhang, S., Zhang, L. M., Peng, M., Zhang, L. L., Zhao, H. F., and Chen, H. X. (2012). “Assessment of risks of loose landslide deposits formed by the 2008 Wenchuan earthquake.” Nat. Hazards Earth Syst. Sci., 12, 1381–1392.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Sep 4, 2011
Accepted: Apr 23, 2012
Published online: Apr 25, 2012
Published in print: Jan 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.