Pile Setup in Cohesive Soil. II: Analytical Quantifications and Design Recommendations
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 139, Issue 2
Abstract
This paper establishes a methodology to quantify pile setup by using recent field test data that was presented in a companion paper for steel H-piles driven in cohesive soils. Existing methods found in literature for the same purpose either require restrikes of piles onsite or are developed for a specific soil type and seldom use easily quantifiable soil properties, despite their significant influence on pile setup. Following a critical evaluation of the existing methods, a new approach for estimating pile setup was developed using dynamic measurements and analyses in combination with measured soil properties, such as the horizontal coefficient of consolidation, undrained shear strength, and the standard penetration test value. Using pile setup information available in the literature, the proposed approach has shown that it provides good estimates for the setup of steel H-piles, as well as for other types and sizes of driven piles.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors express their gratitude to the Iowa Highway Research Board for sponsoring this project and to the members of the project’s Technical Advisory Committee for guidance and advice: Ahmad Abu-Hawash, Dean Bierwagen, Lyle Brehm, Ken Dunker, Kyle Frame, Steve Megivern, Curtis Monk, Michael Nop, Gary Novey, John Rasmussen, and Bob Stanley.
References
AASHTO. (2010). LRFD Bridge Design Specifications, Washington, DC.
Bullock, P. J., Schmertmann, J. H., McVay, M. C., and Townsend, F. C. (2005). “Side shear setup I: Test piles driven in Florida.” J. Geotech. Geoenviron. Eng., 131(3), 292–300.
Cheng, S. M., and Ahmad, S. A. (1988). “Dynamic testing versus static loading test: Five case histories.” Proc., 3rd Int. Conf. on the Application of Stress-Wave Theory to Piles, B. H. Fellenius, ed., BiTech, BC, Canada 477–489.
Davisson, M. (1972). ““High capacity piles.” Proc., Soil Mechanics Lecture Series on Innovations in Foundation Construction, ASCE, Reston, VA, 81–112.
Fellenius, B. H. (2002). “Pile dynamics in geotechnical practice—Six case histories.” Proc., Int. Deep Foundations Congress, M. W. O’Neill and F. C. Townsend, eds., 619–631.
Fellenius, B. H. (2008). “Effective stress analysis and set-up for shaft capacity of piles in clay.” From research to practice in geotechnical engineering, ASCE, Reston, VA, 384–406.
Houlsby, G., and Teh, C. (1988). “Analysis of the piezocone in clay.” Proc., 1st Int. Symp. on Penetration Testing 2, Institution of Civil Engineers, Orlando, FL, 777–783.
Huang, S. (1988). “Application of dynamic measurement on long H-pile driven into soft Ground in Shanghai.” Proc., 3rd Int. Conf. on the Application of Stress-Wave Theory to Piles, B. H. Fellenius, ed., BiTech, BC, Canada, 635–643.
Karlsrud, K., Clausen, C. J. F., and Aas, P. M. (2005). “Bearing capacity of driven piles in clay, the NGI approach.” Proc.,1st Int. Symposium on Frontiers in Offshore Geotechnics, Taylor & Francis, London, 775–782.
Karna, U. L. (2001). Characterization of time dependent pile capacity in glacial deposits by dynamic load tests, New Jersey Institute of Technology, Newark, NJ.
Kim, D., Bica, A. V. D., Salgado, R., Prezzi, M., and Lee, W. (2009). “Load testing of a closed-ended pipe pile driven in multilayered soil.” J. Geotech. Geoenviron. Eng., 135(4), 463–473.
Kim, K. J., and Kreider, C. A. (2007). “Measured soil setup of steel HP piles from Windsor Bypass Project in North Carolina.” Transportation Research Record 2004, Transportation Research Board,Washington, DC, 3–11.
Long, J. H., Maniaci, M., and Samara, E. A. (2002). “Measured and predicted capacity of H-piles.” Proc., Int. Deep Foundations Congress, M. W. O’Neill and F. C. Townsend, eds., ASCE, Reston, VA, 542–558.
Lukas, R. G., and Bushell, T. D. (1989). “Contribution of soil freeze to pile capacity.” Foundation engineering: Current principles and practices, Vol. 2, F. H. Kulhawy, ed., ASCE, Reston, VA, 991–1001.
Ng, K. W., Roling, M., AbdelSalam, S. S., Suleiman, M. T., and Sritharan, S. (2013). “Pile setup in cohesive soil. I: Experimental investigation.” J. Geotech. Geoenviron. Eng., 139(2), 199–209.
Ng, K. W., Suleiman, M. T., and Sritharan, S. (2010). “LRFD resistance factors including the influence of pile setup for design of steel H-pile using WEAP.” Proc., Annual Geo-Congress of the Geo-Institute, D. Fratta, A. J. Puppala, and B. Muhunthan, eds., ASCE, Reston, VA, 2153–2161.
Paikowsky, S. G., Regan, J. E., and McDonnell, J. J. (1994). “A simplified field method for capacity evaluation of driven piles.” Rep. No. FHWA-RD-94-042, Federal Highway Administration, Washington, DC.
Pei, J., and Wang, Y. (1986). “Practical experiences on pile dynamic measurement in Shanghai.” Proc., Int. Conf. on Deep Foundations, China Building Industry Press, Beijing, 2.36–2.41.
Pile Dynamics, Inc. (2005). GRLWEAP wave equation analysis of pile driving: Procedures and models, version 2005, Pile Dynamics, Cleveland, OH.
Roling, M., Sritharan, S., and Suleiman, M. T. (2010). “Development of LRFD design procedures for bridge piles in Iowa—Electronic database.” Final Rep. Project No. TR-573, Institute for Transportation, Iowa State Univ., Ames, IA.
Skov, R., and Denver, H. (1988). “Time-dependence of bearing capacity of piles.” Proc., 3rd Int. Conf. on the Application of Stress-Wave Theory to Piles, B. H. Fellenius, ed., BiTech, BC, Canada, 879–888.
Soderberg, L. O. (1962). “Consolidation theory applied to foundation pile time effects.” Geotechnique, 12(3), 217–225.
Svinkin, M. R., and Skov, R. (2000). “Set-up effect of cohesive soils in pile capacity.” Proc. 6th Int. Conf. on Application of Stress-Waves Theory to Piles, S. Niyama and J. Beim, eds., Taylor & Francis, London, U.K., 107–111.
Thibodeau, E., and Paikowsky, S. G. (2005). “Performance evaluation of a large scale pile load testing program in light of newly developed LRFD parameters.” GeoFrontiers 2005—LRFD and reliability based design of deep foundations, ASCE, Reston, VA.
Thompson, W. R., Held, L., and Saye, S. (2009). “Test pile program to determine axial capacity and pile setup for the Biloxi Bay Bridge.” Deep Foundation Inst. J., 3(1), 13–22.
Yang, L., and Liang, R. (2006). “Incorporating set-up into reliability-based design of driven piles in clay.” Can. Geotech. J., 43(9), 946–955.
Zhu, G. Y. (1988). “Wave equation applications for piles in soft ground.” Proc., 3rd Int. Conf. on the Application of Stress-Wave Theory to Piles, B. H. Fellenius, ed., BiTech, BC, Canada, 831–836.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jun 16, 2011
Accepted: Apr 23, 2012
Published online: Apr 25, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.