Geotechnical Analysis of Heat Exchanger Piles
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 137, Issue 10
Abstract
There is currently a lack of established calculation methods for the geotechnical design of heat exchanger piles, although the technology is experiencing a fast expansion. Instead of quantifying the effects of temperature changes on the static behavior of heat exchanger piles, the common geotechnical practice is to apply a large overall security factor. This is done to be on the side of safety with respect to thermal effects. The few existing in situ experiments show that applying a thermal load induces a significant change in the stress-strain state of a pile. This paper presents a geotechnical numerical analysis method based on the load-transfer approach that assesses the main effects of temperature changes on pile behavior. The method is validated on the basis of in situ measurements of the loads and deformations experienced by heat exchanger test piles. The occurrence of critical design situations is further discussed. Some conclusions are formulated on concrete failure and the full mobilization of the pile shaft friction and base resistance during the operation of the heat exchange system.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank the reviewers for their very constructive comments, and Mrs Alice Di Donna for her contribution to the validation of the numerical code. This work was partly funded by Swisselectric Research.
References
Amar, S., Clarke, B. G. F., Gambin, M. P., and Orr, T. L. L. (1991). “The application of pressuremeter test results to foundation design in Europe, Part 1: Predrilled pressuremeters/self-boring pressuremeters.” International Society for Soil Mechanics and Foundation Engineering, European Regional Technical Committee, No. 4, A. A. Balkema, Rotterdam, Netherlands.
Armaleh, S., and Desai, C. S. (1987). “Load-deformation response of axially loaded piles.” J. Geotech. Eng., 113(12), 1483–1500.
Bochon, A. (1992). “Les mesures de déformation des structures hyperstatiques: Le témoin sonore.” Rev. Fr. Geotech., 60, 41–50 (in French).
Boënnec, O. (2009). “Piling on the Energy.” Geodrilling Int., (150), 25–28.
Bourne-Webb, P. J., Amatya, K., Soga, K., Amis, T., Davidson, C., and Payne, P. (2009). “Energy pile test at Lambeth College, London: Geotechnical and thermodynamic aspects of pile response to heat cycles.” Géotechnique, 59(3), 237–248.
Cekerevac, C., and Laloui, L. (2004). “Experimental study of thermal effects on the mechanical behaviour of a clay.” Int. J. Numer. Anal. Methods Geomech., 28(3), 209–228.
Coyle, H. M., and Reese, L. C. (1966). “Load transfer for axially loaded piles in clay.” J. Soil Mech. and Found. Div., 92(2), 1–26.
Frank, R., Kalteziotis, N., Bustamante, M., Christoulas, S., and Zervogiannis, H. (1991). “Evaluation of performance of two piles using pressuremeter method.” J. Geotech. Eng., 117(5), 695–713.
Frank, R., and Zhao, S. R. (1982). “Estimation par les paramètres pressiométriques de l’enfoncement sous charge axiale de pieux forés dans des sols fins.” Bull. Liaison Lab. Ponts Chaussees, 119, 17–24 (in French).
Hueckel, T., François, B., and Laloui, L. (2009). “Explaining thermal failure in saturated clays.” Géotechnique, 59(3), 197–212.
Lang, H. J., and Huder, J. (1978). “Bodenmechanik und Grundbau: Das Verhalten von Böden und die wichtigsten grundbaulichen Konzepte.” Springer, Berlin (in German).
Laloui, L., and Cekerevac, C. (2008). “Non-isothermal plasticity model for cyclic behaviour of soils.” Int. J. Numer. Anal. Meth. Geomech., 32(5), 437–460.
Laloui, L., Moreni, M., and Vulliet, L. (2003). “Comportement d’un pieu bi-fonction, fondation et échangeur de chaleur.” Can. Geotech. J., 40(2), 388–402 (in French).
Laloui, L., Nuth, M., and Vulliet, L. (2006). “Experimental and numerical investigations of the behaviour of a heat exchanger pile.” Int. J. Numer. Anal. Meth. Geomech., 30(8), 763–781.
Legrand, J., Millan, A., and Renault, J. (1993). “Règles techniques de conception et de calcul des fondations des ouvrages de génie civil.” Cahier des clauses techniques générales applicables aux marchés publics de travaux, Fascicule No 62—Titre, V, Ministère de l’équipement du logement et des transports, France (in French).
Marsland, A., and Randolph, M. F. (1977). “Comparisons of the results from pressuremeter tests and large in situ plate tests in London Clay.” Géotechnique, 27(2), 217–243.
Randolph, M. F., and Wroth, C. P. (1978). “Analysis of deformation of vertically loaded piles.” J. Geotech. Eng., 104(GT12), 1465–1488.
Seed, H. B., and Reese, L. C. (1957). “The action of soft clay along friction piles.” Trans. Am. Soc. Civ. Eng., 122, 731–754.
Silvani, C., Nuth, M., Laloui, L., and Peron, H. (2009). “Understanding the thermomechanical response of heat exchanger piles.” Proc., 1st Int. Symp. on Computational Geomechanics (COMGEO I), Juan-les-Pins, France, 589–596.
Swiss Association for Architects and Engineers (SIA) (2005). “Nutzung der Erdwärme mit Fundationspfählen und anderen erdberührten Betonbauteilen.” Dokumentation D 0190, Swiss Association of Engineers and Architects, SIA, Bern, Switzerland (in German).
TERRASOL. (2009). “Software User’s Manual, Programme FoXta Partie F: Module Taspie.” 〈http://www.terrasol.com/Softwares/Foxta/manuels/FoXta-PartieF_v2.0.pdf.〉 (Mar. 2009).
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Sep 4, 2009
Accepted: Jan 25, 2011
Published online: Jan 28, 2011
Published in print: Oct 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.